参数资料
| 型号： | ISL59922IRZ |
| 厂商： | Intersil |
| 文件页数： | 6/16页 |
| 文件大小： | 0K |
| 描述： | IC ANLG VID LINE TRPL 20-QFN |
| 标准包装： | 72 |
| 类型： | 视频延迟线 |
| 应用： | RGB 视频信号 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-VQFN 裸露焊盘 |
| 供应商设备封装： | 20-QFN 裸露焊盘（5x5） |
| 包装： | 管件 |
14
FN6826.2
August 31, 2010
These steps are only necessary if the sync signal is
embedded on the video and you want to avoid possible
monitor blanking during skew adjustment.
Test Pins
Three test pins are provided (Test R, Test G, Test B). During
normal operation, the test pins output pulses of current for a
duration of the overlap between the inputs, as shown in
Figure 34:
TESTR pulse = REDOUT (A) with respect to GREENOUT (B)
TESTG pulse = GREENOUT with respect to BLUEOUT
TESTB pulse = BLUEOUT with respect to REDOUT
Averaging the current gives a direct measure of the delay
between the two edges. When A precedes B, the current
pulse is +50A, and the output voltage goes up. When B
precedes A, the pulse is -50A.
For the logic to work correctly, A and B must have a period of
overlap while they are high (a delay longer than the pulse
width cannot be measured).
Signals A and B are derived from the video input by
comparing the video signal with a slicing level, which is set by
an internal DAC. This enables the delay to be measured
either from the rising edges of sync-like signals encoded on
top of the video or from a dedicated set-up signal. The outputs
can be used to set the correct delays for the signals received.
The DAC level is set through the serial input by bits 1
through 4 directed to the test register (00).
Internal DAC Voltage
The slice level of the internal DAC may be programmed by
writing a byte to the test register (00). Table 3 shows the
values that should be written to change the DAC slice level.
Please keep in mind when writing to the test register that the
LSB should always be zero.
Referred to the input, the DAC slice range for the ISL5992x
is cut in half for gain of 2 mode because the slicing occurs
after the x1/x2 stage output amplifier. (In the EL9115, the
slicing occurred before the amplifier so the range of the DAC
voltage was the same for either gain of 1 or gain of 2).
TABLE 3. DAC VOLTAGE RANGE - INPUT REFERRED
wxyz
DAC RANGE [mV]
(GAIN 1)
DAC RANGE [mV]
(GAIN 2)
1000
-400
-200
1001
-350
-175
1010
-300
-150
1011
-250
-125
1100
-200
-100
1101
-150
-75
1110
-100
-50
1111
-50
-25
0000
0
0001
50
25
0010
100
50
0011
150
75
0100
200
100
0101
250
125
0110
300
150
0111
350
175
NOTE: Test Register word = 000wxyz0. wxyz fed to DAC. z is LSB
FIGURE 34. DELAY DETECTOR
A
B
OUTPUT
4
SLICING LEVEL
COMPARATORS
A
B
INTERNAL DAC
000wxyz0
TESTR
A
B
TESTG
A
B
TESTB
REDOUT
GREENOUT
BLUEOUT
ISL59920, ISL59921, ISL59922, ISL59923
相关PDF资料 |
PDF描述 |
|---|---|
| ISL98001CQZ-240 | IC TRPL VIDEO DIGITIZER 128-MQFP |
| ISL99201IRTDZ-T | IC AMP AUDIO 1.5W MONO D 8TDFN |
| ISL99202IRTAZ-TK | IC AMP STEREO 60MW 12-TQFN |
| ISL99203IIZ-T | IC AMP AUDIO 5.5W MONO D 20WLCSP |
| ISPPAC-CLK5320S-01T64I | IC BUFFER FANOUT ISP UNIV 64TQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL59922IRZ-EVALZ | 制造商:Intersil Corporation 功能描述:ISL59922IRZ-EVALZ (PB-FREE ) EVALUATION BOARD - ROHS COMPLIA - Bulk |
| ISL59922IRZ-T7 | 功能描述:视频 IC ISL95871C INTEGRTD FET CO-PACK BATRY CH RoHS:否 制造商:Fairchild Semiconductor 工作电源电压:5 V 电源电流:80 mA 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-28 封装:Reel |
| ISL59923 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Triple Analog Video Delay Lines |
| ISL59923IRZ | 功能描述:视频 IC ISL97631IHTZ HI PWR WHT LED BOOSTLT1932 RoHS:否 制造商:Fairchild Semiconductor 工作电源电压:5 V 电源电流:80 mA 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-28 封装:Reel |
| ISL59923IRZ-EVALZ | 制造商:Intersil Corporation 功能描述:ISL59923IRZ-EVALZ (PB-FREE ) EVALUATION BOARD - ROHS COMPLIA - Bulk |
发布紧急采购，3分钟左右您将得到回复。