- 您现在的位置：买卖IC网 > PDF目录223953 > HDSP-2500 Eight Character 5 mm and 7 mm Smart Alphanumeric Displays PDF资料下载
参数资料
| 型号： | HDSP-2500 |
| 英文描述： | Eight Character 5 mm and 7 mm Smart Alphanumeric Displays |
| 中文描述： | 八字5毫米和7毫米智能字母数字显示器 |
| 文件页数： | 5/16页 |
| 文件大小： | 406K |
| 代理商： | HDSP-2500 |
13
Figure 5. Logic Levels to Access the Flash RAM.
Table 2. Current Requirements at
Different Brightness Levels V
DD = 5.0 V
%
Current at 25
°C
Symbol
D
2
D
1
D
0
Brightness
Typ.
Units
I
DD (V)
0
100
200
mA
0
1
80
160
mA
0
1
0
53
106
mA
01
1
40
80
mA
10
0
27
54
mA
10
1
20
40
mA
11
0
13
26
mA
Figure 6. Logic Levels to Access the Control Word
Register
Control Word Register
Figure 6 shows how to access the
Control Word Register. This 8-bit
register performs five functions:
Brightness control, Flash RAM
control, Blinking, Self Test, and
Clear. Each function is
independent of the others; how-
ever, all bits are updated during
each Control Word write cycle.
Brightness (Bits 0-2)
Bits 0-2 of the Control Word
adjust the brightness of the
display. Bits 0-2 are interpreted
as a three bit binary code with
code (000) corresponding to
maximum brightness and code
(111) corresponding to a blanked
display. In addition to varying the
display brightness, bits 0-2 also
vary the average value of I
DD. IDD
can be calculated at any bright-
ness level by multiplying the
percent brightness level by the
value of I
DD at the 100% bright-
ness level. These values of I
DD are
shown in Table 2.
Flash Function (Bit 3)
Bit 3 determines whether the
flashing character attribute is on
or off. When bit 3 is a“1,” the
output of the Flash RAM is
checked. If the content of a loca-
tion in the Flash RAM is a “1,” the
associated digit will flash at
approximately 2 Hz. For an
external clock, the blink rate can
be calculated by driving the clock
frequency by 28,672. If the flash
enable bit of the Control Word is
a “0,” the content of the Flash
RAM is ignored. To use this
function with multiple display
systems, see the Display Reset
section.
Blink Function (Bit 4)
Bit 4 of the Control Word is used
to synchronize blinking of all
eight digits of the display. When
this bit is a “1” all eight digits of
the display will blink at approxi-
mately 2 Hz. The actual rate is
dependent on the clock frequency.
For an external clock, the blink
rate can be calculated by dividing
the clock frequency by 28,672.
This function will override the
Flash function when it is active.
To use this function with multiple
display systems, see the Display
Reset section.
相关PDF资料 |
PDF描述 |
|---|---|
| HDSP-2501 | Dual Differential Drivers And Receivers 16-PDIP 0 to 70 |
| HDSP-5553-EB000 | CAP 820PF 100V 0.1 NP0(C0G) RAD-.10IN .200X.260 CONF T&R |
| HDSP-5553-EC000 | Low Current Seven Segment Displays |
| HDSP-5553-ED000 | Low Current Seven Segment Displays |
| HDSP-5553-EE000 | Low Current Seven Segment Displays |
相关代理商/技术参数 |
参数描述 |
|---|---|
| HDSP-2501 | 功能描述:LED 显示器和配件 Yellow 585nm 5x7 Smart Display RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube |
| HDSP-2502 | 功能描述:LED 显示器和配件 Red 626nm 5x7 Smart Display RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube |
| HDSP2502 | 制造商:Avago Technologies 功能描述:LED DISPLAY ALPHANUMERIC |
| HDSP-2503 | 功能描述:LED 显示器和配件 Green 574nm 5x7 Smart Display RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube |
| HDSP2503 | 制造商:Avago Technologies 功能描述:LED DISPLAY ALPHANUMERIC |
发布紧急采购，3分钟左右您将得到回复。