- 您现在的位置：买卖IC网 > PDF目录17316 > ISL6440EVAL1Z (Intersil)EVALUATION BOARD FOR ISL6440 PDF资料下载
参数资料
| 型号： | ISL6440EVAL1Z |
| 厂商： | Intersil |
| 文件页数： | 9/15页 |
| 文件大小： | 0K |
| 描述： | EVALUATION BOARD FOR ISL6440 |
| 标准包装： | 1 |
| 主要目的： | DC/DC，步降 |
| 输出及类型： | 2，非隔离 |
| 输出电压： | 1.8V，3.3V |
| 电流 - 输出： | 2A，2A |
| 输入电压： | 12V |
| 稳压器拓扑结构： | 降压 |
| 频率 - 开关： | 300kHz |
| 板类型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | ISL6440 |
ISL6440
Soft-Start Operation
When soft-start is initiated, the voltage on the SS pin of the
enabled PWM channels starts to ramp gradually, due to the
T SOFT = 0.8V ? ----------- ?
V OUTx = 0.8V ? ---------------------- ?
5 μ A current sourced into the external capacitor. The output
voltage follows the soft-start voltage.
When the SS pin voltage reaches 0.8V, the output voltage of
the enabled PWM channel reaches the regulation point, and
the soft-start pin voltage continues to rise. At this point the
PGOOD and fault circuitry is enabled. This completes the
soft-start sequence. Any further rise of SS pin voltage does
not affect the output voltage. By varying the values of the
soft-start capacitors, it is possible to provide sequencing of the
main outputs at start-up. The soft-start time can be obtained
from the following equation:
C SS
? 5 μ A ?
VCC5 1V/DIV
V OUT1 1V/DIV
SS1 1V/DIV
FIGURE 13. SOFT-START OPERATION
The soft-start capacitors can be chosen to provide startup
tracking for the two PWM outputs. This can be achieved by
choosing the soft-start capacitors such that the soft-start
capacitor ration equals the respective PWM output voltage
ratio. For example, if I use PWM1 = 1.2V and PWM2 = 3.3V
then the soft-start capacitor ration should be, C SS1 /C SS1 =
1.2/3.3 = 0.364. Figure 14 shows that soft-start waveform
with C SS1 = 0.01μF and C SS2 = 0.027μF.
9
V OUT1 1V/DIV
V OUT2 1V/DIV
FIGURE 14. PWM1 AND PWM2 OUTPUT TRACKING DURING
STARTUP
Output Voltage Programming
A resistive divider from the output to ground sets the output
voltage of either PWM channel. The center point of the
divider shall be connected to FBx pin. The output voltage
value is determined by the following equation.
R1 + R2
? R2 ?
where R1 is the top resistor of the feedback divider network
and R2 is the resistor connected from FB1 or FB2 to ground.
Out-of-Phase Operation
The two PWM controllers in the ISL6440 operate 180 o out-
of-phase to reduce input ripple current. This reduces the
input capacitor ripple current requirements, reduces power
supply-induced noise, and improves EMI. This effectively
helps to lower component cost, save board space and
reduce EMI.
Dual PWMs typically operate in-phase and turn on both
upper FETs at the same time. The input capacitor must then
support the instantaneous current requirements of both
controllers simultaneously, resulting in increased ripple
voltage and current. The higher RMS ripple current lowers
the efficiency due to the power loss associated with the ESR
of the input capacitor. This typically requires more low-ESR
capacitors in parallel to minimize the input voltage ripple and
ESR-related losses, or to meet the required ripple current
rating.
With dual synchronized out-of-phase operation, the high-
side MOSFETs of the ISL6440 turn on 180 o out-of-phase.
The instantaneous input current peaks of both regulators no
longer overlap, resulting in reduced RMS ripple current and
input voltage ripple. This reduces the required input
capacitor ripple current rating, allowing fewer or less
expensive capacitors, and reducing the shielding
requirements for EMI. The typical operating curves show the
synchronized 180 degree out-of-phase operation.
FN9040.2
October 4, 2005
相关PDF资料 |
PDF描述 |
|---|---|
| R1S12-1509/P-R | CONV DC/DC 1W 15VIN 09VOUT |
| 195D825X9025Y2T | CAP TANT 8.2UF 25V 10% 2910 |
| A9BAA-2008F | FLEX CABLE - AFF20A/AF20/AFE20T |
| 195D686X9004Y2T | CAP TANT 68UF 4V 10% 2910 |
| R1S12-1505/P-R | CONV DC/DC 1W 15VIN 05VOUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6440IA | 功能描述:IC REG CTRLR BUCK PWM CM 24-QSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| ISL6440IA-T | 功能描述:IC REG CTRLR BUCK PWM CM 24-QSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| ISL6440IA-TK | 功能描述:IC REG CTRLR BUCK PWM CM 24-QSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| ISL6440IAZ | 功能描述:电流型 PWM 控制器 DUAL PWM CONTRLR+LIN EAR CONTRLR 300KHZ RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL6440IAZ-T | 功能描述:IC REG CTRLR BUCK PWM CM 24-QSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:75 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.3 V ~ 13.5 V 降压:是 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:0°C ~ 70°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:管件 产品目录页面:1051 (CN2011-ZH PDF) 其它名称:296-2543-5 |
发布紧急采购，3分钟左右您将得到回复。