参数资料
型号: ISD5108EYI
厂商: WINBOND ELECTRONICS CORP
元件分类: 音频合成
英文描述: 480 SEC, SPEECH SYNTHESIZER WITH RCDG, PDSO28
封装: 8 X 13.4 MM, LEAD FREE, PLASTIC, TSOP1-28
文件页数: 66/89页
文件大小: 600K
代理商: ISD5108EYI
ISD5100 SERIES
Publication Release Date: May 16, 2007
- 69 -
Revision 1.4
Conditions
1.
Typical values: TA = 25°C and Vcc = 3.0V.
2.
All min/max limits are guaranteed by Winbond via electrical testing or characterization. Not all
specifications are 100 percent tested.
3.
Low-frequency cut off depends upon the value of external capacitors (see Pin Descriptions).
4.
Differential input mode. Nominal differential input is 208 mV p-p. (0TLP)
5.
Sampling frequency can vary as much as –6/+4 percent over the industrial temperature and voltage
ranges. For greater stability, an external clock can be utilized (see Pin Descriptions).
6.
Playback and Record Duration can vary as much as –6/+4 percent over the industrial temperature
and voltage ranges. For greater stability, an external clock can be utilized (See Pin Descriptions).
7.
Filter specification applies to the low pass filter.
8.
For optimal signal quality, this maximum limit is recommended.
9.
When a record command is sent, TRAC = TRAC + TRACL on the first page addressed.
10.
The maximum signal level at any input is defined as 3.17 dB higher than the reference transmission
level point. (0TLP) This is the point where signal clipping may begin.
11.
Measured at 0TLP point for each gain setting. See the ANA IN table and AUX IN table on pages 54
and 55 respectively.
12.
0TLP is the reference test level through inputs and outputs. See the ANA IN table and AUX IN table
on pages 54 and 55 respectively.
13.
Referenced to 0TLP input at 1 kHz, measured over 300 to 3,400 Hz bandwidth.
14.
For die, only typical values are applicable.
10.4. CHARACTERISTICS OF THE I
2C SERIAL INTERFACE
The I
2C interface is for bi-directional, two-line communication between different ICs or modules. The
two lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be connected to a
positive supply via a pull-up resistor. Data transfer may be initiated only when the interface bus is not
busy.
Bit transfer
One data bit is transferred during each clock pulse. The data on the SDA line must remain stable
during the HIGH period of the clock pulse, as changes in the data line at this time will be interpreted
as a control signal.
相关PDF资料
PDF描述
ISD5108EY 480 SEC, SPEECH SYNTHESIZER WITH RCDG, PDSO28
ISD5108SYI 480 SEC, SPEECH SYNTHESIZER WITH RCDG, PDSO28
ISD5108SY 480 SEC, SPEECH SYNTHESIZER WITH RCDG, PDSO28
ISD5108X 480 SEC, SPEECH SYNTHESIZER WITH RCDG, UUC27
ISD5116EYI 960 SEC, SPEECH SYNTHESIZER WITH RCDG, PDSO28
相关代理商/技术参数
参数描述
ISD5108EYIR 功能描述:IC VOICE REC/PLAY 4-8MN 28-TSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 语音录制和重放 系列:ISD5100 标准包装:14 系列:- 接口:串行 滤波器通频带:1.7kHz 持续时间:8 ~ 32 秒 安装类型:通孔 封装/外壳:28-DIP(0.300",7.62mm) 供应商设备封装:28-PDIP 其它名称:90-21300+000
ISD5108EYR 功能描述:IC VOICE REC/PLAY 4-8MN 28-TSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 语音录制和重放 系列:ISD5100 标准包装:14 系列:- 接口:串行 滤波器通频带:1.7kHz 持续时间:8 ~ 32 秒 安装类型:通孔 封装/外壳:28-DIP(0.300",7.62mm) 供应商设备封装:28-PDIP 其它名称:90-21300+000
ISD5108SY 功能描述:IC VOICE REC/PLAY 4-8MN 28-SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 语音录制和重放 系列:ISD5100 标准包装:14 系列:- 接口:串行 滤波器通频带:1.7kHz 持续时间:8 ~ 32 秒 安装类型:通孔 封装/外壳:28-DIP(0.300",7.62mm) 供应商设备封装:28-PDIP 其它名称:90-21300+000
ISD5108SYI 功能描述:IC VOICE REC/PLAY 4-8MN 28-SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 语音录制和重放 系列:ISD5100 标准包装:14 系列:- 接口:串行 滤波器通频带:1.7kHz 持续时间:8 ~ 32 秒 安装类型:通孔 封装/外壳:28-DIP(0.300",7.62mm) 供应商设备封装:28-PDIP 其它名称:90-21300+000
ISD5108SYIR 功能描述:IC VOICE REC/PLAY 4-8MN 28-SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 语音录制和重放 系列:ISD5100 标准包装:14 系列:- 接口:串行 滤波器通频带:1.7kHz 持续时间:8 ~ 32 秒 安装类型:通孔 封装/外壳:28-DIP(0.300",7.62mm) 供应商设备封装:28-PDIP 其它名称:90-21300+000