- 您现在的位置：买卖IC网 > PDF目录20381 > ISL6207CR-T (Intersil)IC MOSFET DRVR SYNC BUCK 8-QFN PDF资料下载
参数资料
| 型号： | ISL6207CR-T |
| 厂商： | Intersil |
| 文件页数： | 5/10页 |
| 文件大小： | 0K |
| 描述： | IC MOSFET DRVR SYNC BUCK 8-QFN |
| 标准包装： | 6,000 |
| 配置： | 高端和低端，同步 |
| 输入类型： | PWM |
| 延迟时间： | 20ns |
| 电流 - 峰： | 2A |
| 配置数： | 1 |
| 输出数： | 2 |
| 高端电压 - 最大（自引导启动）： | 36V |
| 电源电压： | 4.5 V ~ 5.5 V |
| 工作温度： | -10°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-VQFN 裸露焊盘 |
| 供应商设备封装： | 8-QFN（3x3） |
| 包装： | 带卷 (TR) |
ISL6207
Electrical Specifications
Recommended Operating Conditions, Unless Otherwise Noted. (Continued)
PARAMETER
UGATE Turn-On Propagation Delay
LGATE Turn-On Propagation Delay
SYMBOL
t PDHUGATE
t PDHLGATE
TEST CONDITIONS
V VCC = 5V, Outputs Unloaded
V VCC = 5V, Outputs Unloaded
MIN
10
10
TYP
20
20
MAX
30
30
UNITS
ns
ns
OUTPUT
Upper Drive Source Resistance
Upper Driver Source Current (Note 5)
Upper Drive Sink Resistance
Upper Driver Sink Current (Note 5)
Lower Drive Source Resistance
Lower Driver Source Current (Note 5)
Lower Drive Sink Resistance
Lower Driver Sink Current (Note 5)
R UGATE
I UGATE
R UGATE
I UGATE
R LGATE
I LGATE
R LGATE
I LGATE
500mA Source Current
-10°C to 85°C
V UGATE-PHASE = 2.5V
500mA Sink Current
-10°C to 85°C
V UGATE-PHASE = 2.5V
500mA Source Current
-10°C to 85°C
V LGATE = 2.5V
500mA Sink Current
-10°C to 85°C
V LGATE = 2.5V
-
-
-
-
-
-
-
-
-
-
-
-
1.0
1.0
2.0
1.0
1.0
2.0
1.0
1.0
2.0
0.4
0.4
4.0
2.5
2.2
-
2.5
2.2
-
2.5
2.2
-
1.0
0.8
-
?
?
A
?
?
A
?
?
A
?
?
A
NOTE:
5. Guaranteed by characterization, not 100% tested in production.
Functional Pin Description
UGATE (Pin 1 for SOIC-8, Pin 8 for QFN)
The UGATE pin is the upper gate drive output. Connect to
the gate of high-side power N-Channel MOSFET.
BOOT (Pin 2 for SOIC-8, Pin 1 for QFN)
BOOT is the floating bootstrap supply pin for the upper gate
drive. Connect the bootstrap capacitor between this pin and
the PHASE pin. The bootstrap capacitor provides the charge
to turn on the upper MOSFET. See the Bootstrap Diode and
Capacitor section under DESCRIPTION for guidance in
choosing the appropriate capacitor value.
PWM (Pin 3 for SOIC-8, Pin 2 for QFN)
The PWM signal is the control input for the driver. The PWM
signal can enter three distinct states during operation, see the
three-state PWM Input section under DESCRIPTION for further
details. Connect this pin to the PWM output of the controller. In
addition, place a 500k ? resistor to ground from this pin. This
allows for proper three-state operation under all start-up
conditions.
GND (Pin 4 for SOIC-8, Pin 3 for QFN)
GND is the ground pin. All signals are referenced to this node.
LGATE (Pin 5 for SOIC-8, Pin 4 for QFN)
LGATE is the lower gate drive output. Connect to gate of the
low-side power N-Channel MOSFET.
5
VCC (Pin 6 for SOIC-8, Pin 5 for QFN)
Connect the VCC pin to a +5V bias supply. Place a high
quality bypass capacitor from this pin to GND.
EN (Pin 7 for SOIC-8, Pin 6 for QFN)
EN is the enable input pin. Connect this pin to HIGH to
enable, and LOW to disable, the IC. When disabled, the IC
draws less than 1 μ A bias current.
PHASE (Pin 8 for SOIC-8, Pin 7 for QFN)
Connect the PHASE pin to the source of the upper MOSFET
and the drain of the lower MOSFET. This pin provides a
return path for the upper gate driver.
Description
Operation
Designed for speed, the ISL6207 dual MOSFET driver
controls both high-side and low-side N-Channel FETs from
one externally provided PWM signal.
A rising edge on PWM initiates the turn-off of the lower
MOSFET (see Timing Diagram). After a short propagation
delay [t PDLLGATE ], the lower gate begins to fall. Typical fall
times [t FLGATE ] are provided in the Electrical Specifications
section. Adaptive shoot-through circuitry monitors the LGATE
voltage and determines the upper gate delay time
[t PDHUGATE ], based on how quickly the LGATE voltage drops
below 1V. This prevents both the lower and upper MOSFETs
from conducting simultaneously, or shoot-through. Once this
delay period is completed, the upper gate drive begins to rise
[t RUGATE ], and the upper MOSFET turns on.
FN9075.8
December 2, 2005
相关PDF资料 |
PDF描述 |
|---|---|
| EGM06DTMD | CONN EDGECARD 12POS R/A .156 SLD |
| EBM15DCMI | CONN EDGECARD 30POS .156 WW |
| R0.25S-0512/P | CONV DC/DC 0.25W 5V IN 12V OUT |
| T95D336M025LSSL | CAP TANT 33UF 25V 20% 2917 |
| ISL6207CR | IC MOSFET DRVR SYNC BUCK 8-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6207CRZ | 功能描述:功率驱动器IC VER OF ISL6207CR RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| ISL6207CRZA | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High Voltage Synchronous Rectified Buck MOSFET Driver |
| ISL6207CRZA-T | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High Voltage Synchronous Rectified Buck MOSFET Driver |
| ISL6207CRZ-T | 功能描述:功率驱动器IC VER OF ISL6207CR-T RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| ISL6207HBZ | 功能描述:功率驱动器IC VER OF ISL6207CB W/- 10 TO +100 TEMP RNG RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。