参数资料
| 型号： | ISL54415IRUZ-T |
| 厂商： | Intersil |
| 文件页数： | 2/14页 |
| 文件大小： | 0K |
| 描述： | IC USB SWITCH DUAL SPDT 10UTQFN |
| 标准包装： | 3,000 |
| 功能： | USB 开关 |
| 电路： | 2 x SPDT |
| 导通状态电阻： | 6 欧姆 |
| 电压电源： | 单电源 |
| 电压 - 电源，单路/双路(±)： | 2.5 V ~ 3.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-UFQFN |
| 供应商设备封装： | 10-UTQFN（2.1x1.6） |
| 包装： | 带卷 (TR) |
10
FN6318.1
June 27, 2006
Figure 15 shows the measured gain and phase of a
3.58MHz, 300MVP-P signal at the output of the switch
relative to the signal at the input of the switch as you vary the
DC offset of the signal from 0V to 1V using a network
analyzer. The data from the sweep was used to calculated
the differential gain (DG) and differential phase (DP). Over
luminance range of 0V to 1V: DG = 0.03% and DP = 0.05°.
Over luminanace range of 0V to 0.7V: DG = 0.03% and
DP = 0.03°. DG and DP plot using an actual NTSC video
signal is shown in Figure 16. DG = 0.05% and DP = 0.02°.
These NC switches are uni-directional switches. The
audio/video sources should be connected at the NC side of
the switch (pins 7 and 8) and the speaker load and video
receiver should be connected at the COM side of the switch
(pins 3 and 4).
For the ISL54415 and ISL54416 parts the NC audio/video
switches are active (turned ON) whenever the VBUS voltage
is ≤ VDD + 0.2V. The VBUS pin is internally pulled low
through a pull-down resistor allowing the VBUS pin to float.
When the VBUS pin is floating the NC audio/video switches
are ON.
Note: Whenever the audio/video switches are ON the USB
transceivers need to be in the high impedance state or static
high or low state to keep from interfering with the audio/video
transmission.
For the ISL54417 part the NC1 audio/video switch is active
(turned ON) whenever logic pin IN1 (pin 10) is LOW. The
NC2 audio/video switch is active (turned ON) whenever the
logic pin IN2 (pin 2) is LOW. Unlike the ISL54415 and
ISL54416 parts were the two SPDT switches work in
tandem, the ISL54417 gives you independent control over
each SPDT switch.
NO1 and NO2 USB Switches
The two NO (normally open) USB switches (NO1, NO2) are
5
Ω bidirectional switches that were designed to pass low
speed and full-speed USB differential signals typically in the
range of 0V to 3.6V. The switches have low capacitance
(0.47pF) and high bandwidth (239MHz) to pass USB full-
speed signals (12Mbps) with minimum edge and phase
distortion to meet USB 2.0 signal quality specifications. See
Figure 12 for full-speed USB eye diagram.
For the ISL54415 and ISL54416 parts the maximum signal
range for the USB switches is from -1.5V to VBUS. The
signal voltage should not be allow to exceed the VBUS
voltage rail or go below ground by more than -1.5V.
For the ISL54417 part the maximum signal range is from
-1.5V to VDD. The signal voltage should not be allowed to
exceed the VDD voltage rail or go below ground by more
than -1.5V.
When using the ISL54415 and ISL54416 parts the USB
switches are active (turned ON) whenever the VBUS voltage
is ≥VDD + 0.8V. VBUS is internally pulled low, so when VBUS
is floating the USB switches are OFF.
Note: Whenever the USB switches are ON the audio and
video drivers need to be at AC or DC ground or floating to
keep from interfering with the data transmission.
When using the ISL54417 part the NO1 USB switch is active
(turned ON) whenever logic pin IN1 (pin 10) is HIGH. The
NO2 USB switch is active (turned ON) whenever the logic
pin IN2 (pin 2) is HIGH. Unlike the ISL54415 and ISL54416
parts were the two SPDT switches work in tandem, the
ISL54417 gives you independent control over each SPDT
switch.
FIGURE 8. VECTOR-SCOPE PLOT BEFORE SWITCH
FIGURE 9. VECTOR-SCOPE PLOT AFTER SWITCH
ISL54415, ISL54416, ISL54417
相关PDF资料 |
PDF描述 |
|---|---|
| ISL54500IRUZ-T | IC SWITCH SPDT SGL 6UTDFN |
| ISL54502IHZ-T | IC SWITCH SPDT SOT23-6 |
| ISL54503IRUZ-T | IC SWITCH SPDT SGL 6UTDFN |
| ISL54505IHZ-T | IC SWITCH SPDT SOT23-6 |
| ISL5585GCR-TK | IC SLIC RINGING 3.3V VOB 32-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL54416 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Low Voltage, Dual SPDT, USB/CVBS/ Audio Switches with Negative Signal Capability |
| ISL54416IRUZ-T | 功能描述:IC USB SWITCH DUAL SPDT 10UTQFN RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:36 系列:- 功能:多路复用器 电路:2 x 4:1 导通状态电阻:75 欧姆 电压电源:单/双电源 电压 - 电源，单路/双路(±):2 V ~ 12 V，±2 V ~ 6 V 电流 - 电源:- 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 供应商设备封装:20-SOIC W 包装:管件 |
| ISL54417 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Low Voltage, Dual SPDT, USB/CVBS/ Audio Switches with Negative Signal Capability |
| ISL54417IRUZ-T | 功能描述:IC USB SWITCH DUAL SPDT 10UTQFN RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:36 系列:- 功能:多路复用器 电路:2 x 4:1 导通状态电阻:75 欧姆 电压电源:单/双电源 电压 - 电源，单路/双路(±):2 V ~ 12 V，±2 V ~ 6 V 电流 - 电源:- 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 供应商设备封装:20-SOIC W 包装:管件 |
| ISL54500 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:+1.8V to +5.5V, 5ヘ, Single SPDT Analog Switch |
发布紧急采购，3分钟左右您将得到回复。