参数资料
型号: IB050Q120T53N1-CB
厂商: Vicor Corporation
文件页数: 10/15页
文件大小: 0K
描述: 1/4 BRICK IBC 36-60VIN 53A EVAL
标准包装: 1
系列: VI BRICK™
主要目的: DC/DC,步降
输出及类型: 1,隔离
功率 - 输出: 650W
输出电压: 12V
电流 - 输出: 53A
输入电压: 36 ~ 60V
稳压器拓扑结构: 降压
频率 - 开关: 1MHz
板类型: 完全填充
已供物品:
已用 IC / 零件: IB050Q120T53
相关产品: 1102-1046-ND - IBC MODULE 12VDC 53A 650W
其它名称: 1102-1052
IB050Q120T53N1-00
PIN / CONTROL FUNCTIONS
+In / -In – DC Voltage Input Pins
The IBC input voltage range should not be exceeded. An internal
undervoltage /overvoltage lockout function prevents operation outside of
the normal operating input range. The IBC turns on within an input voltage
of 200 nH, the RC damper may be 47 μ F in series with 0.3 Ω . A single
window bounded by the “Input under-voltage turn-on” and “Input
over-voltage turn-off” levels, as specified. The IBC may be protected against
accidental application of a reverse input voltage by the addition of a
rectifier in series with the positive input, or a reverse rectifier in shunt with
the positive input located on the load side of the input fuse.
The connection of the IBC to its power source should be implemented with
minimal distribution inductance. If the interconnect inductance exceeds
100 nH, the input should be bypassed with a RC damper to retain low
source impedance and stable operation. With an interconnect inductance
electrolytic or equivalent low-Q capacitor may be used in place of the series
RC bypass.
1
2
3
Top View
Pin
Function
5
4
EN - Enable/Disable
Negative Logic Option
If the EN port is left floating, the IBC output is disabled. Once this port is-
pulled lower than 0.8 Vdc with respect to –In, the output is enabled. The
EN port can be driven by a relay, opto-coupler, or open collector transistor.
Refer to Figures 6 and 7 for the typical enable / disable characteristics. This
port should not be toggled at a rate higher than 1 Hz. The EN port should
also not be driven by or pulled up to an external voltage source.
Positive Logic Option
If the EN port is left floating, the IBC output is enabled. Once this port is
pulled lower than 1.4 Vdc with respect to –In, the output is disabled. This
action can be realized by employing a relay, opto-coupler, or open collector
transistor. This port should not be toggled at a rate higher than 1 Hz.
The EN port should also not be driven by or pulled up to an external volt-
age source. The EN port can source up to 2 mA at 5 Vdc. The EN port
should never be used to sink current.
If the IBC is disabled using the EN pin, the module will attempt to restart
approximately every 250ms. Once the module has been disabled for at least
250ms, the turn on delay after the EN pin is enabled will be as shown in
Figure 7.
+Out / -Out – DC Voltage Output Pins
Total load capacitance at the output of the IBC should not exceed the
specified maximum. Owing to the wide bandwidth and low output
impedance of the IBC, low frequency bypass capacitance and significant
energy storage may be more densely and efficiently provided by adding
capacitance at the input of the IBC.
1
2
3
4
5
Figure 30 — IBC Pin Designations
Vin+
Enable
Vin-
Vout-
Vout+
IBC MODULE
Page 10 of 15
Rev 2.4
8/2013
vicorpower.com
800 735.6200
相关PDF资料
PDF描述
LXC100-1400SW POWER SUPPLY LED 100W 1400MA
VI-230-CX-S CONVERTER MOD DC/DC 5V 75W
NTST20U100CTG DIODE SCHOTTKY 10A 100V TO-220
IB050Q096T70N1-CB 1/4 BRICK IBC 36-60VIN 70A EVAL
TC4431EJA IC MOSFET DRIVER 30V 1.5A 8-CDIP
相关代理商/技术参数
参数描述
IB0639412 制造商:Amphenol PCD 功能描述:IB-I 6 - Bulk
IB0XXQ096T80XX-XX 制造商:VICOR 制造商全称:Vicor Corporation 功能描述:5:1 Intermediate Bus Converter Module: Up to 850 W Output
IB1 制造商:BACO Controls Inc 功能描述:
IB10 制造商:IBase Technology (USA) Inc. 功能描述:KIT W/ IDEX2, COMX2, VGA, AUDIO, RJ45, USBX2 FOR (IP100) - Bulk 制造商:Austerlitz Electronic 功能描述:
IB100 制造商:Hubbell Wiring Device-Kellems 功能描述:ICON, BLANK,BL,100PK