参数资料
型号: ICS2059GI-02T
厂商: IDT, Integrated Device Technology Inc
文件页数: 8/12页
文件大小: 0K
描述: IC CLK MULT/JITTER ATTEN 16TSSOP
产品变化通告: Product Discontinuation 13/May/2009
标准包装: 2,500
类型: 漂移衰减器,多路复用器
PLL:
输入: 时钟,晶体
输出: CMOS
电路数: 1
比率 - 输入:输出: 2:1
差分 - 输入:输出: 无/无
频率 - 最大: 27MHz
除法器/乘法器: 是/是
电源电压: 3.15 V ~ 3.45 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 16-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 16-TSSOP
包装: 带卷 (TR)
其它名称: 2059GI-02T
ICS2059-02
CLOCK MULTIPLIER AND JITTER ATTENUATOR
VCXO AND SYNTHESIZERS
IDT / ICS CLOCK MULTIPLIER AND JITTER ATTENUATOR
5
ICS2059-02
REV E 051310
A “normalized” PLL loop bandwidth may be calculated
as follows:
The “normalized” bandwidth equation above does not
take into account the effects of damping factor or the
second pole. However, it does provide a useful
approximation of filter performance.
The loop damping factor is calculated as follows:
Where:
RS = Value of resistor in loop filter (Ohms)
ICP = Charge pump current (amps)
(refer to Charge Pump Current Table, below)
N = Crystal multiplier shown in the above
table
CS = Value of capacitor C1 in loop filter (Farads)
As a general rule, the following relationship should be
maintained between components C1 and C2 in the loop
filter:
Charge Pump Current Table
Special considerations must be made in choosing loop
components CS and CP. Series Termination Resistor
Clock output traces over one inch should use series
termination. To series terminate a 50
trace (a
commonly used trace impedance), place a 33
resistor
in series with the clock line, as close to the clock output
pin as possible. The nominal impedance of the clock
output is 20
. (The optional series termination resistor
is not shown in the External Component Schematic.)
Decoupling Capacitors
As with any high-performance mixed-signal IC, the
ICS2059-02 must be isolated from system power
supply noise to perform optimally.
Decoupling capacitors of 0.01F must be connected
between each VDD and the PCB ground plane. To
further guard against interfering system supply noise,
the ICS2059-02 should use one common connection to
the PCB power plane as shown in the diagram on the
next page. The ferrite bead and bulk capacitor help
reduce lower frequency noise in the supply that can
lead to output clock phase modulation.
NBW
RS ICP
×
575
×
N
-----------------------------------------
=
345
Damping Factor
RS
625
I
CP
×
CS
×
N
-------------------------------------------
×
=
375
CP
CS
20
------
=
RSET
Charge Pump Current
(ICP)
1.4 M
10
A
680 k
20
A
540 k
25
A
120 k
100
A
相关PDF资料
PDF描述
ICS2510CGLF IC CLOCK DVR PLL 3.3V 24-TSSOP
ICS251PMLF IC CLK SYNTHESIZER FP SGL 8-SOIC
ICS252PMLF IC CLK SYNTHESIZER FP DUAL 8SOIC
ICS271PGILF VCXO CLK TRPL PLL PROGR 20-TSSOP
ICS275PGILF VCXO CLK SYNTH TRPL PLL 16-TSSOP
相关代理商/技术参数
参数描述
ICS2101M 制造商:未知厂家 制造商全称:未知厂家 功能描述:
ICS2101N 制造商:未知厂家 制造商全称:未知厂家 功能描述:
ICS2102M 制造商:未知厂家 制造商全称:未知厂家 功能描述:Tone/Volume/Balance Control
ICS2115V 制造商:未知厂家 制造商全称:未知厂家 功能描述:Waveform Generator/Support
ICS2115Y 制造商:未知厂家 制造商全称:未知厂家 功能描述:Waveform Generator/Support