- 您现在的位置：买卖IC网 > PDF目录11193 > ISL54228IRTZ-T (Intersil)IC USB SWITCH DPST OVP 8TDFN PDF资料下载
参数资料
| 型号： | ISL54228IRTZ-T |
| 厂商： | Intersil |
| 文件页数： | 17/17页 |
| 文件大小： | 0K |
| 描述： | IC USB SWITCH DPST OVP 8TDFN |
| 标准包装： | 1,000 |
| 功能： | 开关 |
| 电路： | 2 x SPST |
| 导通状态电阻： | 17 欧姆 |
| 电压电源： | 单电源 |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 5.25 V |
| 电流 - 电源： | 45µA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WFDFN 裸露焊盘 |
| 供应商设备封装： | 8-TDFN（2x2） |
| 包装： | 带卷 (TR) |
ISL54228
9
FN7628.0
July 29, 2010
Application Block Diagram
Detailed Description
The ISL54228 device is a dual single pole/single throw
(SPST) analog switch configured as a DPST that
operates from a single DC power supply in the range of
2.7V to 5.25V.
It was designed for switching a USB high-speed source
or full-speed source in portable battery powered
products. It is offered in small TQFN and TDFN
packages for use in MP3 players, cameras, PDAs,
cellphones, and other personal media players.
The part consists of two 3.5Ω high speed SPST
switches. These switches have high bandwidth and low
capacitance to pass USB high-speed (480Mbps)
differential data signals with minimal edge and phase
distortion. They can also swing from 0V to 3.6V to pass
USB full speed (12Mbps) differential data signals with
minimal distortion.
The device has a single logic control pin (OE) to open
and close the two SPST switches. The part has an LP
control pin to put the part in a low power state.
The part contains special overvoltage protection (OVP)
circuitry on the COM+ and COM- pins. This circuitry
acts to open the SPST switches when the part senses a
voltage on the COM pins that is >3.8V (typ) or
< -0.45V (typ). It isolates voltages up to 5.25V and
down to -5V from getting through to the other side of
the switches (D-, D+) to protect the USB down-stream
transceiver connected at the D+ and D- pins.
The ISL54228 was designed for MP3 players, cameras,
cellphones, and other personal media player
applications that need to switch a high-speed or full-
speed transceiver source. A typical application block
diagram of this functionality is previously shown.
A detailed description of the SPST switches is provided
in the following section.
High-Speed (Dx) SPST Switches
The Dx switches are bi-directional switches that can
pass USB high-speed and USB full-speed signals when
VDD is in the range of 2.7V to 5.25V.
When powered with a 2.7V supply, these switches have
a nominal rON of 3.5Ω over the signal range of 0V to
400mV with a rON flatness of 0.26Ω. The rON matching
between the switches over this signal range is only
0.2Ω, ensuring minimal impact by the switches to USB
high speed signal transitions. As the signal level
increases, the rON switch resistance increases. At a
signal level of 3.3V, the switch resistance is nominally
Performance Curves” beginning on page 12.
The Dx switches were specifically designed to pass USB
2.0 high-speed (480Mbps) differential signals in the
range of 0V to 400mV. They have low capacitance and
high bandwidth to pass the USB high-speed signals
with minimum edge and phase distortion to meet USB
2.0 high speed signal quality specifications. See
Figure 14 in the “Typical Performance Curves” on
page 13 for USB High-speed Eye Pattern taken with
switch in the signal path.
The Dx switches can also pass USB full-speed signals
(12Mbps) in the range of 0V to 3.6V with minimal
PORTABLE MEDIA DEVICE
ISL54228
USB
TRANSCEIVER
HIGH-SPEED
U
S
B
CONNE
CTO
R
COM -
COM +
GND
D+
D-
VDD
OE
CONTROLLER
VBUS
D-
D+
GND
OR
FULL-SPEED
OVP
DET
4MΩ
LP
Logic
4MΩ
500Ω
3.3V
Control
ISL54228
相关PDF资料 |
PDF描述 |
|---|---|
| NLAS5223BMUR2G | IC SWITCH DUAL SPDT 10UQFN |
| MC74HC4067ADWR2G | IC MUX/DEMUX/QUAD SWITCH 24SOIC |
| M74HCT4851ADTR2G | ANALOG MULTIPLEXERS/DEMUL TSSOP |
| NLAS5223MNR2G | IC SWITCH DUAL SPDT 10WQFN |
| MC74HCT4851ADR2G | ANALOG MULTIPLEXERS/DEMUL SOIC16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL54228IRTZ-T7A | 功能描述:IC USB SWITCH DPST OVP 8TDFN RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:250 系列:- 功能:开关 电路:单刀单掷 导通状态电阻:48 欧姆 电压电源:单电源 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V 电流 - 电源:5µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:48-LQFP 供应商设备封装:48-LQFP（7x7） 包装:托盘 |
| ISL54228IRUZEVAL1Z | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High-Speed USB 2.0 (480Mbps) DPST Switch with Overvoltage Protection (OVP) |
| ISL54228IRUZ-T | 功能描述:IC USB SWITCH DPST OVP 8TQFN RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 其它有关文件:STG4159 View All Specifications 标准包装:5,000 系列:- 功能:开关 电路:1 x SPDT 导通状态电阻:300 毫欧 电压电源:双电源 电压 - 电源，单路/双路(±):±1.65 V ~ 4.8 V 电流 - 电源:50nA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:7-WFBGA，FCBGA 供应商设备封装:7-覆晶 包装:带卷 (TR) |
| ISL54228IRUZ-T7A | 功能描述:IC USB SWITCH DPST OVP 8TQFN RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:250 系列:- 功能:开关 电路:单刀单掷 导通状态电阻:48 欧姆 电压电源:单电源 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V 电流 - 电源:5µA 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:48-LQFP 供应商设备封装:48-LQFP（7x7） 包装:托盘 |
| ISL54230 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Octal Multiprotocol Switch |
发布紧急采购，3分钟左右您将得到回复。