参数资料
型号: GPC140-15
厂商: SL Power Electronics Manufacture of Condor/Ault Brands
文件页数: 1/2页
文件大小: 0K
描述: POWER SUPPLY SWITCHER 140W 15V
标准包装: 10
系列: GPC140
类型: 标准产品
输出数: 1
输出电压: 15V
输入电压: 85 ~ 264VAC
输出 - 1 @ 电流(最大): 15 VDC @ 9.3A
功率(瓦特): 140W
电源类型: 开关(开放框架)
应用: 商用
安装类型: 底座安装
尺寸/尺寸: 8.50" L x 4.50" W x 2.12" H(215.9mm x 114.3mm x 53.9mm)
工作温度: 0°C ~ 50°C
效率: 70%
电源(瓦特)- 最大: 140W
批准: CE,CSA,IEC,UL
线路调节: 2%
负载调整: 2%
相关产品: 08-30466-1140G-ND - COVER
08-30466-1140-ND - COVER
18-30234-3016-ND - CONNECTOR KIT
GPC140 Commercial/ GPM140 Medical
140 Watt Global Performance Switchers
FEATURES:
? Wide-range ac input 85-264 Vac
? 2-year warranty
? Conducted EMI exceeds FCC Class B and CISPR 22
Class B (Commercial models) and CISPR 11 Class B
(Medical models)
? Single outputs
? Commercial Approved to UL1950, IEC950,
EN60950 and CSA22.2-234 L3
? Medical Approved to UL2601-1, IEC601-1 and
CSA22.2 No. 601
SPECIFICATIONS:
?
marked to LVD
Ac Input
85-264 Vac, 47-63 Hz single phase.
Input Current
Maximum input current at 120 Vac, 60 Hz with full rated
output load: 3.7 A
Hold-Up Time
20ms minimum from loss of ac input at full load, nominal
line (115 Vac).
Output Power
140 W convection; 160 W with air flow. Peak ratings are
for 60 s maximum duration, 10% duty cycle.
Overload Protection
Fully protected against short circuit and output overload.
Short circuit protection is cycling type power limit on
output 1. Recovery after fault is automatic.
Overvoltage Protection
Main outputs: 130% ± 15% typical.
Efficiency
70% at full rated load, nominal input voltage, depending
on model and load distribution.
Output Noise
0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential
mode. Measured with noise probe directly across output
terminals of the power supply.
Transient Response
Main output — 500 μs typical response time for return to
within 0.5% of final value for a 50% load step change. ? i/
? t<0.2 A/μs. Maximum voltage deviation is 3.5%. Startup/
shutdown overshoot less than 3%.
Remote Sense
Provided as a standard feature.
Voltage Adjustment
Built-in potentiometer adjusts voltage ±5%.
Overload Protection
Factory set to begin power limiting at approximately 175 W.
EMI/EMC Compliance
All models include built-in EMI filtering to meet the
following emissions requirements:
EMI SPECIFICATIONS COMPLIANCE LEVEL
Conducted Emissions GPC140 EN55022 Class B; FCC Class B
Conducted Emissions GPM140 EN55011 Class B; FCC Class B
Input Protection
Internal ac fuse provided. Designed to blow only if a
catastrophic failure occurs in the unit.
Static Discharge
RF Field Susceptibility
Fast Transients/Bursts
Surge Susceptibility
EN61000-4-2, 6 kV contact, 8 kV air
EN61000-4-3, 3 V/meter
EN61000-4-4, 2 kV, 5 kHz
EN61000-4-5, 1 kV diff., 2 kV com.
Inrush Current
Inrush is limited by internal thermistors. Inrush at 240 Vac,
averaged over the first ac half-cycle under cold start
conditions will not exceed 60 A.
Temperature Coefficient
0.03%/ ° C typical on all outputs.
Thermal Shutdown
Provided as a standard feature. Designed to protect unit
from prolonged overtemperature.
Environmental
Designed for 0 to 50 ° C operation at full rated output
power; derate output current and total output power by
2.5% per ° C above 50 ° C. See Environmental and
Packaging Specifications on next page.
Power Fail
TTL- or CMOS-compatible output goes low (< 0.5 V) 5 ms
before output voltage drops more than 4% below
nominal voltage upon loss of ac power. The signal is
Commercial Leakage Current
0.95 mA 254 Vac @ 60 Hz input.
Commercial Safety
Approved to UL1950, CSA22.2 No. 234 Level 3, IEC950
and EN60950. UL file #E135803 commercial; CSA
#LR46516 all models. The output(s) are intended for
safety earthed Signal Output and Intermediate Circuits
only. All dc outputs are SELV under normal and single
fault conditions.
Medical Leakage Current
60 μA 254 Vac @ 60 Hz input.
Medical Safety
Approved to UL2601, CSA22.2 No. 601 Level 3 and
IEC601. UL file E116994; CSA #LR46516. The output(s)
are intended for safety earthed Signal Output and
Intermediate Circuits only. The output(s) are not accept-
able for patient connection without additional isolation. All
dc outputs are SELV under normal and single fault
conditions.
factory set to trip on 84 to 94 Vac brown-out depending
upon incoming line impedance and distortion. Other
settings are available to the user through adjustment of
built-in potentiometer.
Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033
56
800-235-5929 ? 805-486-4565 ? FAX 805-487-8911 ? www.condorpower.com
相关PDF资料
PDF描述
B32522C3155K CAP FILM 1.5UF 250VDC RADIAL
T95S685K004LZAL CAP TANT 6.8UF 4V 10% 1507
GPC140-12 POWER SUPPLY SWITCHER 140W 12V
T95S475M6R3LZAL CAP TANT 4.7UF 6.3V 20% 1507
T95S475M010LZAL CAP TANT 4.7UF 10V 20% 1507
相关代理商/技术参数
参数描述
GPC140-15G 功能描述:线性和开关式电源 140W 15V @ 9.3A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压(通道 1):20 V 输出电流(通道 1):40 A 商用/医用: 输出电压(通道 2): 输出电流(通道 2): 安装风格:Rack 长度: 宽度: 高度:
GPC140-15T 制造商:SL Power Electronics 功能描述:POWER SUPPLIES MISC. - Bulk
GPC140-24 功能描述:线性和开关式电源 140W 24V @ 5.8A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压(通道 1):20 V 输出电流(通道 1):40 A 商用/医用: 输出电压(通道 2): 输出电流(通道 2): 安装风格:Rack 长度: 宽度: 高度:
GPC140-24G 功能描述:线性和开关式电源 140W 24V @ 5.8A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压(通道 1):20 V 输出电流(通道 1):40 A 商用/医用: 输出电压(通道 2): 输出电流(通道 2): 安装风格:Rack 长度: 宽度: 高度:
GPC140-28 功能描述:线性和开关式电源 140W 28V @ 5A RoHS:否 制造商:TDK-Lambda 产品:Switching Supplies 开放式框架/封闭式:Enclosed 输出功率额定值:800 W 输入电压:85 VAC to 265 VAC 输出端数量:1 输出电压(通道 1):20 V 输出电流(通道 1):40 A 商用/医用: 输出电压(通道 2): 输出电流(通道 2): 安装风格:Rack 长度: 宽度: 高度: