参数资料
型号: GS1515-CQM
厂商: Electronic Theatre Controls, Inc.
英文描述: HDTV Serial Digital Reclocker
中文描述: 高清晰度电视串行数字时钟恢复器
文件页数: 4/17页
文件大小: 336K
代理商: GS1515-CQM
522 - 23 - 01
12
G
S
151
5
into the summing node of the integrator achieves the
sweep. The sweep is disabled once phase lock is asserted.
The direction of the sweep is also changed once LFS
saturates at either end.
MUTE
The logic controls the mute block whenever the PLL_LOCK
signal has a LOW logic state. Whenever the mute signal is
asserted, previous state of the output is latched.
BYPASS
The BYPASS block bypasses the re-clocked/mute path of
the data whenever a logic low input is applied to the
BYPASS input.
In the bypass mode, the mute does not
have any effect on the outputs. Also, in the bypass mode,
the internal PLL still locks to a valid HDTV signal and would
show PLL_LOCK.
CABLE DRIVER
The output of the GS1515 is a dual/complimentary current
mode cable driver stage. The output swing and impedance
can be varied. The following table may be used to select
the RSET resistor for the desired line impedance. Linear
interpolation can be used to determine the specific value of
the resistor for a given output swing at the load impedance.
For linear interpolation, either Figure 20 or the information in
Table 2 should be used. The admittance should be found
and then, by inverting the admittance, a resistor value for
the RSET can be found. The output can be used as dual
0.8V 75
cable drivers. It can also be used as a differential
transmission line driver. In this case, the pull-up resistor
should match the impedance of the transmission line
because the pull-up resistor acts as the source impedance.
When it is used in this case, a higher value of RSET resistor
could be used in order to reduce the swing and to save
power. Other HD-LINX products can handle such low
input swings. It should be noted that the minimum RSET
resistor cannot be less than 50
for reliability reasons
because of higher current density.
Fig. 20 Signal Swing for Various RSET Admittances
When the outputs are used to differentially drive some other
device such as the GS1508, it is recommended to use 50
transmission lines with the smallest possible signal swing
while allowing 10% variation at the output swing to select
the right choice of the RSET resistor. To drive the GS1508,
the recommended RSET resistor is 150
. There is no need to
compensate for the return-loss in this situation. The
uncompensated waveform at the output is shown in Figure
21.
Fig. 21 Uncompensated Output Eye Waveform
Fig. 22 Compensated Output Eye Waveform
NOTE: Figures 21 and 22 show the waveforms on an
oscilloscope using a 75
to 50 pad.
SOURCE/END
TERMINA
TEED
OUTPUT
SWING
(V)
1/RSET (
)
0.00
0.01
0.02
0.03
1.0
0.8
0.6
0.4
0.2
0.0
75
50
相关PDF资料
PDF描述
GS1515-CTM HDTV Serial Digital Reclocker
GS2008HET/R7 2 A, 800 V, SILICON, RECTIFIER DIODE
GS4576S09L-25 DDR DRAM, PBGA144
GS54180RK 1 ELEMENT, 18 uH, GENERAL PURPOSE INDUCTOR, SMD
GS54180RJ 1 ELEMENT, 18 uH, GENERAL PURPOSE INDUCTOR, SMD
相关代理商/技术参数
参数描述
GS1515-CTM 制造商:GENNUM 制造商全称:GENNUM 功能描述:HDTV Serial Digital Reclocker
GS1522 制造商:GENNUM 制造商全称:GENNUM 功能描述:HDTV Serial Digital Serializer
GS1522_04 制造商:GENNUM 制造商全称:GENNUM 功能描述:HDTV Serial Digital Serializer
GS1522-CQR 制造商:Rochester Electronics LLC 功能描述: 制造商:Gennum Corporation 功能描述:
GS1522-CQRE3 制造商:Gennum Corporation 功能描述:Monolithic Bipolar Integrated Circuit 128-Pin MQFP