
B24
Item
Specification
Condition
1. Contact resistance
Inner
: 10 m max.
Outside : 5 m max.
100 mA max.
2. Insulation resistance
500 M min.
250 V DC
3. Withstanding voltage
No flashover or insulation breakdown.
300 V AC / 1 minute
4. V.S.W.R.(*)
1.3 max.
DC to 3 GHz
5. Female contact retention
0.2 N min.
Measured with a 0.3 pin gauge
6. Insertion and withdrawal force (plug)
1.96 N min.
With corresponding connector
7. Durability (Insertion/withdrawal)
Contact resistance: Amount of change 10 m max.
250 cycles
12. Salt spray
No marked corrosion
Exposed to density 5% salt water for 48 hours
8. Vibration
No electrical discontinuity of 1s or more
No damage, cracks, or parts looseness.
Frequency: 10 to 500 Hz, single amplitude of 0.75 mm or
acceleration of 98 m/s2(peak), 2 hours in each of the 3 directions.
9. Shock
No electrical discontinuity of 1s or more
No damage, cracks, or parts looseness.
Acceleration of 490 m/s2, 11 ms duration, sine half-wave
waveform, 10 cycles in each of the 3 axis
10. Humidity (Steady state)
Insulation resistance
100 M min. (at high humidity)
500 M min. (when dry)
No damage, cracks, or parts looseness.
240 hours at temperature of 25 to 65 and humidity of
90% to 96%
11. Temperature cycle
No damage, cracks, or parts looseness.
Temperature: -55°C 5 to 35°C 85°C 5 to 35°C
Time:
30 min Within 5 min 30 min. Within 5 min
Cycles:
5
s Product Specifications
s Ordering Information
sMaterials
part
Material
Finish
Body
Brass/Phosphor bronze
Gold and nickel plating/Gold plating
Insulator
PTFE
——————
Female inner contact
Beryllium copper
Gold plating
Male vinnerr contact
Phosphor bronze
Gold plating
Spring coil
Piano wire
Nickel plating
Heat-shrink tubing
Polyolefin
——————
POD3 – [
]
– [
]
qw
e
q Series name: POD3
w Connector types
J
: Jack
R
: Receptacle
PR : Plug receptacle
e Applicable cable or suffix
DFS111: CO-6F FH-SB manufactured by
Hitachi Cable, Ltd.
DFS111-UL1979 manufactured by
Junkosha Co., Ltd.
*Voltage standing wave ratio (V.S.W.R.) measuring system.
The above voltage standing wave ratio (V.S.W.R.) standard value is measured in the measuring system as shown below.
Note1: The cable connector is measured with double ended 10cm cable assembly.
Note2: The printed circuit board connector is mounted on the 50 ohms PCB, to
which Hirose's adaptor is connected.
Ratings
Nominal characteristic impedance
50 ohms
Voltage
100 V AC
Frequency
DC to 3 GHz
Operating temperature
-30C° to +85C°
Operating humidity
95% max.
The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.