- 您现在的位置：买卖IC网 > PDF目录371807 > HFBR-4526 Plastic Optical Fiber Cable and Accessories for Versatile Link PDF资料下载
参数资料
| 型号： | HFBR-4526 |
| 英文描述： | Plastic Optical Fiber Cable and Accessories for Versatile Link |
| 中文描述： | 塑料光纤电缆及配件的通用链接 |
| 文件页数： | 6/11页 |
| 文件大小： | 267K |
| 代理商： | HFBR-4526 |
6
Step 3
Any excess fiber protruding from
the connector end may be cut off;
however, the trimmed fiber
should extend at least 1.5 mm
(0.06 in) from the connector end.
Insert the connector fully into the
polishing fixture with the trimmed
fiber protruding from the bottom
of the fixture. This plastic polish-
ing fixture can be used to polish
two simplex connectors or simplex
latching connectors simultane-
ously, or one duplex connector.
Note:
The four dots on the
bottom of the polishing fixture
are wear indicators. Replace
the polishing fixture when any
dot is no longer visible.
Typically, the polishing fixture
can be used 10 times; 10 duplex
connectors or 20 simplex
connectors, two at a time.
Place the 600 grit abrasive paper
on a flat smooth surface, pressing
down on the connector, polish the
fiber and the connector using a
figure eight pattern of strokes
until the connector is flush with
the bottom of the polishing
fixture. Wipe the connector and
fixture with a clean cloth or
tissue.
Step 4
Place the flush connector and
polishing fixture on the dull side
of the 3
μ
m pink lapping film and
continue to polish the fiber and
connector for approximately 25
strokes. The fiber end should be
flat, smooth and clean.
This cable is now ready for use.
Note:
Use of the pink lapping
film fine polishing step results
in approximately 2 dB
improvement in coupling
performance of either a
transmitter-receiver link or a
bulkhead/splice over a 600 grit
polish alone. This fine polish is
comparable to the Agilent
factory polish. The fine
polishing step may be omitted
where an extra 2 dB of optical
power is not essential, as with
short link lengths. Proper
polishing of the tip of the fiber/
connector face results in a tip
diameter between 2.5 mm
(0.098 in.) minimum and 3.2
mm (0.126 in.) maximum..
HFBR-4593 Polishing Kit
相关PDF资料 |
PDF描述 |
|---|---|
| HFBR-4593 | Plastic Optical Fiber Cable and Accessories for Versatile Link |
| HFBR-4597 | Plastic Optical Fiber Cable and Accessories for Versatile Link |
| HFBR-45XX | Plastic Optical Fiber Cable and Accessories for Versatile Link |
| HFBR-5320 | 200 MBd Low-Cost SBCON Multimode Fiber Transceiver(200 MBd 低价格SBCON 多模式光纤收发器) |
| HFBR-5527 | 125 Megabaud Fiber Optic Transceiver(125 百万波特光纤收发器) |
相关代理商/技术参数 |
参数描述 |
|---|---|
| HFBR-4526Z | 功能描述:光纤连接器 Duplex Crimp Ring 500 piece box RoHS:否 制造商:Molex 产品:Adapters 类型:8 Port with External Shutter 连接器类型:Adapter 模式:Multimode 光纤直径: 颜色:Blue 附件类型:LC Adapter |
| HFBR-4531 | 功能描述:光纤连接器 Snap-in FO Crimpless Connector RoHS:否 制造商:Molex 产品:Adapters 类型:8 Port with External Shutter 连接器类型:Adapter 模式:Multimode 光纤直径: 颜色:Blue 附件类型:LC Adapter |
| HFBR-4531Z | 功能描述:光纤连接器 Snap-in FO Crimpless Conn RoHS RoHS:否 制造商:Molex 产品:Adapters 类型:8 Port with External Shutter 连接器类型:Adapter 模式:Multimode 光纤直径: 颜色:Blue 附件类型:LC Adapter |
| HFBR-4532 | 功能描述:光纤连接器 Latching FO Crimples s Connector RoHS:否 制造商:Molex 产品:Adapters 类型:8 Port with External Shutter 连接器类型:Adapter 模式:Multimode 光纤直径: 颜色:Blue 附件类型:LC Adapter |
| HFBR-4532Z | 功能描述:光纤连接器 Latching FO Crimples s Conn RoHS RoHS:否 制造商:Molex 产品:Adapters 类型:8 Port with External Shutter 连接器类型:Adapter 模式:Multimode 光纤直径: 颜色:Blue 附件类型:LC Adapter |
发布紧急采购，3分钟左右您将得到回复。