参数资料
| 型号： | ISL12029IVZ |
| 厂商： | Intersil |
| 文件页数： | 10/29页 |
| 文件大小： | 0K |
| 描述： | IC RTC/CALENDAR EEPROM 14-TSSOP |
| 标准包装： | 960 |
| 类型： | 时钟/日历 |
| 特点： | 警报器，闰年，监控器，监视计时器 |
| 时间格式： | HH:MM:SS（12/24 小时） |
| 数据格式： | YY-MM-DD-dd |
| 接口： | I²C，2 线串口 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 电压 - 电源，电池： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 14-TSSOP |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
18
FN6206.10
December 16, 2010
operations. See “I2C Communications During Battery
In battery mode, the RESET signal output is asserted LOW
when the VDD voltage supply has dipped below the VRESET
threshold. The RESET signal output will not return HIGH
until the device is back to VDD mode even the VDD voltage is
above VRESET threshold.
Serial Communication
The device supports the I2C bidirectional serial bus protocol.
CLOCK AND DATA
Data states on the SDA line can change only during SCL
LOW. SDA state changes during SCL HIGH are reserved for
indicating start and stop conditions (see Figure 16).
START CONDITION
All commands are preceded by the start condition, which is a
HIGH to LOW transition of SDA when SCL is HIGH. The
device continuously monitors the SDA and SCL lines for the
start condition and will not respond to any command until
this condition has been met (see Figure 17).
STOP CONDITION
All communications must be terminated by a stop condition,
which is a LOW to HIGH transition of SDA when SCL is
HIGH. The stop condition is also used to place the device
into the Standby power mode after a read sequence. A stop
condition can only be issued after the transmitting device
has released the bus (see Figure 17).
ACKNOWLEDGE
Acknowledge is a software convention used to indicate
successful data transfer. The transmitting device, either
master or slave, will release the bus after transmitting 8-bits.
During the ninth clock cycle, the receiver will pull the SDA
line LOW to acknowledge that it received the 8-bits of data
(refer to Figure 18).
The device will respond with an acknowledge after recognition
of a start condition and if the correct Device Identifier and Select
bits are contained in the Slave Address Byte. If a write
operation is selected, the device will respond with an
acknowledge after the receipt of each subsequent 8-bit word.
The device will not acknowledge if the slave address byte is
incorrect.
SCL
SDA
DATA STABLE
DATA CHANGE
DATA STABLE
FIGURE 16. VALID DATA CHANGES ON THE SDA BUS
SCL
SDA
START
STOP
FIGURE 17. VALID START AND STOP CONDITIONS
SCL FROM
MASTER
DATA OUTPUT
FROM TRANSMITTER
DATA OUTPUT
FROM RECEIVER
8
1
9
START
ACKNOWLEDGE
FIGURE 18. ACKNOWLEDGE RESPONSE FROM RECEIVER
ISL12029, ISL12029A
相关PDF资料 |
PDF描述 |
|---|---|
| ISL12030IBZ | IC RTC/CALENDAR EEPROM 8-SOIC |
| ISL12032IVZ | IC RTC LP BATT BACK SRAM 14TSSOP |
| ISL12057IUZ | IC RTC/CALENDAR I2C 8-MSOP |
| ISL12058IUZ | IC RTC/CALENDAR I2C-BUS 8-MSOP |
| ISL12059IBZ | IC RTC/CALENDAR I2C-BUS 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL12029IVZ-T | 功能描述:实时时钟 REAL TIME CLKRTC W/ EPROM IN 14LD T RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| ISL12030 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Low Power RTC with 50/60 Cycle AC Input, Alarms and Daylight Savings Correction |
| ISL12030IBZ | 功能描述:实时时钟 REAL TIME CLK W/ EEPROM 8LD RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| ISL12030IBZ-T | 功能描述:实时时钟 REAL TIME CLK W/ EEPROM 8LD RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| ISL12032 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Low Power RTC with Battery Backed SRAM and 50/60 Cycle AC Input and Xtal Back-up |
发布紧急采购，3分钟左右您将得到回复。