- 您现在的位置：买卖IC网 > PDF目录20147 > ISL9008IEMZ-T (Intersil)IC REG LDO 3V .15A SC70 PDF资料下载
参数资料
| 型号： | ISL9008IEMZ-T |
| 厂商： | Intersil |
| 文件页数： | 9/10页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 3V .15A SC70 |
| 标准包装： | 3,000 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 3V |
| 输入电压： | 最高 6.5V |
| 电压 - 压降（标准）： | 0.2V @ 150mA |
| 稳压器数量： | 1 |
| 电流 - 输出： | 150mA（最小） |
| 电流 - 限制（最小）： | 175mA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-TSSOP（5 引线），SC-88A，SOT-353 |
| 供应商设备封装： | SC-70-5 |
| 包装： | 带卷 (TR) |
ISL9008
Functional Description
The ISL9008 contains all circuitry required to implement a
high performance LDO. High performance is achieved
through a circuit that delivers fast transient response to
varying load conditions. In a quiescent condition, the
ISL9008 adjusts its biasing to achieve the lowest standby
current consumption.
The device also integrates current limit protection, smart
thermal shutdown protection, and soft-start. Smart thermal
shutdown protects the device against overheating. Soft-start
minimizes start-up input current surges without causing
excessive device turn-on time.
Power Control
The ISL9008 has an enable pin, (EN), to control power to the
LDO output. When EN is low, the device is in shutdown
mode. In this condition, all on-chip circuits are off, and the
device draws minimum current, typically less than 0.3μA.
When the EN pin goes high, the device first polls the output
of the UVLO detector to ensure that VIN voltage is at least
2.1V (typical). Once verified, the device initiates a start-up
sequence. During the start-up sequence, trim settings are
first read and latched. Then, sequentially, the bandgap,
reference voltage and current generation circuitry turn-on.
Once the references are stable, the LDO powers-up.
During operation, whenever the VIN voltage drops below
about 1.84V, the ISL9008 immediately disables the LDO
output. When VIN rises back above 2.1V (assuming the EN
pin is high), the device re-initiates its start-up sequence and
LDO operation resumes automatically.
Reference Generation
The reference generation circuitry includes a trimmed
bandgap, a trimmed voltage reference divider, a trimmed
current reference generator, and an RC noise filter.
The bandgap generates a zero temperature coefficient (TC)
voltage for the regulator reference and other voltage
references required for current generation and
over-temperature detection.
A current generator provides references required for
adaptive biasing as well as references for LDO output
current limit and thermal shutdown determination.
LDO Regulation and Programmable Output Divider
The LDO Regulator is implemented with a high-gain
operational amplifier driving a PMOS pass transistor. The
design of the ISL9008 provides a regulator that has low
quiescent current, fast transient response, and overall
stability across all operating and load current conditions.
LDO stability is guaranteed for a 1μF to 4.7μF output
capacitor that has a tolerance better than 20% and ESR less
than 200m Ω . The design is performance-optimized for a 1μF
capacitor. Unless limited by the application, use of an output
capacitor value above 4.7μF is not recommended as LDO
performance improvement is minimal.
Soft-start circuitry integrated into each LDO limits the initial
ramp-up rate to about 30μs/V to minimize current surge. The
ISL9008 provides short-circuit protection by limiting the
output current to about 200mA (typ).
The LDO uses an independently trimmed 1V reference as its
input. An internal resistor divider drops the LDO output voltage
down to 1V. This is compared to the 1V reference for regulation.
The resistor division ratio is programmed in the factory.
Overheat Detection
The bandgap outputs a proportional-to-temperature current
that is indicative of the temperature of the silicon. This
current is compared with references to determine if the
device is in danger of damage due to overheating. When the
die temperature reaches about +140°C, the LDO
momentarily shuts down until the die cools sufficiently. In the
overheat condition, if the LDO sources more than 50mA it
will be shut off. Once the die temperature falls back below
about +110°C, the disabled LDO is re-enabled and soft-start
automatically takes place.
All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without
notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
9
FN9235.1
March 11, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| PSAA60M-150-R-C3 | ADAPTER DESKTOP CLASS I 60W 15V |
| T95R156M050EZSL | CAP TANT 15UF 50V 20% 2824 |
| A121K15X7RK5TAA | CAP CER 120PF 200V 10% X7R AXIAL |
| PSAA60M-150-R-C2 | ADAPTER DESKTOP CLASS I 60W 15V |
| ABE30DHRT | CONN CARD EXTEND 60POS 1MM SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL9008IENZ | 制造商:Intersil Corporation 功能描述: |
| ISL9008IENZ-T | 功能描述:IC REG LDO 3.3V .15A SC70 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，可调式 输出电压:1.25 V ~ 10 V 输入电压:2.9 V ~ 12 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:700mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-VFDFN 裸露焊盘 供应商设备封装:10-DFN（3x3） 包装:Digi-Reel® 其它名称:NCV8535MNADJR2GOSDKR |
| ISL9011 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual LDO with Low Noise, Low IQ, and High PSRR |
| ISL9011_06 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual LDO with Low Noise, Low IQ, and High PSRR |
| ISL9011A | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Dual LDO with Low Noise, Low IQ, and High PSRR |
发布紧急采购，3分钟左右您将得到回复。