参数资料
| 型号： | IRPLHALO1E |
| 厂商： | International Rectifier |
| 文件页数： | 5/17页 |
| 文件大小： | 0K |
| 描述： | KIT HALOGIN CONVERTER 100VA |
| 标准包装： | 1 |
| 主要目的： | 照明，镇流器控制 |
| 已用 IC / 零件： | IR2161 |
| 已供物品： | 板，文档 |
| 相关产品： | IR2161STRPBF-ND - IC HALOGEN CONVERTER CTLR 8-SOIC IR2161PBF-ND - IC HALOGEN CONVERTER CTLR 8-DIP IR2161SPBF-ND - IC HALOGEN CONV CTRL 8-SOIC |
| 其它名称： | *IRPLHALO1E |
IRPLHALO1E
nected to two diodes, DCP1 and DCP2, feeds current back from the half bridge (VS) to VCC and
sustains the supply to the IC after it has been initially started. This arrangement avoids the neces-
sity for RS to supply all the current to VCC, which would require RS to dissipate around 2W in a
220VAC supplied system. This is undesirable as 2W power dissipated as heat within the convertor
adds significantly to the temperature rise. When selecting the value of RS, the trade-off is between
power dissipation and the ability of the convertor to start up when connected to a dimmer that is set
to a very low level. When a dimmer is set close to minimum and the supply to the convertor is
switched on, only a small voltage will appear on the DC bus and so RS must be small enough for
this to provide sufficient starting current for VCC. However the smaller the value of RS is, the more
power it will dissipate. It should be noted that the above considerations are important in a 220VAC
supplied system, but in a 120VAC supplied system a charge pump would not be necessary and RS
could supply VCC without dissipating significant power. Other considerations such as the high
primary current become more problematic in a 120VAC system.
An external 16V zener diode DZ has been added to avoid the need for the internal zener to dissi-
pate power (it should be rated at 1.3W). The resistor RD in series with CD is necessary if the
convertor is required to operate from a triac based (leading edge) phase cut dimmer. When the triac
fires at a point during the mains half-cycle the high dv/dt allows a large current to flow through this
path to rapidly charge CVCC to the maximum VCC voltage. In this way each line half cycle, the
system will receive a fast pull up on VCC when the traic in the dimmer is fired.
The external zener DZ will prevent possible damage to the IC by shunting excess current to COM.
Once the capacitor voltage on VCC reaches the start-up threshold the IC turns on and HO and LO
begin to oscillate. A bootstrap diode (DB) and supply capacitor (CB) comprise the supply voltage for
the high side driver circuitry. To guarantee that the high-side supply is charged up before the first
pulse on pin HO, the first pulse from the output drivers comes from the LO pin. During under voltage
lock-out mode, the high and low-side driver outputs HO and LO are both low.
Soft Start Operation
The soft start mode is defined as the state the IC is in at switch on of the system when the lamp
filament is cold. As with any type of filament lamp the Dichroic Halogen lamp has a positive tem-
perature coefficient of resistance such that the cold resistance (at switch on when the lamp has
been off long enough to cool) is much lower than the hot resistance when the lamp is running. This
normally results in a high inrush current occurring at switch on. Under worst-case conditions this
could potentially trigger the shut down circuit. To overcome this problem the IR2161 incorporates
the soft start function.
When the IC starts oscillating the frequency is initially very high (about 125kHz). This causes the
output voltage of the convertor to be lower since the HF transformer in the system has a fixed
primary leakage inductance that will present a higher impedance at higher frequency allowing less
www.irf.com
5
相关PDF资料 |
PDF描述 |
|---|---|
| IRPLHID2 | KIT DESIGN BALLAST IRS2573D |
| IRPLLNR2U | BALLAST 32W/T8 120V AC IR21571 |
| IRPLLNR4 | BALLAST UNIV INP FLUOR IR2166 |
| IRPLLNR5 | KIT BALLAST UNIV FLUOR 54W TL5 |
| IRPLLNR7 | KIT UNIV ELEC BALLAST FLUOR LAMP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRPLHID1U | 制造商:International Rectifier 功能描述:600V .500A OTHER - Boxed Product (Development Kits) |
| IRPLHID2 | 功能描述:电源管理IC开发工具 HID Ballast for 70W Lamp Using IRS2573D RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| IRPLLED1 | 功能描述:BOARD EVALUATION FOR IRS2540PBF RoHS:是 类别:编程器，开发系统 >> 评估板 - LED 驱动器 系列:- 标准包装:1 系列:PowerWise® 电流 - 输出 / 通道:20mA 输出及类型:1，非隔离 输出电压:17V 特点:可调光 输入电压:2.7 ~ 5.5 V 已供物品:板 已用 IC / 零件:LM3508 相关产品:LM3508TLX-ND - IC LED DRVR WHT BCKLGT 9USMDLM3508TLDKR-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLCT-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLTR-ND - IC LED DRVR WHT BCKLGT 9MICROSMD |
| IRPLLED1A | 功能描述:电源管理IC开发工具 Hi-Vlt DC-DC Buck Cnvr HBLED Cur Cntrl RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| IRPLLED5 | 制造商:International Rectifier 功能描述: |
发布紧急采购，3分钟左右您将得到回复。