- 您现在的位置：买卖IC网 > PDF目录15499 > IRU3038CF (International Rectifier)IC REG CTRLR BUCK PWM VM TSSOP14 PDF资料下载
参数资料
| 型号： | IRU3038CF |
| 厂商： | International Rectifier |
| 文件页数： | 6/18页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM TSSOP14 |
| 标准包装： | 94 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 440kHz |
| 占空比： | 95% |
| 电源电压： | 5 V ~ 12 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 1384 (CN2011-ZH PDF) |
| 其它名称： | *IRU3038CF |
IRU3038
D I O
P COND (Upper Switch) = I LOAD 3 R DS(ON) 3 D 3 q
P COND (Lower Switch) = I LOAD 3 R DS(ON) 3 (1 - D) 3 q
Output Capacitor Selection
The criteria to select the output capacitor is normally
based on the value of the Effective Series Resistance
(ESR). In general, the output capacitor must have low
enough ESR to meet output ripple and load transient
requirements, yet have high enough ESR to satisfy sta-
bility requirements. The ESR of the output capacitor is
calculated by the following relationship:
D V O
ESR [ ---(4)
Where:
D V O = Output Voltage Ripple
D I O = Output Current
D V O =100mV and D I O =4A
This results to: ESR=25m V
The Sanyo TPC series, Poscap capacitor is a good choice.
The 6TPC150M 150 m F, 6.3V has an ESR 40m V . Se-
lecting two of these capacitors in parallel, results to an
ESR of ? 20m V which achieves our low ESR goal.
The capacitor value must be high enough to absorb the
inductor's ripple current. The larger the value of capaci-
tor, the lower will be the output ripple voltage.
Inductor Selection
The inductor is selected based on output power, operat-
ing frequency and efficiency requirements. Low inductor
value causes large ripple current, resulting in the smaller
size, but poor efficiency and high output noise. Gener-
ally, the selection of inductor value can be reduced to
desired maximum ripple current in the inductor ( ? i). The
optimum point is usually found between 20% and 50%
If D i = 30%(I O ), then the output inductor will be:
L = 2.6 m H
The Coilcraft DO5022HC series provides a range of in-
ductors in different values, low profile suitable for large
currents, 3.3 m H, 10A is a good choice for this applica-
tion. This will result to a ripple approximately 26.5% of
output current.
Power MOSFET Selection
The IRU3038 uses two N-Channel MOSFETs. The se-
lections criteria to meet power transfer requirements is
based on maximum drain-source voltage (V DSS ), gate-
source drive voltage (V GS ), maximum output current, On-
resistance R DS(ON) and thermal management.
The MOSFET must have a maximum operating voltage
(V DSS ) exceeding the maximum input voltage (V IN ).
The gate drive requirement is almost the same for both
MOSFETs. Logic-level transistor can be used and cau-
tion should be taken with devices at very low V GS to pre-
vent undesired turn-on of the complementary MOSFET,
which results a shoot-through current.
The total power dissipation for MOSFETs includes con-
duction and switching losses. For the Buck converter,
the average inductor current is equal to the DC load cur-
rent. The conduction loss is defined as:
2
2
ripple of the output current.
q = R DS(ON) Temperature Dependency
For the buck converter, the inductor value for desired
operating ripple current can be determined using the fol-
lowing relation:
The R DS(ON) temperature dependency should be consid-
ered for the worst case operation. This is typically given
D t
L = (V IN - V OUT ) 3
V IN
D i
V IN - V OUT = L 3 ; D t = D 3
V OUT
V IN 3D i 3 f S
Where:
V IN = Maximum Input Voltage
V OUT = Output Voltage
1
f S
V OUT
;D=
---(5)
in the MOSFET data sheet. Ensure that the conduction
losses and switching losses do not exceed the package
ratings or violate the overall thermal budget.
Choose IRF7460 for both control MOSFET and synchro-
nous MOSFET. This device provides low on-resistance
in a compact SOIC 8-Pin package.
? i = Inductor Ripple Current
f S = Switching Frequency
? t = Turn On Time
D = Duty Cycle
6
www.irf.com
Rev. 2.0
09/12/02
相关PDF资料 |
PDF描述 |
|---|---|
| HCTR-442 | INDUCTOR 4.2UH 9.14A SMD |
| 4307-336K | COIL RF 33000UH MOLDED SHIELDED |
| 4307-276K | COIL RF 27000UH MOLDED SHIELDED |
| 4307-226K | COIL RF 22000UH MOLDED SHIELDED |
| 4307-186K | COIL RF 18000UH MOLDED SHIELDED |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IRU3038CFTRPBF | 制造商:International Rectifier 功能描述:Voltage Mode PWM Controller 500mA 14-Pin TSSOP T/R |
| IRU3038CS | 功能描述:IC REG CTRLR BUCK PWM VM 14-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| IRU3038CSTR | 功能描述:IC REG CTRLR BUCK PWM VM 14-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| IRU3039 | 制造商:IRF 制造商全称:International Rectifier 功能描述:SYNCHRONOUS PWM CONTROLLER WITH OVER CURRENT PROTECTION |
| IRU3039CH | 制造商:IRF 制造商全称:International Rectifier 功能描述:SYNCHRONOUS PWM CONTROLLER WITH OVER CURRENT PROTECTION |
发布紧急采购，3分钟左右您将得到回复。