参数资料
型号: ISL23325TFRUZ-TK
厂商: Intersil
文件页数: 5/20页
文件大小: 0K
描述: IC DGTL POT 256POS 100K 16UTQFN
标准包装: 1,000
系列: XDCP™
接片: 256
电阻(欧姆): 100k
电路数: 2
温度系数: 标准值 45 ppm/°C
存储器类型: 易失
接口: I²C,2 线串口
电源电压: 1.2 V ~ 5.5 V,1.7 V ~ 5.5 V
工作温度: -40°C ~ 125°C
安装类型: *
封装/外壳: *
供应商设备封装: *
包装: *
ISL23325
13
FN7870.0
June 21, 2011
Functional Pin Descriptions
Potentiometers Pins
RHI AND RLI
The high (RHi, i = 0, 1) and low (RLi, i = 0,1) terminals of the
ISL23325 are equivalent to the fixed terminals of a mechanical
potentiometer. RHi and RLi are referenced to the relative position
of the wiper and not the voltage potential on the terminals. With
WRi set to 255 decimal, the wiper will be closest to RHi, and with
the WR set to 0, the wiper is closest to RLi.
RWI
RWi (i = 0,1) is the wiper terminal, and it is equivalent to the
movable terminal of a mechanical potentiometer. The position of
the wiper within the array is determined by the WRi register.
VCC
Power terminal for the potentiometer section analog power
source. Can be any value needed to support voltage range of DCP
pins, from 1.7V to 5.5V, independent of the VLOGIC voltage.
Bus Interface Pins
SERIAL DATA INPUT/OUTPUT (SDA)
The SDA is a bi-directional serial data input/output pin for I2C
interface. It receives device address, wiper address and data
from an I2C external master device at the rising edge of the serial
clock SCL, and it shifts out data after each falling edge of the
serial clock.
SDA requires an external pull-up resistor, since it is an open drain
input/output.
FIGURE 21. WIPER LARGE SIGNAL SETTLING TIME
FIGURE 22. POWER-ON START-UP IN VOLTAGE DIVIDER MODE
FIGURE 23. 10k -3dB CUT OFF FREQUENCY
FIGURE 24. STANDBY CURRENT vs TEMPERATURE
Typical Performance Curves (Continued)
9TH CLOCK OF THE
DATA BYTE (ACK)
1V/DIV
0.2s/DIV
SCL
WIPER
0.5V/DIV
20s/DIV
VCC
WIPER
0.5V/DIV, 0.2s/DIV
-3dB FREQUENCY = 1.4MHz AT MIDDLE TAP
CH1: RH TERMINAL
CH2: RW TERMINAL
0
0.2
0.4
0.6
0.8
1.0
1.8
-40
-15
10
35
60
85
110
S
T
A
N
D
B
Y
C
U
R
E
N
T
I C
C
(
A
)
TEMPERATURE (°C)
VCC = 5.5V, VLOGIC = 5.5V
VCC = 1.7V, VLOGIC = 1.2V
1.6
1.4
1.2
相关PDF资料
PDF描述
LB15RKW01-05-JC SWITCH PUSHBUTTON SPDT 3A 125V
LB15RKW01-12-CJ SWITCH PUSHBUTTON SPDT 3A 125V
YB16WCKW01-5F-JF SWITCH PUSHBUTTON SPDT 3A 125V
ISL28134IBZ-T7 IC OPAMP CHOPPER RR 3.5MHZ 8SOIC
YB16WCKW01-5D-JD SWITCH PUSHBUTTON SPDT 3A 125V
相关代理商/技术参数
参数描述
ISL23325TFVZ 功能描述:数字电位计 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel
ISL23325TFVZ-T7A 功能描述:数字电位计 IC 256 TAPVOLATILE I2C DUAL FL RNG IND 14LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel
ISL23325TFVZ-TK 功能描述:数字电位计 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel
ISL23325UFRUZ-T7A 功能描述:数字电位计 IC 256 TAPVOLATILE I2C DUAL FL RNG IND 16LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel
ISL23325UFRUZ-TK 功能描述:数字电位计 IC 256 TAP VOLATILE I2C DL FL RNG DCP 14LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel