- 您现在的位置：买卖IC网 > PDF目录1221 > IRPLDIM5E (International Rectifier)KIT DES BALLAST 4LEVEL DIM FLUOR PDF资料下载
参数资料
| 型号： | IRPLDIM5E |
| 厂商： | International Rectifier |
| 文件页数： | 11/17页 |
| 文件大小： | 0K |
| 描述： | KIT DES BALLAST 4LEVEL DIM FLUOR |
| 标准包装： | 1 |
| 主要目的： | 照明，镇流器控制 |
| 嵌入式： | 是，MCU，8 位 |
| 已用 IC / 零件： | IRS2530D |
| 主要属性： | 25W CFL 灯调光驱动器，220 VAC 输入，电压模式加热 |
| 次要属性： | 低 AC 线路/电压不足保护，灯故障保护，带自动重启功能 |
| 已供物品： | 板，CD |
| 产品目录页面： | 1383 (CN2011-ZH PDF) |
| 相关产品： | IRS2530DSPBF-ND - IC BALLAST CTRL DIM 600V 8-SOIC IRS2530DSTRPBFDKR-ND - IC DIMMING BALLAST CTRL 8-SOIC IRS2530DSTRPBFCT-ND - IC DIMMING BALLAST CTRL 8-SOIC IRS2530DSTRPBFTR-ND - IC DIMMING BALLAST CTRL 8-SOIC IRS2530DPBF-ND - IC CTRL BALLAST DIMMING 8-DIP |
In case the DC bus decreases too far and the lamp extinguishes, the VCC voltage will
go below VCCUV- and the ignition/preheat ramp will be reset to re-ignite the lamp
reliably.
Figure 5.2: Brown-out conditions: CH1 is the VCO voltage, CH2 is the VS voltage
Lamp Removal
When the lamp is removed, the IRS2530D uses the Crest Factor Over-current
Protection to enter the Fault mode and shut down. During lamp removal, the output
stage will transition to a series-LC configuration, and the frequency will move towards
resonance until the inductor saturates. The IRS2530D uses the VS-sensing circuitry
and the RDSon of the low-side half-bridge MOSFET to measure the MOSFET current
for detecting an over-current fault. Should the peak current exceed the average current
by a factor of 5.5 (CF>5.5) during the on-time of LO, the IRS2530D will enter Fault
Mode, where the half-bridge is off. Performing crest factor measurement provides a
relative current measurement that cancels temperature and/or tolerance variations of
the RDSon of the low-side half-bridge MOSFET.
Figure 5.3 shows the voltage across the lamp and the VS voltage when the lower
filament of the lamp is removed. Figure 5.4 shows these voltages when the upper
filament of the lamp is removed. In both cases, the IRS2530D will enter the Fault Mode
and shut down after detecting that the crest factor exceeds 5 during the on-time of LO.
Figure 5.5 shows the VS pin, inductor current, and voltage across lamp when the
inductor saturates and the ballast shuts down.
www.irf.com
RD0802
- 11 -
相关PDF资料 |
PDF描述 |
|---|---|
| IRPLHALO1E | KIT HALOGIN CONVERTER 100VA |
| IRPLHID2 | KIT DESIGN BALLAST IRS2573D |
| IRPLLNR2U | BALLAST 32W/T8 120V AC IR21571 |
| IRPLLNR4 | BALLAST UNIV INP FLUOR IR2166 |
| IRPLLNR5 | KIT BALLAST UNIV FLUOR 54W TL5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRPLHALO1E | 功能描述:电源管理IC开发工具 Halogen Cnvrtr 220/230VAC RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| IRPLHID1U | 制造商:International Rectifier 功能描述:600V .500A OTHER - Boxed Product (Development Kits) |
| IRPLHID2 | 功能描述:电源管理IC开发工具 HID Ballast for 70W Lamp Using IRS2573D RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| IRPLLED1 | 功能描述:BOARD EVALUATION FOR IRS2540PBF RoHS:是 类别:编程器，开发系统 >> 评估板 - LED 驱动器 系列:- 标准包装:1 系列:PowerWise® 电流 - 输出 / 通道:20mA 输出及类型:1，非隔离 输出电压:17V 特点:可调光 输入电压:2.7 ~ 5.5 V 已供物品:板 已用 IC / 零件:LM3508 相关产品:LM3508TLX-ND - IC LED DRVR WHT BCKLGT 9USMDLM3508TLDKR-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLCT-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLTR-ND - IC LED DRVR WHT BCKLGT 9MICROSMD |
| IRPLLED1A | 功能描述:电源管理IC开发工具 Hi-Vlt DC-DC Buck Cnvr HBLED Cur Cntrl RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
发布紧急采购，3分钟左右您将得到回复。