- 您现在的位置：买卖IC网 > PDF目录17645 > ISL23445WFRZ (Intersil)IC DGTL POT 256POS 10K 20TSSOP PDF资料下载
参数资料
| 型号： | ISL23445WFRZ |
| 厂商： | Intersil |
| 文件页数： | 9/20页 |
| 文件大小： | 0K |
| 描述： | IC DGTL POT 256POS 10K 20TSSOP |
| 产品培训模块： | Solutions for Industrial Control Applications |
| 标准包装： | 75 |
| 系列： | XDCP™ |
| 接片： | 256 |
| 电阻（欧姆）： | 10k |
| 电路数： | 4 |
| 温度系数： | 标准值 125 ppm/°C |
| 存储器类型： | 易失 |
| 接口： | 4 线 SPI（芯片选择） |
| 电源电压： | 1.2 V ~ 5.5 V，1.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | * |
| 封装/外壳： | * |
| 供应商设备封装： | * |
| 包装： | * |
ISL23445
17
FN7874.0
June 21, 2011
transition from a very low impedance “make” to a much higher
impedance “break” within a short period of time (<1s). There
are several code transitions such as 0Fh to 10h, 1Fh to 20h,...,
EFh to FFh, which have higher transient glitch. Note, that all
switching transients will settle well within the settling time as
stated in the datasheet. A small capacitor can be added
externally to reduce the amplitude of these voltage transients,
but that will also reduce the useful bandwidth of the circuit, thus,
this may not be a good solution for some applications. It may be
a good idea, in this case, to use fast amplifiers in a signal chain
for fast recovery.
VLOGIC Requirements
It is recommended to keep VLOGIC powered all the time during
normal operation. In a case where turning VLOGIC OFF is
necessary, it is recommended to ground the VLOGIC pin of the
ISL23445. Grounding the VLOGIC pin or both VLOGIC and VCC does
not affect other devices on the same bus. It is good practice to put
a 1F capacitor in parallel with 0.1F decoupling capacitor close to
the VLOGIC pin.
VCC Requirements and Placement
It is recommended to put a 1F capacitor in parallel with 0.1F
decoupling capacitor close to the VCC pin.
CS
SCK
MOSI
MISO
CS
SCK
SDI
SDO
CS
SCK
SDI
SDO
CS
SCK
SDI
SDO
CS
SCK
SDI
SDO
C
DCP0
DCP1
DCP2
DCP(N-1)
FIGURE 29. DAISY CHAIN CONFIGURATION
N DCP IN A CHAIN
CS
SCK
SDI
SDO 0
WR
D C P2
WR
D C P1
WR
D C P0
WR
D C P1
SDO 1
WR
D C P2
SDO 2
WR
D C P2
FIGURE 30. DAISY CHAIN WRITE SEQUENCE OF N = 3 DCP
16 CLKLS
16 CLKS
FIGURE 31. TWO BYTE READ INSTRUCTION
CS
SCK
SDI
SDO
INSTRUCTION
ADDR
DATA IN
DATA OUT
1
2
10
11
12
13
14
15
16
345
67
8
9
相关PDF资料 |
PDF描述 |
|---|---|
| YB15WCKG03-BB | SWITCH PUSH SPDT 0.4VA 28V |
| YB15WSKG01-BB | SWITCH PUSH SPDT 0.4VA 28V |
| YB15WCKG01-GB | SWITCH PUSH SPDT 0.4VA 28V |
| ISL23445UFRZ | IC DGTL POT 256POS 50K 20QFN |
| B32652A6333J | CAP FILM 0.033UF 630VDC RADIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL23445WFRZ-T7A | 功能描述:数字电位计 IC 256 TAPVOLATILE SPI QUAD FL RNG IND 20LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL23445WFRZ-TK | 功能描述:数字电位计 IC 256 TAP VOLATILE SPI QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL23445WFVZ | 功能描述:数字电位计 IC 256 TAP VOLATILE SPI QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL23445WFVZ-T7A | 功能描述:数字电位计 IC 256 TAPVOLATILE SPI QUAD FL RNG IND 20LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
| ISL23445WFVZ-TK | 功能描述:数字电位计 IC 256 TAP VOLATILE SPI QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 电阻:200 Ohms 温度系数:35 PPM / C 容差:25 % POT 数量:Dual 每 POT 分接头:256 弧刷存储器:Volatile 缓冲刷: 数字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作电源电压:1.7 V to 5.5 V 电源电流:27 uA 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:TQFN-16 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。