参数资料
| 型号： | ICM7555IBAZ-T |
| 厂商： | Intersil |
| 文件页数： | 9/12页 |
| 文件大小： | 0K |
| 描述： | IC OSC MONO TIMING 1MHZ 8-SOIC |
| 标准包装： | 1 |
| 类型： | 555 型，计时器/振荡器（单路） |
| 频率： | 1MHz |
| 电源电压： | 2 V ~ 18 V |
| 电流 - 电源： | 60µA |
| 工作温度： | -25°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 标准包装 |
| 供应商设备封装： | 8-SOIC |
| 安装类型： | 表面贴装 |
| 其它名称： | ICM7555IBAZ-TDKR |
6
FN2867.9
August 24, 2006
OUTPUT DRIVE CAPABILITY
The output driver consists of a CMOS inverter capable of
driving most logic families including CMOS and TTL. As
such, if driving CMOS, the output swing at all supply
voltages will equal the supply voltage. At a supply voltage of
4.5V or more, the ICM7555 and ICM7556 will drive at least
two standard TTL loads.
ASTABLE OPERATION
The circuit can be connected to trigger itself and free run as
a multivibrator, see Figure 2A. The output swings from rail to
rail, and is a true 50% duty cycle square wave. (Trip points
and output swings are symmetrical.) Less than a 1%
frequency variation is observed over a voltage range of +5V
to +15V.
The timer can also be connected as shown in Figure 2B. In this
circuit, the frequency is:
The duty cycle is controlled by the values of RA and RB, by the
equation:
MONOSTABLE OPERATION
In this mode of operation, the timer functions as a one-shot.
See Figure 3. Initially the external capacitor (C) is held
discharged by a transistor inside the timer. Upon application of
a negative TRIGGER pulse to pin 2, the internal flip-flop is set
which releases the short circuit across the external capacitor
and drives the OUTPUT high. The voltage across the capacitor
now increases exponentially with a time constant t = RAC.
When the voltage across the capacitor equals 2/3 V+, the
comparator resets the flip-flop, which in turn discharges the
capacitor rapidly and also drives the OUTPUT to its low state.
TRIGGER must return to a high state before the OUTPUT can
return to a low state.
CONTROL VOLTAGE
The CONTROL VOLTAGE terminal permits the two trip
voltages for the THRESHOLD and TRIGGER internal
comparators to be controlled. This provides the possibility of
oscillation frequency modulation in the astable mode or even
inhibition of oscillation, depending on the applied voltage. In
the monostable mode, delay times can be changed by
varying the applied voltage to the CONTROL VOLTAGE pin.
RESET
The RESET terminal is designed to have essentially the
same trip voltage as the standard bipolar 555/6, i.e., 0.6V to
0.7V. At all supply voltages it represents an extremely high
input impedance. The mode of operation of the RESET
function is, however, much improved over the standard
bipolar NE/SE 555/6 in that it controls only the internal flip-
flop, which in turn controls simultaneously the state of the
OUTPUT and DISCHARGE pins. This avoids the multiple
threshold problems sometimes encountered with slow falling
edges in the bipolar devices.
OUTPUT
1
2
3
4
8
7
6
5
VDD
OPTIONAL
CAPACITOR
C
VDD
RA
RB
FIGURE 2B. ALTERNATE ASTABLE CONFIGURATION
f
1
1.4 RC
------------------
=
(EQ. 1)
f1.44 RA 2RB
+
()
C
=
(EQ. 2)
DRA RB
+
() RA 2RB
+
()
=
(EQ. 3)
TRIGGER
OUTPUT
RESET
1
2
3
4
8
7
6
5
VDD
DISCHARGE
THRESHOLD
CONTROL
VOLTAGE
OPTIONAL
CAPACITOR
C
VDD ≤18V
RA
ICM7555
tOUTPUT = -ln (1/3) RAC = 1.1RAC
FIGURE 3. MONOSTABLE OPERATION
ICM7555, ICM7556
相关PDF资料 |
PDF描述 |
|---|---|
| D38999/24KG41SA | CONN RCPT 41POS JAM NUT W/SCKT |
| V110A15M300B3 | CONVERTER MOD DC/DC 15V 300W |
| MS27468E19A32P | CONN RCPT 32POS JAM NUT W/PINS |
| MS3116J12-10PW | CONN PLUG 10POS STRAIGHT W/PINS |
| MS3116J12-10P | CONN PLUG 10POS STRAIGHT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ICM7555ID | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:General purpose CMOS timer |
| ICM7555ID,602 | 功能描述:计时器和支持产品 CMOS TIMER -40 TO +85 RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
| ICM7555ID,623 | 功能描述:计时器和支持产品 CMOS TIMER -40 TO +85 RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
| ICM7555ID/01,112 | 功能描述:计时器和支持产品 CMOS TIMR -40 TO +85 RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
| ICM7555ID/01,118 | 功能描述:计时器和支持产品 CMOS TIMER GEN-PURPOSE RoHS:否 制造商:Micrel 类型:Standard 封装 / 箱体:SOT-23 内部定时器数量:1 电源电压-最大:18 V 电源电压-最小:2.7 V 最大功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。