参数资料
型号: IR3088AMTR
厂商: International Rectifier
文件页数: 17/33页
文件大小: 0K
描述: IC XPHASE W/FAULT DET 20L-MLPQ
标准包装: 1
系列: XPhase™
应用: 处理器
电流 - 电源: 10mA
电源电压: 8.4 V ~ 14 V
工作温度: 0°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 20-MLPQ
供应商设备封装: 20-MLPQ(4x4)
包装: 剪切带 (CT)
其它名称: *IR3088AMTR
IR3088AMCT
IR3088A
Phase Delay Timing Resistors R PHASE1 and R PHASE2
The phase delay of the interleaved multiphase converter is programmed by the resistor divider connected at
RMPIN+ or RMPIN- depending on which slope of the oscillator ramp is used for the phase delay programming of
phase IC, as shown in Figure 3.
If the upslope is used, RMPIN+ pin of the phase IC should be connected to RMPOUT pin of the control IC and
RMPIN- pin should be connected to the resistor divider. When RMPOUT voltage is above the trip voltage at
RMPIN- pin, the PWM latch is set. GATEL becomes low, and GATEH becomes high after the non-overlap time.
If down slope is used, RMPIN- pin of the phase IC should be connected to RMPOUT pin of the control IC and
RMPIN+ pin should be connected to the resistor divider. When RMPOUT voltage is below the trip voltage at
RMPIN- pin, the PWM latch is set. GATEL becomes low, and GATEH becomes high after the non-overlap time.
Use VBIAS voltage as the reference for the resistor divider since the oscillator ramp magnitude from control IC
tracks VBIAS voltage. Try to avoid both edges of the oscillator ramp for better noise immunity. Determine the ratio
of the programming resistors corresponding to the desired switching frequencies and phase numbers. If the resistor
R PHASEx1 is pre-selected, the resistor R PHASEx2 is determined as:
R PHASEx 2 =
RA PHASEx ? R PHASEx 1
1 ? RA PHASEx
(20)
Combined Over Temperature and Phase Delay Setting Resistors R PHASE1 , R PHASE2 and R PHASE3
The over temperature setting resistor divider can be combined with the phase delay resistor divider to save one
resistor per phase.
Calculate the HOTSET threshold voltage V HOTSET corresponding to the allowed maximum temperature from
Equation (18). If the over temperature setting voltage is lower than the phase delay setting voltage,
VBIAS*RA PHASEx , connect RMPIN+ or RMPIN- pin between R PHASEx1 and R PHASEx2, and connect HOTSET pin
between R PHASEx2 and R PHASEx3 . Pre-select R PHASEx1 ,
R PHASEx 2 =
R PHASEx 3 =
( RA PHASEx ? V BIAS ? V HOTSET ) * R PHASEx 1
V BIAS ? ( 1 ? RA PHASEx )
V HOTSET ? R PHASEx 1
V BIAS * ( 1 ? RA PHASEx )
(21)
(22)
If the over temperature setting voltage is higher than the phase delay setting voltage, VBIAS*RA PHASEx , connect
HOTSET pin between R PHASEx1 and R PHASEx2, and connect RMPIN+ or RMPIN- between R PHASEx2 and R PHASEx3 .
Pre-select R PHASEx1 ,
R PHASEx 2 =
R PHASEx 3 =
( V HOTSET ? RA PHASEx ? V BIAS ) ? R PHASEx 1
V BIAS ? V HOTSET
RA PHASEx ? V BIAS * R PHASEx 1
V BIAS ? V HOTSET
(23)
(24)
Bootstrap Capacitor C BST
Depending on the duty cycle and gate drive current of the phase IC, a 0.1uF to 1uF capacitor is needed for the
bootstrap circuit.
Decoupling Capacitors for Phase IC
0.1uF-1uF decoupling capacitors are required at VCC and VCCL pins of phase ICs.
Page 17 of 33
1/15 /05
相关PDF资料
PDF描述
IR3088MTRPBF IC CTLR XPHASE 28-MLPQ
IR3092MTRPBF IC CONTROLLER 2PHASE 48-MLPQ
IR3092M IC CONTROLLER 2PHASE 48-MLPQ
IR3093MTRPBF IC CTLR 3PHASE VR10 48-MLQP
IR3094MPBF IC REG CTRLR BUCK PWM VM 48MLPQ
相关代理商/技术参数
参数描述
IR3088AMTRPBF 功能描述:开关变换器、稳压器与控制器 XPHASE IC W/ FAULT OVERTEMP DETECT RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
IR3088APBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASETM PHASE IC WITH FAULT AND OVERTEMP DETECT
IR3088M 功能描述:IC XPHASE W/FAULT DET 20L-MLPQ RoHS:否 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像,声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP(8x8) 包装:管件
IR3088MPBF 功能描述:IC CONTROLLER PHASE 20L-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像,声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP(8x8) 包装:管件
IR3088MTR 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE PHASE IC WITH FAULT AND OVERTEMP DETECT