- 您现在的位置：买卖IC网 > PDF目录10681 > ISL81387IBZ-T (Intersil)TXRX ESD RS-485/422 2PORT 20SOIC PDF资料下载
参数资料
| 型号： | ISL81387IBZ-T |
| 厂商： | Intersil |
| 文件页数： | 6/27页 |
| 文件大小： | 0K |
| 描述： | TXRX ESD RS-485/422 2PORT 20SOIC |
| 产品培训模块： | Solutions for Industrial Control Applications |
| 标准包装： | 1 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 2/2 |
| 规程： | RS232，RS422，RS485 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 20-SOIC W |
| 包装： | 标准包装 |
| 产品目录页面： | 1241 (CN2011-ZH PDF) |
| 其它名称： | ISL81387IBZ-TDKR |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
14
FN6201.3
November 21, 2007
ISL81387, ISL41387 Advantages
These dual protocol ICs offer many parametric
improvements versus those offered on competing dual
protocol devices. Some of the major improvements are:
15kV Bus Pin ESD - Eases board level requirements
2.7V Diff VOUT - Better Noise immunity and/or distance
Full Failsafe RS-485 Rx - Eliminates bus biasing
Selectable RS-485 Data Rate - Up to 20Mbps, or slewrate
limited for low EMI and fewer termination issues
High RS-232 Data Rate - >460kbps
Lower Tx and Rx Skews - Wider, consistent bit widths
Lower ICC - Max ICC is 2x to 4x lower than competition
Flow-Thru Pinouts - Tx, Rx bus pins on one side/logic pins
on the other, for easy routing to connector/UART
Smaller (SSOP and QFN) and Pb-free packaging
RS-232 Mode
RX FEATURES
RS-232 receivers invert and convert RS-232 input levels
(±3V to ±25V) to the standard TTL/CMOS levels required by
a UART, ASIC, or controller serial port. Receivers are
designed to operate at faster data rates than the drivers, and
they feature very low skews (10ns) so the receivers
contribute negligibly to bit width distortion. Inputs include the
standard required 3k
Ω to 7kΩ pull-down resistor, so unused
inputs may be left unconnected. Rx inputs also have built-in
hysteresis to increase noise immunity, and to decrease
erroneous triggering due to slowly transitioning input signals.
Rx outputs are short circuit protected, and are tri-statable via
the active high RXEN pin, when the IC is shutdown (SHDN;
Mode” on page 16), or via the active low RXEN pin available
on the QFN package option (see“ISL41387 (QFN Package)
Special Features” on page 17 for more details).
TX FEATURES
RS-232 drivers invert and convert the standard TTL/CMOS
levels from a UART, or controller serial port to RS-232
compliant levels (±5V minimum). The Tx delivers these
compliant output levels even at data rates of 650kbps, and
with loads of 1000pF. The drivers are designed for low skew
(typically 12% of the 500kbps bit width), and are compliant to
the RS-232 slew rate spec (4V/s to 30V/s) for a wide
range of load capacitances. Tx inputs float if left
unconnected, and may cause ICC increases. For the best
results, connect unused inputs to GND.
Tx outputs are short circuit protected, and incorporate a
thermal SHDN feature to protect the IC in situations of
severe power dissipation. See the RS-485 section for more
details. Drivers tri-state via the active high DEN pin, in SHDN
Mode” on page 16), or when the 5V power supply is off.
CHARGE PUMPS
The on-chip charge pumps create the RS-232 transmitter
power supplies (typically +6/-7V) from a single supply as low
as 4.5V, and are enabled only if the port is configured for
RS-232 operation, and not in SHDN. The efficient design
requires only four small 0.1F capacitors for the voltage
doubler and inverter functions. By operating discontinuously
(i.e., turning off as soon as V+ and V- pump up to the
nominal values), the charge pump contribution to RS-232
mode ICC is reduced significantly. Unlike competing devices
that require the charge pump in RS-485 mode, disabling the
charge pump saves power, and minimizes noise. If the
application is a dedicated RS-485 port, then the charge
pump capacitors aren’t even required.
DATA RATES AND CABLING
Drivers operate at data rates up to 650kbps, and are
guaranteed for data rates up to 460kbps. The charge pumps
and drivers are designed such that one driver can be
operated at the rated load, and at 460kbps (see Figure 33).
Figure 33 also shows that drivers can easily drive several
thousands of picofarads at data rates up to 250kbps, while
still delivering compliant ±5V output levels.
Receivers operate at data rates up to 2Mbps. They are
designed for a higher data rate to facilitate faster factory
downloading of software into the final product, thereby
improving the user’s manufacturing throughput.
250kbps, and 500kbps, respectively. For these graphs, one
driver drives the specified capacitive load, and a receiver.
RS-232 doesn’t require anything special for cabling; just a
single bus wire per transmitter and receiver, and another
wire for GND. So an ISL81387, ISL41387 RS-232 port uses
a five conductor cable for interconnection. Bus terminations
are not required, nor allowed, by the RS-232 standard.
RS-485 Mode
RX FEATURES
RS-485 receivers convert differential input signals as small
as 200mV, as required by the RS-485 and RS-422
standards, to TTL/CMOS output levels. The differential Rx
provides maximum sensitivity, noise immunity, and common
mode rejection. Per the RS-485 standard, receiver inputs
function with common mode voltages as great as ±7V
outside the power supplies (i.e., +12V and -7V), making
them ideal for long networks where induced voltages are a
realistic concern. Each RS-485, RS-422 port includes a
single receiver (RA), and the unused Rx output (RB) is
disabled.
ISL81387, ISL41387
相关PDF资料 |
PDF描述 |
|---|---|
| LT1715IMS#TRPBF | IC COMPARATOR 150MHZ DUAL 10MSOP |
| CS5525-ASZ | IC ADC 16BIT W/4BIT LATCH 20SSOP |
| LT1715IMS#TR | IC COMPARATOR 150MHZ DUAL 10MSOP |
| AD8612ARUZ-REEL | IC COMP DUAL 4NS FAST 14-TSSOP |
| AD9609BCPZ-40 | IC ADC 10BIT 40MSPS LP 32LFCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL81483 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:1/8 Unit Load, 5V, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers |
| ISL81483IB | 功能描述:IC TXRX RS485/422 5V LP 8-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:25 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:4.5 V ~ 5.5 V 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 供应商设备封装:16-PDIP 包装:管件 |
| ISL81483IB-T | 功能描述:IC TXRX RS485/422 5V LP 8-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:25 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:4.5 V ~ 5.5 V 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 供应商设备封装:16-PDIP 包装:管件 |
| ISL81483IBZ | 功能描述:IC TXRX RS485/422 5V LP 8-SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:250 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:16-TSSOP 包装:带卷 (TR) |
| ISL81483IBZS2705 | 制造商:Intersil Corporation 功能描述:CISCO ISL81483IBZ W/CONTAINER LABELING - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。