参数资料
型号: ICS91718CMLF
厂商: IDT, Integrated Device Technology Inc
文件页数: 6/11页
文件大小: 0K
描述: IC CLOCK GENERATOR LOW EMI 8SOIC
标准包装: 97
类型: 时钟发生器
PLL: 带旁路
输入: 时钟
输出: 时钟
电路数: 1
比率 - 输入:输出: 1:2
差分 - 输入:输出: 无/无
频率 - 最大: 80MHz
除法器/乘法器: 无/无
电源电压: 3 V ~ 3.6 V
工作温度: 0°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
其它名称: 91718CMLF
4
ICS91718
0500D—07/15/04
1. The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for verification.
Read-Back will support Intel PIIX4 "Block-Read" protocol.
2. The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3. The input is operating at 3.3V logic levels.
4. The data byte format is 8 bit bytes.
5. To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller. The bytes
must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte has been
transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those two bytes.
The data is loaded until a Stop sequence is issued.
6. At power-on, all registers are set to a default condition, as shown.
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D4(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D5(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Byte 7
Stop Bit
How to Read:
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D4
(H)
ICS clock will
acknowledge
Controller (host) sends a dummy command code
ICS clock will
acknowledge
Controller (host) sends a dummy byte count
ICS clock will
acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 6
ICS clock will
acknowledge each byte one at a time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D5
(H)
ICS clock will
acknowledge
ICS clock will send the
byte count
Controller (host) acknowledges
ICS clock sends first byte
(Byte 0) through byte 7
Controller (host) will need to acknowledge each
byte
Controller (host) will send a stop bit
Notes:
相关PDF资料
PDF描述
ICS91720BGLF IC CLK GENERATOR LOW EMI 8-TSSOP
ICS9179BF-03 IC CLK BUFFER 1:10 133MHZ 28SSOP
ICS91857AGT IC CLOCK DRIVER SSTL_2 48-TSSOP
ICS93718CFLFT IC CLK BUFF 2:12 200MHZ 48-SSOP
ICS951601AFLFT IC FREQ TIMING GENERATOR 48-SSOP
相关代理商/技术参数
参数描述
ICS91718CMLFT 功能描述:IC CLOCK GENERATOR LOW EMI 8SOIC RoHS:是 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:- 标准包装:2,000 系列:- 类型:PLL 时钟发生器 PLL:带旁路 输入:LVCMOS,LVPECL 输出:LVCMOS 电路数:1 比率 - 输入:输出:2:11 差分 - 输入:输出:是/无 频率 - 最大:240MHz 除法器/乘法器:是/无 电源电压:3.135 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:32-LQFP 供应商设备封装:32-TQFP(7x7) 包装:带卷 (TR)
ICS91718CMT 功能描述:IC CLOCK GENERATOR LOW EMI 8SOIC RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:- 标准包装:2,000 系列:- 类型:PLL 时钟发生器 PLL:带旁路 输入:LVCMOS,LVPECL 输出:LVCMOS 电路数:1 比率 - 输入:输出:2:11 差分 - 输入:输出:是/无 频率 - 最大:240MHz 除法器/乘法器:是/无 电源电压:3.135 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:32-LQFP 供应商设备封装:32-TQFP(7x7) 包装:带卷 (TR)
ICS91718YGLF-T 制造商:ICS 制造商全称:ICS 功能描述:Low EMI, Spread Modulating, Clock Generator
ICS91718YMLF-T 制造商:ICS 制造商全称:ICS 功能描述:Low EMI, Spread Modulating, Clock Generator
ICS91719 制造商:ICS 制造商全称:ICS 功能描述:Low EMI, Spread Modulating, Clock Generator