参数资料
| 型号： | HFA1155IH96 |
| 厂商： | Intersil |
| 文件页数： | 5/10页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP CFA 380MHZ LP SOT23-5 |
| 标准包装： | 3,000 |
| 应用： | 电流反馈 |
| 电路数： | 1 |
| -3db带宽： | 365MHz |
| 转换速率： | 1650 V/µs |
| 电流 - 电源： | 5.5mA |
| 电流 - 输出 / 通道： | 55mA |
| 电压 - 电源，单路/双路(±)： | 4.5 V ~ 11 V，±2.25 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SC-74A，SOT-753 |
| 供应商设备封装： | SOT-23-5 |
| 包装： | 带卷 (TR) |
4
Application Information
Relevant Application Notes
The following Application Notes pertain to the HFA1155:
AN9787-An Intuitive Approach to Understanding
Current Feedback Amplifiers
AN9420-Current Feedback Amplifier Theory and
Applications
AN9663-Converting from Voltage Feedback to Current
Feedback Amplifiers
AN9897-Operating the HFA1155 from 5V Single
Supply
These publications may be obtained from Intersil’s web site
(www.intersil.com).
Performance Differences Between Packages
The HFA1155 is a high frequency current feedback
amplifier. As such, it is sensitive to parasitic capacitances
which influence the amplifier’s operation. The different
parasitic capacitances of different packages yield
performance differences (notably bandwidth and bandwidth
related parameters).
Because of these performance differences, designers
should evaluate and breadboard with the same package
style to be used in production.
Optimum Feedback Resistor
The enclosed frequency response graphs detail the
performance of the HFA1155 in various gains. Although the
bandwidth dependency on ACL isn’t as severe as that of a
voltage feedback amplifier, there is an appreciable decrease
in bandwidth at higher gains. This decrease can be minimized
by taking advantage of the current feedback amplifier’s unique
relationship between bandwidth and RF. All current feedback
amplifiers require a feedback resistor, even for unity gain
applications, and the RF, in conjunction with the internal
compensation capacitor, sets the dominant pole of the
frequency response. Thus, the amplifier’s bandwidth is
inversely proportional to RF. The HFA1155 is optimized for
RF = 604Ω, at a gain of +2. Decreasing RF decreases
stability, resulting in excessive peaking and overshoot (Note:
Capacitive feedback causes the same problems due to the
feedback impedance decrease at higher frequencies). At
higher gains the amplifier is more stable, so RF can be
decreased in a trade-off of stability for bandwidth. The table
below lists recommended RF values for various gains, and the
expected bandwidth.
5V Single Supply Operation
This amplifier operates at single supply voltages down to
4.5V. The dramatic supply current reduction at this operating
condition (refer also to Figure 16) makes this op amp an
even better choice for low power 5V systems. Refer to
Application Note AN9897 for further information.
Driving Capacitive Loads
Capacitive loads, such as an A/D input, or an improperly
terminated transmission line will degrade the amplifier’s
phase margin resulting in frequency response peaking and
possible oscillations. In most cases, the oscillation can be
avoided by placing a resistor (RS) in series with the output
prior to the capacitance.
Figure 1 details starting points for the selection of this
resistor. The points on the curve indicate the RS and CL
combinations for the optimum bandwidth, stability, and
settling time, but experimental fine tuning is recommended.
Picking a point above or to the right of the curve yields an
overdamped response, while points below or left of the curve
indicate areas of underdamped performance.
RS and CL form a low pass network at the output, thus
limiting system bandwidth well below the amplifier bandwidth
of 355MHz (AV = +2). By decreasing RS as CLincreases (as
illustrated by the curves), the maximum bandwidth is
obtained without sacrificing stability. In spite of this,
bandwidth still decreases as the load capacitance increases.
For example, at AV = +2, RS = 30Ω, CL = 22pF, the
bandwidth is 290MHz, but the bandwidth drops to 90MHz at
AV =+2, RS = 6Ω, CL = 390pF.
OPTIMUM FEEDBACK RESISTOR
ACL
RF (Ω)
SOT-23
BANDWIDTH (MHz)
SOT-23
-1
576
360
+1
453, (+RS = 221)
365
+2
604
355
+5
475
300
+10
182
250
HFA1155
相关PDF资料 |
PDF描述 |
|---|---|
| ICS1493K-17LF | IC CLOCK SYNTHESIZER 20-VFQFPN |
| ICS1524AMLFT | IC CLK GEN SSTL_3/PECL 24-SOIC |
| ICS1526GILF | IC VIDEO CLK SYNTHESIZER 16TSSOP |
| ICS1562BM-201T | IC VIDEO CLK SYNTHESIZER 16-SOIC |
| ICS1574BMT | IC CLOCK GEN PROGR LASER 16-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| HFA115IB | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HFA11XXEVAL | 功能描述:EVALUATION PLATFORM HFA11XX RoHS:否 类别:编程器，开发系统 >> 评估板 - 运算放大器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- |
| HFA1205 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual, 400MHz, Low Power, Video Operational Amplifier |
| HFA1205_04 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual, 425MHz, Low Power, Video Operational Amplifier |
| HFA1205IB | 制造商:Rochester Electronics LLC 功能描述:OPAMP 2X 400MHZ CFB 8SOIC IND - Bulk |
发布紧急采购，3分钟左右您将得到回复。