- 您现在的位置：买卖IC网 > PDF目录17373 > ISL60002DIH325Z-T7A (Intersil)IC VREF SERIES PREC 2.5V SOT23-3 PDF资料下载
参数资料
| 型号： | ISL60002DIH325Z-T7A |
| 厂商： | Intersil |
| 文件页数： | 35/38页 |
| 文件大小： | 0K |
| 描述： | IC VREF SERIES PREC 2.5V SOT23-3 |
| 产品培训模块： | Solutions for Test and Measurement Equipment Solutions for Industrial Control Applications |
| 标准包装： | 1 |
| 系列： | FGA™ |
| 基准类型： | 串联，精度 |
| 输出电压： | 2.5V |
| 容差： | ±5mV |
| 温度系数： | 20ppm/°C |
| 输入电压： | 2.7 V ~ 5.5 V |
| 通道数： | 1 |
| 电流 - 静态： | 900nA |
| 电流 - 输出： | 7mA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | TO-236-3，SC-59，SOT-23-3 |
| 供应商设备封装： | SOT-23-3 |
| 包装： | 标准包装 |
| 其它名称： | ISL60002DIH325Z-T7ADKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页当前第35页第36页第37页第38页
ISL60002
Board Assembly Considerations
FGA references provide high accuracy and low temperature drift
but some PC board assembly precautions are necessary. Normal
Output voltage shifts of 100μV to 1mV can be expected with
significantly over the full bandwidth. As shown in Figure 118,
noise is reduced to less than 40μV P-P from 1Hz to 1MHz using
this network with a 0.01μF capacitor and a 2k Ω resistor in series
with a 10μF capacitor.
Pb-free reflow profiles. Precautions should be taken to avoid
excessive heat or extended exposure to high reflow
temperatures, which may reduce device initial accuracy.
Post-assembly x-ray inspection may also lead to permanent
changes in device output voltage and should be minimized or
avoided. If x-ray inspection is required, it is advisable to monitor
the reference output voltage to verify excessive shift has not
occurred. If large amounts of shift are observed, it is best to add
an X-ray shield consisting of thin zinc (300μm) sheeting to allow
clear imaging, yet block x-ray energy that affects the FGA
reference.
Special Applications Considerations
400
350
300
250
200
150
100
50
CL = 0
CL = 0.001μF
CL = 0.1μF
CL = 0.01μF AND 10μF + 2k Ω
In addition to post-assembly examination, there are also other
X-ray sources that may affect the FGA reference long term
0
1
10
100
1k
10k
100k
accuracy. Airport screening machines contain X-rays and will
have a cumulative effect on the voltage reference output
accuracy. Carry-on luggage screening uses low level X-rays and is
not a major source of output voltage shift, however, if a product is
expected to pass through that type of screening over 100 times,
V IN = 3.0V
FIGURE 118. NOISE REDUCTION
it may need to consider shielding with copper or aluminum.
Checked luggage X-rays are higher intensity and can cause
output voltage shift in much fewer passes, thus devices expected
to go through those machines should definitely consider
shielding. Note that just two layers of 1/2 ounce copper planes
will reduce the received dose by over 90%. The leadframe for the
device which is on the bottom also provides similar shielding.
0.1μF
10μF
V IN
V O
ISL60002-25
VOUT = 2.50V
GND
0.01μF
2k Ω
10μF
If a device is expected to pass through luggage X-ray machines
numerous times, it is advised to mount a 2-layer (minimum) PC
board on the top, and along with a ground plane underneath will
effectively shield it from 50 to 100 passes through the machine.
Since these machines vary in X-ray dose delivered, it is difficult to
produce an accurate maximum pass recommendation.
Noise Performance and Reduction
The output noise voltage in a 0.1Hz to 10Hz bandwidth is
typically 30μV P-P . This is shown in the plot in the Typical
Performance Curves. The noise measurement is made with a
bandpass filter made of a 1 pole high-pass filter with a corner
frequency at 0.1Hz and a 2-pole low-pass filter with a corner
frequency at 12.6Hz to create a filter with a 9.9Hz bandwidth.
