- 您现在的位置：买卖IC网 > PDF目录22074 > ISL61853BIRZ (Intersil)IC USB PWR CTRLR DUAL 10DFN PDF资料下载
参数资料
| 型号： | ISL61853BIRZ |
| 厂商： | Intersil |
| 文件页数： | 10/20页 |
| 文件大小： | 0K |
| 描述： | IC USB PWR CTRLR DUAL 10DFN |
| 标准包装： | 100 |
| 类型： | 热交换开关 |
| 应用： | USB 过电流保护控制器 |
| 内部开关： | 是 |
| 电流限制： | 600mA |
| 电源电压： | 2.3 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-VFDFN 裸露焊盘 |
| 供应商设备封装： | 10-DFN（3x3） |
| 包装： | 管件 |
ISL6185
Turn-off Time Delay
During operation, once an OC condition is detected, the output
is current limited for ~12ms to allow transient OC conditions to
pass. If still in current limit and after the current limit period
has elapsed, the output is turned off, and the fault is reported
by pulling the corresponding FAULT low. The internal 12ms timer
starts upon current limiting and is independent of ambient or IC
thermal conditions, thus providing more consistent operation
over the entire temperature range.
Latch-off Restart/Auto-Restart Start
After turn-off, with the latch-off options, both the output and the
FAULT signal are latched low until they are reset by the enable
signal being de-asserted. At this time, the FAULT signal clears,
and the IC is ready for enable to assert. On the auto restart
options, the ISL6185 attempts to periodically turn-on the
output at approximately 1s intervals, as long as the enable is
asserted. If the OC condition remains indefinitely, the fault
indication and the restart attempts also continue until the
thermal protection feature is invoked, thus increasing the
restart period.
Active Output Pull-down
Another ISL6185 feature is the 10k Ω active pull-down on the
outputs to <60mV above GND when the device is disabled, thus
ensuring discharge of the load.
Typical Performance Curves
150
140
1.3
130
120
110
100
90
80
70
60
V IN = 2.5V
V IN = 3.3V
V IN = 5V
1.2
1.1
1.0
0.9
0.8
50
-40
-25
0
25 45 75
85
115
0.7
-40
-25
0 25 45 75
85
115
TEMPERATURE (°C)
FIGURE 3. SWITCH ON-RESISTANCE AT 0.5A
1.2
TEMPERATURE (°C)
FIGURE 4. NORMALIZED SWITCH RESISTANCE
1.6
1.1
1.0
0.9
0.8
5V I TRIP
3.3V I TRIP
1.5
1.4
1.3
1.2
1.1
5V I TRIP
3.3V I TRIP
5V I LIM
5V I SC
0.7
0.6
0.5
0.4
5V I SC
5V I LIM
3.3V I LIM
-40 -25
0 25 45 75
3.3V I SC
85
115
1.0 3.3V I LIM
0.9
0.8
0.7
0.6
-40 -25
0 25 45 75
3.3V I SC
85
115
TEMPERATURE (°C)
FIGURE 5. 0.6A CONTINUOUS CURRENT CHARACTERISTICS
10
TEMPERATURE (°C)
FIGURE 6. 1.1A CONTINUOUS CURRENT CHARACTERISTICS
FN6937.3
March 8, 2012
相关PDF资料 |
PDF描述 |
|---|---|
| RMA30DRMZ-S273 | CONN EDGECARD 60POS .125 SQ WW |
| TPME158M004R0015 | CAP TANT 1500UF 4V 20% 2917 |
| TAP104M050CRW | CAP TANT 0.1UF 50V 20% RADIAL |
| ISL61853BCRZ | IC USB PWR CTRLR DUAL 10DFN |
| ADP3336ARM-REEL7 | IC REG LDO ADJ .5A 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL61853BIRZ-T | 功能描述:热插拔功率分布 DL USB HOTSWAP W/INT FET-EN HI 10LD RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| ISL61853CCRZ | 功能描述:热插拔功率分布 DL USB HOTSWAP W/INT FET-EN HI 10LD RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| ISL61853CCRZ-T | 功能描述:热插拔功率分布 DL USB HOTSWAP W/INT FET-EN HI 10LD RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| ISL61853CIRZ | 功能描述:热插拔功率分布 DL USB HOTSWAP W/INT FET-EN HI 10LD RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| ISL61853CIRZ-T | 功能描述:热插拔功率分布 DL USB HOTSWAP W/INT FET-EN HI 10LD RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。