- 您现在的位置：买卖IC网 > PDF目录17644 > ISL28208FBZ (Intersil)IC OPAMP PREC RR 1.2MHZ DL 8SOIC PDF资料下载
参数资料
| 型号： | ISL28208FBZ |
| 厂商： | Intersil |
| 文件页数： | 14/34页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP PREC RR 1.2MHZ DL 8SOIC |
| 标准包装： | 97 |
| 放大器类型： | 通用 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 0.45 V/µs |
| 增益带宽积： | 1.2MHz |
| 电流 - 输入偏压： | 13nA |
| 电压 - 输入偏移： | 25µV |
| 电流 - 电源： | 185µA |
| 电流 - 输出 / 通道： | 30mA |
| 电压 - 电源，单路/双路(±)： | 3 V ~ 40 V，±1.5 V ~ 20 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | * |
| 封装/外壳： | * |
| 供应商设备封装： | * |
| 包装： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
ISL28108, ISL28208, ISL28408
FN6935.5
March 4, 2014
Applications Information
Functional Description
The ISL28108, ISL28208, and ISL28408 are single, dual and
quad, 1.2MHz, single supply rail-to-rail output amplifiers with a
common mode input voltage range extending to a range of 0.5V
below the V- rail. Their input stages are optimized for precision
sensing of ground referenced signals in low voltage, single supply
applications. The input stage has the capability of handling large
input differential voltages without phase inversion making them
suitable for high voltage comparator applications. Their bipolar
design features high open loop gain and excellent DC input and
output temperature stability. These op amps feature low quiescent
current of 165A, and a maximum temperature drift ranging from
1.1V/°C for the ISL28208 and ISL28408 in the SOIC package to
1.4V/°C for the ISL28208 in the TDFN package and the ISL28408
fabricated in a new precision 40V complementary bipolar DI process
and immune from latch-up.
Operating Voltage Range
The devices are designed to operate over the 3V (±1.5V) to
40V (±20V) range and are fully characterized at ±5V and ±15V. Both
DC and AC performance remain virtually unchanged over the ±5V
to ±15V operating voltage range. Parameter variation with
operating voltage is shown in the “Typical Performance Curves”
beginning on page 10.
Input Stage Performance
The PNP input stage has a common mode input range extending
amplifier performance is guaranteed down to ground (V-) over the
-40°C to +125°C temperature range. For common mode voltages
down to -0.5V the amplifiers are fully functional, but performance
degrades slightly over the full temperature range. This feature
provides excellent CMRR, AC performance and DC accuracy when
amplifying low level ground referenced signals.
The input stage has a maximum input differential voltage equal
to a diode drop greater than the supply voltage (max 42V) and
does not contain the back-to-back input protection diodes found
on many similar amplifiers. This feature enables the device to
function as a precision comparator by maintaining very high
input impedance for high voltage differential input comparator
voltages. The high differential input impedance also enables the
device to operate reliably in large signal pulse applications
without the need for anti-parallel clamp diodes required on
MOSFET and most bipolar input stage op amps. Thus, input
signal distortion caused by nonlinear clamps under high slew
rate conditions are avoided.
In applications where one or both amplifier input terminals are at
risk of exposure to voltages beyond the supply rails, current
limiting resistors may be needed at each input terminal
supply ESD diodes to 20mA.
Output Drive Capability
The bipolar rail-to-rail output stage features low saturation levels
that enable an output voltage swing to less than 10mV when the
total output load (including feedback resistance) is held below
achieved by using feedback resistor values >300k. The low input
bias and offset currents (-43nA and ±3nA +25°C max
respectively) minimize DC offset errors at these high resistance
values. For example, a balanced 4 resistor gain circuit (Figure 65)
with 1M feedback resistors (RF, RG) generates a worst case
input offset error of only ±3mV. Furthermore, the low noise
current reduces the added noise associated with high feedback
resistance.
The output stage is internally current limited. Output current limit
can withstand a short circuit to either rail as long as the power
dissipation limits are not exceeded. This applies to only one
amplifier at a time for the dual op amp. Continuous operation
under these conditions may degrade long-term reliability.
The amplifiers perform well driving capacitive loads
configuration provides the highest bandwidth, but is also the
most sensitive to ringing produced by load capacitance found in
BNC cables. Unity gain overshoot is limited to 30% at
capacitance values to 0.33nF. At gains of 10 and higher, the
device is capable of driving more than 10nF without significant
overshoot.
Output Phase Reversal
Output phase reversal is a change of polarity in the amplifier
transfer function when the input voltage exceeds the supply
voltage. These devices are immune to output phase reversal, out
FIGURE 65. INPUT ESD DIODE CURRENT LIMITING
-
+
RIN-
RL
VIN-
V+
V-
RIN+
VIN+
RF
RG
相关PDF资料 |
PDF描述 |
|---|---|
| ISL9443IRZ-T | IC REG CTRLR BUCK PWM CM 32-QFN |
| FOXSDLF/221-20 | CRYSTAL 22.1184 MHZ 20PF SMD |
| ZL2004ALNFT1 | IC REG CTRLR BUCK SYNC ADJ 32QFN |
| SBG3030CT-T | DIODE SCHOTTKY CC 30V 30A D2-PAK |
| FOXSDLF/115-20 | CRYSTAL 11.0592 MHZ 20PF SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL28208FBZ-T13 | 功能描述:IC OPAMP PREC RR 1.2MHZ DL 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:2.1 V/µs 增益带宽积:3MHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:2000µV 电流 - 电源:750µA 电流 - 输出 / 通道:16mA 电压 - 电源，单路/双路(±):2.7 V ~ 16 V，±1.35 V ~ 8 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:剪切带 (CT) 其它名称:296-10529-1 |
| ISL28208FBZ-T7 | 功能描述:IC OPAMP PREC RR 1.2MHZ DL 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:2.1 V/µs 增益带宽积:3MHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:2000µV 电流 - 电源:750µA 电流 - 输出 / 通道:16mA 电压 - 电源，单路/双路(±):2.7 V ~ 16 V，±1.35 V ~ 8 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:剪切带 (CT) 其它名称:296-10529-1 |
| ISL28208FBZ-T7A | 功能描述:精密放大器 ISL28208FBZ 40V LW N RAIL OUT SNG SUPP RoHS:否 制造商:Maxim Integrated 每芯片的通道数量: 输入补偿电压:0.25 mV at +/- 5 V 输入电压范围（最大值）: 安装风格: 封装 / 箱体:SOIC-8 Narrow 封装:Tube |
| ISL28208FRTZ | 功能描述:IC OPAMP GP R-R 1.2MHZ LP 8TDFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:75 系列:MicroAmplifier™ 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:0.03 V/µs 增益带宽积:100kHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:60µV 电流 - 电源:20µA 电流 - 输出 / 通道:5mA 电压 - 电源，单路/双路(±):2.3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:管件 |
| ISL28208FRTZ-T13 | 功能描述:IC OPAMP GP R-R 1.2MHZ LP 8TDFN RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:75 系列:MicroAmplifier™ 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:0.03 V/µs 增益带宽积:100kHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:60µV 电流 - 电源:20µA 电流 - 输出 / 通道:5mA 电压 - 电源，单路/双路(±):2.3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。