Noise in the 10kHz to 1MHz bandwidth is approximately
400μV P-P with no capacitance on the output, as shown in
Figure 118. These noise measurements are made with a 2
decade bandpass filter made of a 1 pole high-pass filter with a
corner frequency at 1/10 of the center frequency and 1-pole
low-pass filter with a corner frequency at 10 times the center
frequency. Figure 118 also shows the noise in the 10kHz to 1MHz
band can be reduced to about 50μV P-P using a 0.001μF
capacitor on the output. Noise in the 1kHz to 100kHz band can
be further reduced using a 0.1μF capacitor on the output, but
noise in the 1Hz to 100Hz band increases due to instability of the
very low power amplifier with a 0.1μF capacitance load. For load
capacitances above 0.001μF the noise reduction network shown
in Figure 119 is recommended. This network reduces noise
35
FIGURE 119. NOISE REDUCTION NETWORK
Turn-On Time
The ISL60002 devices have ultra-low supply current and thus the
time to bias up internal circuitry to final values will be longer than
with higher power references. Normal turn-on time is typically
7ms. This is shown in Figure 120. Since devices can vary in
supply current down to >300nA, turn-on time can last up to about
12ms. Care should be taken in system design to include this
delay before measurements or conversions are started.
FN8082.19
January 16, 2014
相关PDF资料 |
PDF描述 |
|---|---|
| A9AAT-0806F | FLEX CABLE - AFE08T/AF08/AFE08T |
| R1S-0512/H-R | CONV DC/DC 1W 05VIN 12VOUT |
| A9CAA-0204F | FLEX CABLE - AFG02A/AF02/AFE02T |
| T491C227K006AT | CAP TANT 220UF 6.3V 10% 2312 |
| ECE-V1HSR22SR | CAP ALUM 0.22UF 50V 20% SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL60002DIH325Z-TK | 功能描述:基准电压& 基准电流 PREC 2.5V LW VOLT FGA REF 5MV -40 - +8 RoHS:否 制造商:STMicroelectronics 产品:Voltage References 拓扑结构:Shunt References 参考类型:Programmable 输出电压:1.24 V to 18 V 初始准确度:0.25 % 平均温度系数（典型值）:100 PPM / C 串联 VREF - 输入电压（最大值）: 串联 VREF - 输入电压（最小值）: 分流电流（最大值）:60 mA 最大工作温度:+ 125 C 封装 / 箱体:SOT-23-3L 封装:Reel |
| ISL60002DIH326Z | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| ISL60002DIH326Z-TK | 功能描述:IC VREF SERIES PREC 2.6V SOT23-3 RoHS:是 类别:集成电路 (IC) >> PMIC - 电压基准 系列:FGA™ 标准包装:1 系列:- 基准类型:旁路，可调节，精度 输出电压:2.495 V ~ 36 V 容差:±1% 温度系数:标准值 34ppm/°C 输入电压:2.495 V ~ 36 V 通道数:1 电流 - 阴极:1mA 电流 - 静态:- 电流 - 输出:100mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:TO-236-3，SC-59，SOT-23-3 供应商设备封装:SOT-23-3 包装:剪切带 (CT) 产品目录页面:1073 (CN2011-ZH PDF) 其它名称:296-17329-1 |
| ISL60002DIH330Z-T7A | 功能描述:基准电压& 基准电流 PREC 3.0V LW VOLT FGA REF 5MV -40 - +8 RoHS:否 制造商:STMicroelectronics 产品:Voltage References 拓扑结构:Shunt References 参考类型:Programmable 输出电压:1.24 V to 18 V 初始准确度:0.25 % 平均温度系数（典型值）:100 PPM / C 串联 VREF - 输入电压（最大值）: 串联 VREF - 输入电压（最小值）: 分流电流（最大值）:60 mA 最大工作温度:+ 125 C 封装 / 箱体:SOT-23-3L 封装:Reel |
| ISL60002DIH330Z-TK | 功能描述:基准电压& 基准电流 PREC 3.0V LW VOLT FGA REF 5MV -40 - +8 RoHS:否 制造商:STMicroelectronics 产品:Voltage References 拓扑结构:Shunt References 参考类型:Programmable 输出电压:1.24 V to 18 V 初始准确度:0.25 % 平均温度系数（典型值）:100 PPM / C 串联 VREF - 输入电压（最大值）: 串联 VREF - 输入电压（最小值）: 分流电流（最大值）:60 mA 最大工作温度:+ 125 C 封装 / 箱体:SOT-23-3L 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。