参数资料
型号: GM6155-4.0ST25R
厂商: American Power Management Inc.
英文描述: 150mA LOW-NOISE LDO REGULATOR
中文描述: 150mA低噪声LDO稳压器
文件页数: 5/9页
文件大小: 126K
代理商: GM6155-4.0ST25R
G
M
6
1
5
Applications Information
Enable/ Shutdown
Forcing EN (enable/ shutdown) high (>2V) enables the regulator. EN is compatible with CMOS logic gates. If
enable shutdown feature is not required, connect EN (pin 3) to IN (supply input, pin 1). See Figure 3.
Input Capacitor
A 1F capacitor should be placed from IN to GND if there is more than 10 inches of wire between the input
and the acfilter capacitor or if a battery is used as the input .
Reference Bypass Capacitor
BYP (reference bypass) is connected to the internal voltage reference. A 470pF capacitor (C
) connected
BYP
from BYP to GND quiets this reference, providing a significant reduction in output noise. C
reduces the
BYP
regulator phase margin, when using C
, output capacitors of 2.2F or greater are generally required to
BYP
maintain stability.
The start-up speed of GM6155 is inversely proportional to the size of the reference bypass capacitor.
Applications requiring a slow ramp-up of output voltage should consider larger values of C
. Likewise, if
BYP
rapid turn-on is necessary, consider omitting C
.
BYP
If output noise is not a major concern, omit C
and leave BYP open.
BYP
Output Capacitor
An output capacitor required between OUT and GND to prevent oscillation. The minimum size of the output
capacitor is dependent upon whether a reference bypass capacitor is used. 1.0F minimum is recommended
when C
is not used (see Figure 2). 2.2F minimum is recommended when C
is 470pF (see Figure 1).
BYP
Larger values improve the regulator's transient response, the output capacitor value may be increased
without limit.
The output capacitor should have an ESR (effective series resistance) of about 5W or less and a resonant
frequency above 1MHz. Ultra-low-ESR capacitors can cause a low amplitude oscillation on the output and/
or underdamped transient response. Most tantalum or aluminum electrolytic capacitors are adequate; film
types will work, but more expensive. Since many aluminum electrolytics have electrolytes that freeze at
about -30°C, solid tantalums ate recommended for operation below -25°C.
At lower values for output current, less output capacitance is required for output stability. The capacitor can
be reduced to 0.47F for current below 10mA or 0.33F for current below 1mA.
No-Load Stability
GM6155 will remain stable and in regulation with no load (other than the internal voltage divider) unlike
many other voltage regulators. This is especially important in CMOS RAM keep-alive applications.
Thermal Considerations
Gm6155 is designed to provide 150mA of continuous current in a very small package. Maximum power
dissipation can be calculated based on the output current and the voltage drop across the part. To determine
the maximum power dissipation of the package, use the junction-to-ambient thermal resistance of the device
and the following basic equation:
T
is the maximum junction temperature of the die, 125°C, and T is the ambient operating temperature.
J(max)
A
R
is layout dependent; Table 1 shows examples of junction-to-ambient thermal resistance for the GM6155.
qJA
P
=
D(max)
(T
- T )
J(max)
A
JA
Rq
相关PDF资料
PDF描述
GM6155-4.2ST25R 150mA LOW-NOISE LDO REGULATOR
GM6155-5.0ST25R 150mA LOW-NOISE LDO REGULATOR
GM6155-AST25R 150mA LOW-NOISE LDO REGULATOR
GM6155 150mA LOW-NOISE LDO REGULATOR
GM6156-2.5ST25R 150mA LOW-NOISE LDO REGULATOR
相关代理商/技术参数
参数描述
GM6155-5.0ST25R 制造商:GAMMA 制造商全称:GAMMA 功能描述:150mA LOW-NOISE LDO REGULATOR
GM6155-AST25R 制造商:未知厂家 制造商全称:未知厂家 功能描述:150mA LOW - NOISE LDO REGULATOR
GM6156 制造商:GAMMA 制造商全称:GAMMA 功能描述:150mA LOW-NOISE LDO REGULATOR
GM6156-2.5ST25R 制造商:GAMMA 制造商全称:GAMMA 功能描述:150mA LOW-NOISE LDO REGULATOR
GM6156-2.7ST25R 制造商:GAMMA 制造商全称:GAMMA 功能描述:150mA LOW-NOISE LDO REGULATOR