- 您现在的位置：买卖IC网 > PDF目录13647 > ISL8023AIRTAJZ-T (Intersil)IC VOLTAGE REGULATOR PDF资料下载
参数资料
| 型号： | ISL8023AIRTAJZ-T |
| 厂商： | Intersil |
| 文件页数： | 15/20页 |
| 文件大小： | 0K |
| 描述： | IC VOLTAGE REGULATOR |
| 标准包装： | 6,000 |
| 系列： | * |
ISL8023, ISL8024
CLOCK
I L
0
V OUT
PWM
8 CYCLES
NOMINAL +1.5%
PFM
PFM CURRENT LIMIT
LOAD CURRENT
NOMINAL
NOMINAL -1.5%
PWM
FIGURE 40. SKIP MODE OPERATION WAVEFORMS
Frequency Adjust
The frequency of operation is fixed at 1MHz and internal
compensation when FS is tied to VIN. Adjustable frequency range
from 500kHz to 4MHz via simple resistor connecting FS to SGND
according to Equation 1:
Negative Current Protection
Similar to the overcurrent, the negative current protection is
realized by monitoring the current across the low-side N-FET, as
shown in Figure 3 on page 5. When the valley point of the inductor
current reaches -3A for 4 consecutive cycles, both P-FET and N-FET
R T [ k Ω ] = ------------------------------ – 14
220 ? 10 3
f OSC [ kHz ]
(EQ. 1)
are off. The 100 ? in parallel to the N-FET will activate discharging
the output into regulation. The control will begin to switch when
output is within regulation. The regulator will be in PFM for 20μs
Overcurrent Protection
The overcurrent protection is realized by monitoring the CSA
output with the OCP comparator, as shown in Figure 3. The current
sensing circuit has a gain of 200mV/A, from the P-FET current to
the CSA output. When the CSA output reaches the threshold, the
OCP comparator is trippled to turn off the P-FET immediately. The
overcurrent function protects the switching converter from a
shorted output by monitoring the current flowing through the
upper MOSFET.
Upon detection of an overcurrent condition, the upper MOSFET
will be immediately turned off and will not be turned on again
until the next switching cycle. Upon detection of the initial
overcurrent condition, the overcurrent fault counter is set to 1. If,
on the subsequent cycle, another overcurrent condition is
detected, the OC fault counter will be incremented. If there are
17 sequential OC fault detections, the regulator will be shutdown
under an overcurrent fault condition. An overcurrent fault
condition will result in the regulator attempting to restart in a
hiccup mode within the delay of eight soft-start periods. At the
end of the eight soft-start wait period, the fault counters are reset
and soft-start is attempted again. If the overcurrent condition
goes away during the delay of eight soft-start periods, the output
will resume back into regulation point after hiccup mode expires.
before switching to PWM if necessary.
PG
PG is an open-drain output of a window comparator that
continuously monitors the buck regulator output voltage. PG is
actively held low when EN is low and during the buck regulator
soft-start period. After 1ms delay of the soft-start period, PG
becomes high impedance as long as the output voltage is within
nominal regulation voltage set by VFB. When VFB drops 15% below
or raises 0.8V above the nominal regulation voltage, the ISL8023,
ISL8024 pulls PG low. Any fault condition forces PG low until the
fault condition is cleared by attempts to soft-start. For logic level
output voltages, connect an external pull-up resistor, R 1 , between
PG and VIN. A 100k Ω resistor works well in most applications.
UVLO
When the input voltage is below the undervoltage lock-out (UVLO)
threshold, the regulator is disabled.
15
FN7812.3
March 24, 2014
相关PDF资料 |
PDF描述 |
|---|---|
| ISL8023AIRTAJZ | IC VOLTAGE REGULATOR |
| 400BXC3.3MEFCT810X16 | CAP ALUM 3.3UF 400V 20% RADIAL |
| SC1212-222 | INDUCTOR SMD 2200UH 20A 1KHZ |
| RSM15DSUN | CONN EDGECARD 30POS DIP .156 SLD |
| RMM15DSUN | CONN EDGECARD 30POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL8023AIRTAJZ-T7A | 功能描述:IC REG BUCK SYNC ADJ 3A 16TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:1 系列:EZBuck™ 类型:降压（降压） 输出类型:可调式 输出数:1 输出电压:0.8 V ~ 22.1 V 输入电压:3 V ~ 26 V PWM 型:电流模式 频率 - 开关:1.5MHz 电流 - 输出:1.8A 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-WFDFN 裸露焊盘 包装:剪切带 (CT) 供应商设备封装:8-DFN（2x2） 其它名称:785-1276-1 |
| ISL8023EVAL3Z | 功能描述:电源管理IC开发工具 ISL8023 EVALUATION BOARD 3 - 16 LD TQFN - RoHS COMPLIANT RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| ISL8023IRTAJZ | 功能描述:IC VOLTAGE REGULATOR RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL8023IRTAJZ-T | 功能描述:IC VOLTAGE REGULATOR RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:1 输出电压:5V，1 V ~ 10 V 输入电压:3.5 V ~ 28 V PWM 型:电流模式 频率 - 开关:220kHz ~ 1MHz 电流 - 输出:600mA 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SSOP（0.154"，3.90mm 宽） 包装:带卷 (TR) 供应商设备封装:16-QSOP |
| ISL8023IRTAJZ-T7 | 功能描述:直流/直流开关转换器 3A, Adjustable Vout, Low Quiescent Current Synch. Buck Regul RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。