- 您现在的位置：买卖IC网 > Datasheet目录450 > ISL29120IROZ-T7 (Intersil)IC SENSOR LIGHT-DGTL I2C 6-ODFN Datasheet资料下载
参数资料
| 型号： | ISL29120IROZ-T7 |
| 厂商： | Intersil |
| 文件页数： | 4/8页 |
| 文件大小： | 0K |
| 描述： | IC SENSOR LIGHT-DGTL I2C 6-ODFN |
| 标准包装： | 1,000 |
| 系列： | * |
ISL29120
Principles of Operation
Photodiodes and ADC
The ISL29120 contains three photodiode arrays, which convert
light into current. The spectral response for red, green and blue
color ambient intensity sensing is as shown in Figure 2. After
light is converted to current during the light to signal process, the
current output is converted to a digital count by an on-chip
Analog-to-Digital Converter (ADC). The ADC converter resolution
is selectable from 4, 8, 12 or 16 bits. The ADC conversion time is
inversely proportional to the ADC resolution.
The ADC converter uses an integrating architecture. This
conversion method is ideal for converting small signals in the
presence of a periodic noise. A 100ms integration time (16-bit
mode) for instance, rejects 50Hz and 60Hz power line as well as
florescent flicker noise.
The ADC integration time is determined by an internal oscillator
and the n-bit (n = 4, 8, 12, 16) counter inside the ADC. A good
balancing act of integration time and resolution depends on the
application for optimum system performance.
The ADC provides two programmable ranges to dynamically
accommodate different lighting conditions. For dim conditions,
the ADC can be configured at its high sensitivity (low optical)
range. For bright conditions, the ADC can be configured at its low
sensitivity (higher optical) range.
Note that the effective optical sensitivity of the ISL29120 in
terms of counts/ μW/cm 2 is directly proportional to the ADC
integration time.
I 2 C Interface
There are eight 8-bit registers inside the ISL29120 for
configuration, control and status indication. The two command
registers at address 0x00 and 0x01 define the operation of the
device and provide status of the interrupt events. Two 8-bit read
only registers at address 0x02 and 0x03 are for the ADC output.
These registers contain the results of the latest A/D conversion.
Registers 0x04 and 0x05 contain the ‘low threshold’ value and
registers 0x06 and 0x07 store the ‘high threshold’ value for
interrupt generation.
The ISL29120’s I 2 C interface slave address is internally hard-wired
as 1000110x, where x is R (read) or W (write) bit.
Figure 4 shows a sample one-byte read. Figure 5 shows a sample
one-byte write. The I 2 C bus master always drives the SCL (clock)
line, while either the master or the slave can drive the SDA (data)
line. Figure 5 shows a sample write. Every I 2 C transaction begins
with the master asserting a start condition (SDA falling while SCL
remains high). The following byte is driven by the master, and
includes the slave address and read/write bit. The receiving device
is responsible for pulling SDA low during the acknowledgement
period. Every I 2 C transaction ends with the master asserting a stop
condition (SDA rising while SCL remains high).
For more information about the I 2 C standard, consult the
Philips? I 2 C specification documents.
I 2 C DATA
START
DEVICE ADDRESS
W A
REGISTER ADDRESS
STOP START
DEVICE ADDRESS
A
DATA BYTE0
I 2 C SDA
IN
A6 A5 A4 A3 A2 A1 A0 W A R7 R6 R5 R4 R3 R2 R1 R0 A
A6 A5 A4 A3 A2 A1 A0 W
A
SDA DRIVEN BY ISL29120
I 2 C SDA
OUT
SDA DRIVEN BY MASTER
A
SDA DRIVEN BY MASTER
A
SDA DRIVEN BY MASTER
A D7 D6 D5 D4 D3 D2 D1 D0
I 2 C CLK
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
FIGURE 4. I 2 C READ TIMING DIAGRAM SAMPLE
I 2 C DATA
START
DEVICE ADDRESS
W
A
REGISTER ADDRESS
A
FUNCTIONS
A
STOP
I 2 C SDA IN
A6 A5 A4 A3 A2 A1 A0
W
A
R7 R6 R5 R4 R3 R2 R1 R0
A
B7 B6 B5 B4 B3 B2 B1 B0
A
I 2 C SDA OUT
SDA DRIVEN BY MASTER
A
SDA DRIVEN BY MASTER
A
SDA DRIVEN BY MASTER
A
I 2 C CLK IN
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
FIGURE 5. I 2 C WRITE TIMING DIAGRAM SAMPLE
4
FN8314.0
May 29, 2012
相关PDF资料 |
PDF描述 |
|---|---|
| ISL5216EVAL1 | EVALUATION BOARD FOR ISL5216KI |
| ISL5217EVAL1 | EVALUATION BOARD FOR ISL5217KI |
| ISL5239EVAL1 | EVALUATION BOARD FOR ISL5239 |
| ISL5239KIZ | IC LINEARIZER PRE-DISTORT 196BGA |
| ISL5416EVAL1 | EVALUATION PLATFORM FOR ISL5416 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL29125IROZ-T7 | 制造商:Intersil Corporation 功能描述:ISL29125IROZ PB-FREE RGB SENSOR WITH LITEFILM IR CUT & ORGAN - Tape and Reel |
| ISL29147IROMZ-T7 | 制造商:Intersil Corporation 功能描述:ISL29147IROMZ LOW POWER AMBIENT LIGHT & PROXIMITY SENSOR W/E - Tape and Reel 制造商:Intersil Corporation 功能描述:IC OPT SENSOR LIGHT-VOLT 8-ODFN 制造商:Intersil Corporation 功能描述:AMBIENT LIGHT & PROXIMITY SENSOR, ODFN-8, IC Function:Light to Digital Output Se |
| ISL2D-B | 制造商:Rayovac 功能描述:TOOLS, FLASHLIGHTS (TORCHES), Body Material:Rubber, No. of Batteries:2 , RoHS Compliant: NA |
| ISL2D-BC | 制造商:Rayovac 功能描述:2D INDL SWIVEL/BTRY |
| ISL3034E | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:4-Channel And 6-Channel High Speed, Auto-direction Sensing Logic Level Translators |
发布紧急采购，3分钟左右您将得到回复。