- 您现在的位置：买卖IC网 > PDF目录61066 > ICPL3700 (ISOCOM LTD) 1 CHANNEL LOGIC OUTPUT OPTOCOUPLER PDF资料下载
参数资料
| 型号： | ICPL3700 |
| 厂商： | ISOCOM LTD |
| 元件分类： | 光电耦合器 |
| 英文描述： | 1 CHANNEL LOGIC OUTPUT OPTOCOUPLER |
| 文件页数： | 4/4页 |
| 文件大小： | 78K |
| 代理商： | ICPL3700 |
CML
Common Mode Transient
Immunity at Logic Low Level
Output
RL=4.7kohm, VCML=140V,
IIN=3.11mA, VO(MAX)=0.8V
-600
V/s
7,8
Notes
1. Current into/out of any single lead
2. Surge input current duration is 3ms at 120Hz pulse repetition rate. Transient input current duration is
10s at 120Hz pulse repetition rate. Maximum input power, Pin, must be observed.
3. Maximum input power dissipation of 230mW allows an input IC junction temperature of 125°C at an
ambient temperature of Ta=70°C with a typical thermal resistance from junction to ambient of
jai=240°C/W. Excessive Pin and Tj may result in IC chip degradation.
4. Maximum output power dissipation of 210mW allows an output IC junction temperature of 125°C at an
ambient temperature of Ta=70°C with a typical thermal resistance from junction to ambient of
jao=265°C/W.
5. Maximum operating frequency is defined when output waveform (Pin 6) obtains only 90% of Vcc with
Rl=4.7kohm, Cl=30pF using a 5V square wave input signal.
6. The tPHL (tPLH) propagation delay is measured from the 2.5V level of the leading (trailing) edge of a
5.0V input pulse, 1s rise (fall) time, to the 1.5V level on the leading (trailing) edge of the output pulse.
7. Common mode transient immunity in Logic High (Low) Level is the maximum tolerable, positive
(negative), dVcm/dt on the leading (trailing) edge of the common mode pulse signal, Vcm, to ensure that the
output will remain in a Logic High (Low) state, ie. Vo>2.0V (Vo<0.8V).
8. In applications where dVcm/dt may exceed 50000V/s (such as static discharge), a series resistor Rcc
should be included to protect the detector IC from destructively high surge currents. The recommended
value for Rcc is 240ohm per volt of allowable drop in Vcc between Pin 8 and Vcc with a minimum value of
240ohm.
9. Logic low output level at Pin 6 occurs under the conditions of Vin>=Vth+ as well as the range Vin>Vth-
once Vin has exceeded Vth+. Logic high output level at Pin 6 occurs under the conditions of Vin<=Vth- as
well as the range of Vin<Vth+ once Vin has decreased below Vth-.
10. AC voltage is instantaneous voltage.
11. Device considered a two-terminal device: Pins 1,2,3,4 connected together, and Pins 5,6,7,8 connected
together.
Isocom takes great effort to ensure accurate data, but regrettably cannot be held liable for any error on its
website. Visit File Lists to confirm old printouts are up-to-date.
Contents
相关PDF资料 |
PDF描述 |
|---|---|
| ICS1494M-539LF | 120 MHz, VIDEO CLOCK GENERATOR, PDSO20 |
| ICS1494M-543 | 130.48 MHz, VIDEO CLOCK GENERATOR, PDSO20 |
| ICS1494AN-XXX | 135 MHz, VIDEO CLOCK GENERATOR, PDIP20 |
| ICS1494N-XXX-LF | 135 MHz, VIDEO CLOCK GENERATOR, PDIP20 |
| ICS1694AM-010 | 40 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ICPL4502 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:HIGH SPEED, NON BASE LEAD OPTICALLY COUPLED ISOLATOR PHOTOTRANSISTOR OUTPUT |
| ICPL4502_09 | 制造商:ISOCOM 制造商全称:ISOCOM 功能描述:8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER |
| ICPL4502Y | 制造商:ISOCOM 制造商全称:ISOCOM 功能描述:8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER |
| ICPN10 | 制造商:Panasonic Industrial Company 功能描述:IC PROTECTOR |
| ICP-N10 | 制造商:ROHM 制造商全称:Rohm 功能描述:Circuit protection elements |
发布紧急采购，3分钟左右您将得到回复。