参数资料
型号: IR204C/H16/L10
厂商: Everlight Electronics Co Ltd
文件页数: 8/8页
文件大小: 0K
描述: LED IR 3MM GAA1AS WATER CLEAR TH
标准包装: 1,000
电流 - DC 正向(If): 50mA
辐射强度(le)最小值@正向电流: 5mW/sr @ 20mA
波长: 940nm
正向电压: 1.2V
视角: 50°
方向: 顶视图
安装类型: 通孔
封装/外壳: 径向
包装: 散装
其它名称: 1080-1076
DATASHEET
3mm Infrared LED
IR204C/H16/L10
?
?
?
?
?
Avoiding applying any stress to the lead frame while the LEDs are at high temperature particularly when soldering.
Dip and hand soldering should not be done more than one time
After soldering the LEDs, the epoxy bulb should be protected from mechanical shock or vibration until the LEDs return to
room temperature.
A rapid-rate process is not recommended for cooling the LEDs down from the peak temperature.
Although the recommended soldering conditions are specified in the above table, dip or hand soldering at the lowest
possible temperature is desirable for the LEDs.
Wave soldering parameter must be set and maintain according to recommended temperature and dwell time in the solder
wave.
4.
Cleaning
?
?
When necessary, cleaning should occur only with isopropyl alcohol at room temperature for a duration of no more than
one minute. Dry at room temperature before use.
Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of ultrasonic cleaning on the LEDs
depends on factors such as ultrasonic power and the assembled condition. Ultrasonic cleaning shall be pre-qualified to
ensure this will not cause damage to the LED
5.
Heat Management
?
?
Heat management of LEDs must be taken into consideration during the design stage of LED application. The current
should be de-rated appropriately by referring to the de-rating curve found in each product specification.
The temperature surrounding the LED in the application should be controlled. Please refer to the data sheet de-rating
curve.
6.
ESD (Electrostatic Discharge)
?
?
?
?
Electrostatic discharge (ESD) or surge current (EOS) can damage LEDs.
An ESD wrist strap, ESD shoe strap or antistatic gloves must be worn whenever handling LEDs.
All devices, equipment and machinery must be properly grounded.
Use ion blower to neutralize the static charge which might have built up on surface of the LEDs plastic lens as a result of
friction between LEDs during storage and handing.
7.
Other
?
?
?
Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above
specification.
When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these
specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does
not comply
with the absolute maximum ratings and the instructions included in these specification sheets.
These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t
reproduce or cause anyone to reproduce them without EVERLIGHT’s consent.
8
www.everlight.com
:4
Revision Copyright ?
LifecyclePhase:
No: Release
2010, Everlight All Rights Reserved. Release Date : Jun.07.2013. Issue DIR-0000231 Date:2013-06-10 16:24:33.0
Expired Period: Forever
相关PDF资料
PDF描述
IR25-21C/TR8 LED 3MM GAA1AS WATER CLR REV SMD
IR26-21C/L110/TR8 LED IR SUBMINI 1.6MM ROUND SMD
IR26-51C/L110/TR8 LED IR SUBMINI 1.6MM ROUND SMD
IR323/H0-A LED IR 5MM GAA1AS BLUE TH
IR323 LED IR 5MM GAA1AS BLUE TH
相关代理商/技术参数
参数描述
IR204-H60 制造商:EVERLIGHT 制造商全称:Everlight Electronics Co., Ltd 功能描述:3mm Infrared LED, T-1
IR205 制造商:Extech Instruments Corporation 功能描述:
IR2085S 功能描述:IC DRVR HALF-BRDG SELF-OSC 8SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - MOSFET,电桥驱动器 - 外部开关 系列:- 标准包装:50 系列:- 配置:高端 输入类型:非反相 延迟时间:200ns 电流 - 峰:250mA 配置数:1 输出数:1 高端电压 - 最大(自引导启动):600V 电源电压:12 V ~ 20 V 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:8-DIP(0.300",7.62mm) 供应商设备封装:8-DIP 包装:管件 其它名称:*IR2127
IR2085SHR 制造商:International Rectifier 功能描述:MOSFET DRVR 100V 1A 2-OUT Hi/Lo Side Half Brdg 8-Pin SOIC Tube 制造商:International Rectifier 功能描述:MOSFET DRVR 100V 1A 2-OUT HI/LO SIDE HALF BRDG SELF-OSC 8SOI - Rail/Tube
IR2085SPBF 功能描述:IC DRIVER HALF BRIDGE OSC 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - MOSFET,电桥驱动器 - 外部开关 系列:- 标准包装:50 系列:- 配置:高端 输入类型:非反相 延迟时间:200ns 电流 - 峰:250mA 配置数:1 输出数:1 高端电压 - 最大(自引导启动):600V 电源电压:12 V ~ 20 V 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:8-DIP(0.300",7.62mm) 供应商设备封装:8-DIP 包装:管件 其它名称:*IR2127