- 您现在的位置：买卖IC网 > PDF目录1221 > IRPLLNR7 (International Rectifier)KIT UNIV ELEC BALLAST FLUOR LAMP PDF资料下载
参数资料
| 型号： | IRPLLNR7 |
| 厂商： | International Rectifier |
| 文件页数： | 10/18页 |
| 文件大小： | 0K |
| 描述： | KIT UNIV ELEC BALLAST FLUOR LAMP |
| 标准包装： | 1 |
| 主要目的： | 照明，镇流器控制 |
| 已用 IC / 零件： | IRS2166DPBF |
| 已供物品： | 板，文档 |
| 相关产品： | IRS2166DSTRPBF-ND - IC CTRL PFC/BALLAST 16-SOIC IRS2166DSPBF-ND - IC PFC/BALLAST/HALF BRDG 16-SOIC IRS2166DPBF-ND - IC PFC/BALLAST/HALF BRDG 16-DIP |
15. Preheat Mode
When the ballast reaches the end of the UVLO mode, the Preheat mode is entered. At this point the
ballast control oscillator of the IRS2166D has begun to operate and the half-bridge output is driving
the resonant load (lamp) circuit. There is an initial startup frequency that is much higher than the
steady state Preheat mode frequency that lasts for only a short duration. This is done to ensure that the
initial voltage appearing across the lamp at the startup of oscillation does not exceed the minimum
lamp ignition voltage. If, at the initiation of oscillation of the half-bridge, the voltage across the lamp is
large enough, a visible flash of the lamp occurs which should be avoided. This in effect is a cold strike
of the lamp, which could shorten the life of the lamp.
The ballast control section oscillator of the IRS2166D is similar to oscillators found in many popular
PWM voltage regulator ICs and consists of a timing capacitor and resistor connected to ground.
Resistors RT and RPH program a current that determines the ramp up time of capacitor CT. The
downward ramping time of CT is the deadtime between the switching off of the LO (HO) and the
switching on of the HO (LO) pins on the IRS2166D. The Preheat mode frequency of oscillation is
determined from the parallel resistance of RT and RPH. It is selected such that the voltage appearing
across the lamp is below the minimum lamp ignition voltage while supplying enough current to
preheat the lamp filaments to the correct emission temperature within the Preheat mode period. The
preheating of the lamp filaments is performed with a constant voltage during the Preheat mode. The
waveform in Figure 2 shows the lamp filament current while Figure 3 shows lamp filament voltage
during the normal Startup, Preheat, and Ignition Ramp modes of the ballast.
Figure 2: Lamp filament current during Preheat and Ignition Ramp (500mA / div)
(Crossed lamps)
www.irf.com
RD-0609
10
相关PDF资料 |
PDF描述 |
|---|---|
| IRPLMB1E | KIT DESIGN BALLAST 220VAC |
| IS-418-TR1509-12 | POWER SUPPLY 240VAC FOR DEV KIT |
| IS-DEM KIT-2 | SMARTDISPLAY DEMONSTRATION KIT 2 |
| IS-DEV KIT-1 | SMARTSWITCH DEVELOPMENT KIT 1 |
| IS-DEV KIT-2 | SMARTSWITCH DEVELOPMENT KIT 2 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRPLMB1E | 功能描述:KIT DESIGN BALLAST 220VAC RoHS:否 类别:编程器，开发系统 >> 过时/停产零件编号 系列:- 标准包装:1 系列:- 类型:MCU 适用于相关产品:Freescale MC68HC908LJ/LK（80-QFP ZIF 插口） 所含物品:面板、缆线、软件、数据表和用户手册 其它名称:520-1035 |
| IR-POST-B | 制造商:Knoll Systems 功能描述:Single Target IR Repeater Kit with Black Postage Stamp Receiver 制造商:KNOLL SYSTEMS 功能描述:IR REPEATER COMPLETE KIT BLACK POSTAGE STAMP RECEIVER |
| IRPP3624-05A | 制造商:International Rectifier 功能描述:5 AMP SINGLE PHASE SYNCHRONOUS BUCK POWER+ CHIPSET REFERENCE - Bulk 制造商:International Rectifier 功能描述:DEMO BOARD KIT FOR 3624SPBF 5A 制造商:IR 功能描述:Single Phase 5 A Synchronous Buck Reference Design |
| IRPP3624-12A | 功能描述:电源管理IC开发工具 12 AMP 1 PHASE SYNC BUCK PWR+ RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| IRPP3637-06A | 功能描述:电源管理IC开发工具 6 AMP 1 PHASE SYNC 5V IN 1.25 OUTPUT RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
发布紧急采购，3分钟左右您将得到回复。