参数资料
| 型号： | IR3080MPBF |
| 厂商： | International Rectifier |
| 文件页数： | 24/41页 |
| 文件大小： | 0K |
| 描述： | IC PHASE CONTROLLER 32MLPQ |
| 标准包装： | 5 |
| 系列： | XPhase™ |
| 应用： | 处理器 |
| 电流 - 电源： | 11mA |
| 电源电压： | 9.5 V ~ 14 V |
| 工作温度： | 0°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-MLPQ（5x5） |
| 包装： | 剪切带 (CT) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页
IR3080 PbF
Combined Over Temperature and Phase Delay Setting Resistors R PHASE1 , R PHASE2 and R PHASE3
The over temperature setting resistor divider can be combined with the phase delay resistor divider to save one
resistor per phase.
Calculate the HOTSET threshold voltage V HOTSET corresponding to the allowed maximum temperature from
Equation (23). If the over temperature setting voltage is lower than the phase delay setting voltage,
VBIAS*RA PHASEx , connect RMPIN+ or RMPIN- pin between R PHASEx1 and R PHASEx2, and connect HOTSET pin
between R PHASEx2 and R PHASEx3 . Pre-select R PHASEx1 ,
R PHASEx 2 =
R PHASEx 3 =
( RA PHASEx ? V BIAS ? V HOTSET ) * R PHASEx 1
V BIAS ? ( 1 ? RA PHASEx )
V HOTSET ? R PHASEx 1
V BIAS * ( 1 ? RA PHASEx )
(26)
(27)
If the over temperature setting voltage is higher than the phase delay setting voltage, VBIAS*RA PHASEx , connect
HOTSET pin between R PHASEx1 and R PHASEx2 and connect RMPIN+ or RMPIN- between R PHASEx2 and R PHASEx3
respectively. Pre-select R PHASEx1 ,
R PHASEx 2 =
R PHASEx 3 =
( V HOTSET ? RA PHASEx ? V BIAS ) ? R PHASEx 1
V BIAS ? V HOTSET
RA PHASEx ? V BIAS * R PHASEx 1
V BIAS ? V HOTSET
(28)
(29)
Bootstrap Capacitor C BST
Depending on the duty cycle and gate drive current of the phase IC, a 0.1uF to 1uF capacitor is needed for the
bootstrap circuit.
Decoupling Capacitors for Phase IC
0.1uF-1uF decoupling capacitors are required at VCC and VCCL pins of phase ICs.
VOLTAGE LOOP COMPENSATION
The adaptive voltage positioning (AVP) is usually adopted in the computer applications to improve the transient
response and reduce the power loss at heavy load. Like current mode control, the adaptive voltage positioning loop
introduces extra zero to the voltage loop and splits the double poles of the power stage, which make the voltage
loop compensation much easier.
Resistors R FB and R DRP are chosen according to Equations (16) and (17), and the selection of compensation types
depends on the output capacitors used in the converter. For the applications using Electrolytic, Polymer or AL-
Polymer capacitors and running at lower frequency, type II compensation shown in Figure 17(a) is usually enough.
While for the applications using only ceramic capacitors and running at higher frequency, type III compensation
shown in Figure 17(b) is preferred.
For applications where AVP is not required, the compensation is the same as for the regular voltage mode control.
For converter using Polymer, AL-Polymer, and ceramic capacitors, which have much higher ESR zero frequency,
type III compensation is required as shown in Figure 17(b) with R DRP and C DRP removed.
Type II Compensation for AVP Applications
Determine the compensation at no load, the worst case condition. Choose the crossover frequency fc between 1/10
and 1/5 of the switching frequency per phase. Assume the time constant of the resistor and capacitor across the
output inductors matches that of the inductor, and determine R CP and C CP from Equations (30) and (31), where L E
and C E are the equivalent inductance of output inductors and the equivalent capacitance of output capacitors
respectively.
Page 24
相关PDF资料 |
PDF描述 |
|---|---|
| IR3080M | IC PHASE CONTROLLER 32-MLPQ |
| IR3081AMPBF | IC CTRLR XPHASE VR10.0 28MLPQ |
| IR3081AMTRPBF | IC CTRLR XPHASE VR10.0 28MLPQ |
| IR3081MPBF | IC PHASE CONTROLLER 28MLPQ |
| IR3081M | IC PHASE CONTROLLER 28-MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3080MPBF | 制造商:International Rectifier 功能描述:Controller IC Package/Case:32-MLPQ |
| IR3080MTR | 功能描述:IC PHASE CONTROLLER 32L MLPQ RoHS:否 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3080MTRPBF | 功能描述:开关变换器、稳压器与控制器 XPHASE VRD10 CTRL IC CTRL IC 200 to 700mV RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| IR3080PBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASETM VRD10 CONTROL IC WITH VCCVID & OVERTEMP DETECT |
| IR3081 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE VR 10.0 CONTROL IC |
发布紧急采购，3分钟左右您将得到回复。