- 您现在的位置：买卖IC网 > PDF目录15084 > ISL6520CB-T (Intersil)IC REG CTRLR BUCK PWM VM 8-SOIC PDF资料下载
参数资料
| 型号： | ISL6520CB-T |
| 厂商： | Intersil |
| 文件页数： | 8/11页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 8-SOIC |
| 标准包装： | 2,500 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 340kHz |
| 占空比： | 100% |
| 电源电压： | 4.5 V ~ 5.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
| 其它名称： | ISL6520CB-TR |
ISL6520
the MOSFETs and between the drain of Q 1 and the source
of Q 2 .
P UPPER = Io 2 x r DS(ON) x D +
1 Io x V
2
IN x t SW x F S
The important parameters for the bulk input capacitor are the
P LOWER = Io 2 x r DS(ON) x (1 - D)
voltage rating and the RMS current rating. For reliable
operation, select the bulk capacitor with voltage and current
ratings above the maximum input voltage and largest RMS
current required by the circuit. The capacitor voltage rating
Where: D is the duty cycle = V OUT / V IN ,
t SW is the switching interval, and
F S is the switching frequency.
(EQ. 8)
should be at least 1.25 times greater than the maximum
input voltage and a voltage rating of 1.5 times is a
conservative guideline. The RMS current rating requirement
for the input capacitor of a buck regulator is approximately
1/2 the DC load current.
For a through hole design, several electrolytic capacitors
may be needed. For surface mount designs, solid tantalum
capacitors can be used, but caution must be exercised with
regard to the capacitor surge current rating. These
capacitors must be capable of handling the surge-current at
Given the reduced available gate bias voltage (5V),
logic-level or sub-logic-level transistors should be used for
both N-MOSFETs. Caution should be exercised with
devices exhibiting very low V GS(ON) characteristics. The
shoot-through protection present aboard the ISL6520 may
be circumvented by these MOSFETs if they have large
parasitic impedences and/or capacitances that would
inhibit the gate of the MOSFET from being discharged
below its threshold level before the complementary
MOSFET is turned on.
power-up. Some capacitor series available from reputable
manufacturers are surge current tested.
+5V
D BOOT
MOSFET Selection/Considerations
VCC
+ V D -
+5V
The ISL6520 requires two N-Channel power MOSFETs.
These should be selected based upon r DS(ON) , gate
supply requirements, and thermal management
requirements.
In high-current applications, the MOSFET power
dissipation, package selection and heatsink are the
dominant design factors. The power dissipation includes
two loss components; conduction loss and switching loss.
The conduction losses are the largest component of power
-
+
ISL6520
BOOT
UGATE
PHASE
LGATE
C BOOT
Q1
Q2
NOTE:
V G-S ≈ V CC -V D
NOTE:
V G-S ≈ V CC
dissipation for both the upper and the lower MOSFETs.
These losses are distributed between the two MOSFETs
according to duty factor (see the equations below). Only
the upper MOSFET has switching losses, since the lower
MOSFETs body diode or an external Schottky rectifier
across the lower MOSFET clamps the switching node
before the synchronous rectifier turns on. These equations
assume linear voltage-current transitions and do not
adequately model power loss due the reverse-recovery of
the lower MOSFET’s body diode. The gate-charge losses
are dissipated by the ISL6520 and don't heat the
MOSFETs. However, large gate-charge increases the
switching interval, t SW which increases the upper MOSFET
switching losses. Ensure that both MOSFETs are within
their maximum junction temperature at high ambient
temperature by calculating the temperature rise according
to package thermal-resistance specifications. A separate
heatsink may be necessary depending upon MOSFET
power, package type, ambient temperature and air flow.
8
GND
FIGURE 7. UPPER GATE DRIVE BOOTSTRAP
Figure 7 shows the upper gate drive (BOOT pin) supplied
by a bootstrap circuit from V CC . The boot capacitor,
C BOOT , develops a floating supply voltage referenced to
the PHASE pin. The supply is refreshed to a voltage of V CC
less the boot diode drop (V D ) each time the lower
MOSFET, Q 2 , turns on.
FN9009.6
April 3, 2007
相关PDF资料 |
PDF描述 |
|---|---|
| X4045S8IZ | IC CPU SUPERV 4K EEPROM 8-SOIC |
| VI-20H-EY-B1 | CONVERTER MOD DC/DC 52V 50W |
| ISL6520ACB-T | IC REG CTRLR BUCK PWM VM 8-SOIC |
| X4043S8IZ-2.7A | IC CPU SUPERV 4K EEPROM 8-SOIC |
| VI-25X-EW-F3 | CONVERTER MOD DC/DC 5.2V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6520CBZ | 功能描述:IC REG CTRLR BUCK PWM VM 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6520CBZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 8-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6520CR | 功能描述:IC REG CTRLR BUCK PWM VM 16-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| ISL6520CR-T | 功能描述:IC REG CTRLR BUCK PWM VM 16-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,000 系列:- PWM 型:电压模式 输出数:1 频率 - 最大:1.5MHz 占空比:66.7% 电源电压:4.75 V ~ 5.25 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:40-VFQFN 裸露焊盘 包装:带卷 (TR) |
| ISL6520CRZ | 功能描述:IC REG CTRLR BUCK PWM VM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。