参数资料
型号: ISL6423BEVEZ
厂商: Intersil
文件页数: 8/16页
文件大小: 0K
描述: IC VREG SGL LNB W/I2C 28-EPTSSOP
标准包装: 1,000
应用: 转换器,卫星信号接收机顶盒设计
输入电压: 8 V ~ 14 V
输出数: 1
输出电压: 13.3 V ~ 18.3 V,14.3 V ~ 19.3 V
工作温度: -20°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 28-SOIC(0.173",4.40mm 宽)裸露焊盘
供应商设备封装: 28-TSSOP 裸露焊盘
包装: 管件
Typical Performance Curves
0.80
0.70
0.80
0.70
0.60
0.50
0.40
0.30
0.20
0.10
I OUT _max
0.60
0.50
0.40
0.30
0.20
0.10
I OUT _max
0.00
0
20
40
60
80
0.00
0
20
40
60
80
TEMPERATURE (°C)
FIGURE 2. OUTPUT CURRENT DERATING (EPTSSOP)
Functional Pin Description
TEMPERATURE (°C)
FIGURE 3. OUTPUT CURRENT DERATING (4x4 QFN)
SYMBOL
SDA
SCL
VSW
PGND
CS
SGND
TCAP
BYPASS
TXT
VCC
GATE
VO
ADDR0 & ADDR1
EXTM
FLT
CPVOUT, CPSWIN
CPSWOUT
SELVTOP
TDIN, TDOUT
FUNCTION
Bidirectional data from/to I 2 C bus.
Clock from I 2 C bus.
Input of the linear post-regulator.
Dedicated ground for the output gate driver of respective PWM.
Current sense input; connect the sense resistor Rsc at this pin for desired peak overcurrent value for the boost FET. The
set peak limit is effective in the static mode current limit only i.e., DCL = HIGH.
Small signal ground for the IC.
Capacitor for setting rise and fall time of the output voltage. Typical value is 0.1μF.
Bypass capacitor for internal 5V.
TXT is the Tone Transmit signal input used to change the Tone Decoder Threshold from TXT = 0, 200mV max during
Receive to TXT = 1, 400mV min during Transmit.
Main power supply to the chip.
This output drives the boost FET gate. The output is held low when V CC is below the UVLO threshold.
Output voltage for the LNB is available at VO pin.
Logic combination at the ADDR0 & 1 can select four different chip select addresses.
This pin can be used in two ways:
1) As an input for externally modulated Diseqc tone signal which is transferred to the symmetrically onto V OUT
2) Alternatively apply a Diseqc modulation envelope which modulates an internal tone and then transfers it symmetrically
onto V OUT
This is an Open Drain output from the controller. When the FLT goes low it indicates that an Over Temperature, Over load
fault, UVLO, or an I 2 C reset condition has occurred. The processor should then look at the I 2 C register to get the actual
cause of the error. A high on the FLT indicates that the device is functioning normally.
A 47n charge pump decoupling capacitor is to be connected to CPVOUT. Connect a 1.5n capacitor between CPSWIN and
CPSWOUT
When this pin is low the V OUT is in the 13V, 14V range selected by the I 2 C bit VBOT.
When this pin is high the 18V, 19V range selected by the I 2 C bit VTOP. The Voltage select pin enable VSPEN I 2 C bit must
be set low for the SELVTOP pins to be active. Setting VSPEN high disables this pins and voltage selection will be done
using the I 2 C bits VBOT and VTOP only.
TDIN is the tone decoder input and TDOUT is the tone detector output. TDOUT is an open drain output
8
FN6412.1
April 10, 2007
相关PDF资料
PDF描述
EL7640ILTZ IC BOOST REG DC/DC TFT-LCD 32QFN
LT1175CS8-5#PBF IC REG LDO -5V .5A 8SOIC
ISL6568IRZ-TR5184 IC CTRLR PWM 2PHASE BUCK 32-QFN
ISL6568IRZA-T IC CTRLR PWM BUCK 2PHASE 32-QFN
MIC5320-MFYML TR IC REG LDO 2.8V/1.5V .15A 6-MLF
相关代理商/技术参数
参数描述
ISL6423BEVEZ-T 功能描述:电流型 PWM 控制器 SINGLE LNB SUPPLY + CONTROL VAGEG W/I2C RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL6423ERZ 功能描述:电流型 PWM 控制器 NOTCOMENDED FOR NEW DESIGN RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL6423ERZ-T 功能描述:电流型 PWM 控制器 NOTCOMENDED FOR NEW DESIGN RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL6423EVEZ 功能描述:电流型 PWM 控制器 NOTCOMENDED FOR NEW DESIGN RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL6423EVEZ-T 功能描述:电流型 PWM 控制器 NOTCOMENDED FOR NEW DESIGN RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14