- 您现在的位置：买卖IC网 > PDF目录10543 > ISL3295EIHZ-T7A (Intersil)IC TXRX PDF资料下载
参数资料
| 型号： | ISL3295EIHZ-T7A |
| 厂商： | Intersil |
| 文件页数： | 16/17页 |
| 文件大小： | 0K |
| 描述： | IC TXRX |
| 标准包装： | 1 |
| 系列： | * |
| 其它名称： | ISL3295EIHZ-T7ADKR |
8
FN6544.0
September 19, 2007
Driver Disable from Output
High
tHZ
Full
-
30, 22
60
ns
Driver Disable from Output Low
tLZ
Full
-
25, 20
60
ns
NOTES:
7. All currents into device pins are positive; all currents out of device pins are negative. All voltages are referenced to device ground unless
otherwise specified.
8. Applies to peak current. See “Typical Performance Curves” on page 12 for more information.
9. tSKPP is the magnitude of the difference in propagation delays of the specified terminals of two units tested with identical test conditions (VCC,
temperature, etc.).
10. If the driver enable function isn’t needed, connect DE to VCC (or VL) through a 1kΩ to 3kΩ resistor.
11. Parts are 100% tested at +25°C. Over-temperature limits established by characterization and are not production tested.
12. Due to the high short circuit current at VCC > 3.6V, the outputs must not be shorted outside the range of GND to VCC or damage may occur. To
prevent excessive power dissipation that may damage the output, the short circuit current should be limited to
≤ 300mA during testing. It is best
to use an external resistor for this purpose, since the current limiting on the VO supply may respond too slowly to protect the output.
13. Typicals are measured at VCC = 3.3V for parameters specified with 3V ≤ VCC ≤ 3.6V, and are measured at VCC = 5V for parameters specified
with 4.5V
≤ V
CC ≤ 5.5V. If VCC isn’t specified, then a single “TYP” entry applies to both VCC = 3.3V and 5V, and two entries separated by a
comma refer to VCC = 3.3V and 5V, respectively.
Test Circuits and Waveforms
FIGURE 1A. VOD AND VOC
FIGURE 1B. VOD WITH COMMON MODE LOAD
FIGURE 1. DC DRIVER TEST CIRCUITS
Electrical Specifications
Test Conditions: VCC = 3.0V to 5.5V; VL = VCC (ISL3296E, ISL3297E, ISL3298E only); Typicals are at
TA =+25°C; Unless Otherwise Specified. (Note 7) (Continued)
PARAMETER
SYMBOL
TEST CONDITIONS
TEMP
(°C)
MIN
(Note 11)
TYP
(Note 13)
MAX
(Note 11)
UNITS
D
DE
DI
VCC OR VL
VOD
VOC
RL/2
Z
Y
D
DE
DI
VCC OR VL
VOD
375
Ω
375
Ω
Z
Y
RL = 60Ω
VCM
-7V TO +12V
ISL3293E, ISL3294E, ISL3295E, ISL3296E, ISL3297E, ISL3298E
相关PDF资料 |
PDF描述 |
|---|---|
| AD9215BCPZ-65 | IC ADC 10BIT 65MSPS 32-LFCSP |
| AD7898ARZ-3 | IC ADC 12BIT SRL HS 5V 8SOIC |
| VI-2TJ-IW-F2 | CONVERTER MOD DC/DC 36V 100W |
| MC1413DG | IC TRANS ARRAY NPN DARL 16-SOIC |
| TP050F223Z-A-B | CAP CER 0.022UF 25V AXIAL |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL3296E | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:【16.5kV ESD Protected, +125∑C, 3.0V to 5.5V, SOT-23/TDFN Packaged, Low Power, RS-485/RS-422 Transmitters |
| ISL3296EFRTZ-T | 功能描述:IC TX ESD RS485/422 LP 8-TDFN RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS422，RS485 电源电压:4.5 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:剪切带 (CT) 其它名称:ISL31470EIBZ-T7ACT |
| ISL3296EIRTZ-T | 功能描述:IC TX ESD RS485/422 LP 8-TDFN RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS422，RS485 电源电压:4.75 V ~ 5.25 V 安装类型:通孔 封装/外壳:8-DIP（0.300"，7.62mm） 供应商设备封装:8-PDIP 包装:管件 产品目录页面:1402 (CN2011-ZH PDF) |
| ISL3297E | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:【16.5kV ESD Protected, +125∑C, 3.0V to 5.5V, SOT-23/TDFN Packaged, Low Power, RS-485/RS-422 Transmitters |
| ISL3297EFRTZ-T | 功能描述:IC TX ESD RS485/422 LP 8-TDFN RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS422，RS485 电源电压:4.5 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:剪切带 (CT) 其它名称:ISL31470EIBZ-T7ACT |
发布紧急采购，3分钟左右您将得到回复。