2
N.FL Series
●Lightweight SMT Miniature Coaxial Connectors – 1.4 mm Mated Height
■Specifications
Item
Specification
Conditions
1. Contact resistance
10 mA max.
2. Insulation resistance
500 M ohms min.
100V DC
3. Withstanding voltage
No flashover or insulation breakdown
200V AC / 1 minute
4. V.S.W.R.(Note)
1.3max.
DC to 6GHz
5. Durability
20 cycles
6. Vibration
7. Shock
8. Humidity
96 hours at +40°C, and humidity of 95%
9. Temperature cycle
No damage, cracks, or parts dislocation
10. Salt spray test
No excessive corrosion
5% salt water solution, 48 hours
Acceleration of 735 m/s2, 11 ms continuous time
Waveform: sine half-wave, 3 cycles in each of the
3 axis
Temperature:-40°C/+5°C to +35°C/+90°C/+5°C to +35°C
Time: 30 min./ 5 min. max. / 30 min. / 5 min. max.
5 cycles
Frequency: 10 to 100 Hz, single amplitude of 1.5 mm
Acceleration: 59 m/s2, in each of 3 axis
5 cycles
Contact resistance
Center contact: 30 m ohms max.
Outer contact: 30 m ohms max.
No damage, cracks, or parts dislocation
No electrical discontinuity of 1 μs or longer
No damage, cracks, or parts dislocation
No electrical discontinuity of 1 μs or longer
No damage, cracks, or parts dislocation
Insulation resistance: 100 M ohms min. (high humidity)
Insulation resistance: 500 M ohms min. (dry)
No damage, cracks, or parts dislocation
Center contact: 25 m ohms max.
Outer contact: 25 m ohms max.
Nominal characteristic impedance
Frequency range
50 ohms
DC to 6 GHz
Operating temperature range
Storage temperature range
-40°C to +90°C (90% RH)
-30°C to +70°C (90% RH)
Ratings
Note: Information contained in this catalog represents general requirements for this Series. Contact us for the drawings and specifications for a
specific part number shown.
* V.S.W.R. Measurement System
Measured as shown on the block diagram below.
■Materials / Finishes
Note1: A N.FL Cable assembly (plug) is measured with SMA conversion
adapters mated with N.FL plugs at both ends of a 100cm coaxial cable
harness
Note2: A N.FL receptacle, which is mounted on a 50 ohms glass epoxy board,
is measured with a SMA conversion adapter.
Network Analyzer
Test Set
Test Port
Termination
D.U.T
Test Port Cable
Shell
Phosphor bronze
Silver plated
-------
Female center contact
Phosphor bronze
Gold plated
-------
Insulator
PBT
Color: Black
UL94V-0
Part
Material
Finish
Remarks
●Plug
●Receptacle
Shell
Phosphor bronze
Silver plated
-------
Male center contact
Brass
Gold plated
-------
Insulator
LCP
Color: Black
UL94V-0
Part
Material
Finish
Remarks
The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.