参数资料
型号: ISL9305IRTBFNCZ-T
厂商: Intersil
文件页数: 7/17页
文件大小: 771K
描述: IC REG QD BUCK/LINEAR 16TQFN
产品培训模块: Patient Monitoring and Diagnostic Equipment Solutions
标准包装: 6,000
拓扑: 降压(降压)(2),线性(LDO)(2)
功能: 任何功能
输出数: 4
频率 - 开关: 3MHz
电压/电流 - 输出 1: 0.8 V ~ 5.5 V,800mA
电压/电流 - 输出 2: 0.8 V ~ 5.5 V,800mA
电压/电流 - 输出 3: 0.9 V ~ 3.3 V,350mA
带 LED 驱动器:
带监控器:
带序列发生器:
电源电压: 1.5 V ~ 5.5 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 16-WQFN 裸露焊盘
供应商设备封装: 16-TQFN-EP(4x4)
包装: 带卷 (TR)
ISL9305
7
FN7605.1
August 15, 2011
Theory of Operation
DCD1 and DCD2 Introduction
Both the DCD1 and DCD2 converters on ISL9305 use the
peak-current-mode pulse-width modulation (PWM) control scheme
for fast transient response and pulse-by-pulse current limiting.
Both converters are able to supply up to 800mA load current. The
default output voltage ranges from 0.8V to 3.6V depending on the
factory pre-set configuration and can be programmed via the I
2
C
interface in the range of 0.825V to 3.6V at 25mV/step with a
programmable slew rate. An open-drain DCDPG (DCD Power-Good)
signal is also provided to monitor the DCD1 and DCD2 output
voltages. Optionally, both DCD1 and DCD2 can be programmed to
be actively discharged via an on-chip bleeding resistor (typical
115&) when the converter is disabled.
Skip Mode (PFM Mode) for DCD1/DCD2
Under light load condition, the DCD1 and DCD2 can be
programmed to automatically enter a pulse-skipping mode to
minimize the switching loss by reducing the switching frequency.
Figure 2 illustrates the skip mode operation. A zero-cross sensing
circuit monitors the current flowing through the SW node for zero
crossing. When it is detected to cross zero for 16 consecutive
cycles, the regulator enters the skip mode. During the 16
consecutive cycles, the inductor current could be negative. The
counter is reset to zero when the sensed current flowing through
the SW node does not cross zero during any cycle within the 16
consecutive cycles. Once the converter enters the skip mode, the
pulse modulation is controlled by an internal comparator while
each pulse cycle remains synchronized to the PWM clock. The
P-Channel MOSFET is turned on at the rising edge of the clock
and turned off when its current reaches ~20% of the peak
current limit. As the average inductor current in each cycle is
higher than the average current of the load, the output voltage
rises cycle-over-cycle. When the output voltage is sensed to reach
1.5% above its nominal voltage, the P-Channel MOSFET is turned
off immediately and the inductor current is fully discharged to
zero and stays at zero. The output voltage reduces gradually due
to the load current discharging the output capacitor. When the
output voltage drops to the nominal voltage, the P-Channel
MOSFET will be turned on again, repeating the previous
operations.
The regulator resumes normal PWM mode operation when the
output voltage is sensed to drop below 1.5% of its nominal
voltage value as shown in Figure 3.
16 CYCLES
CLOCK
I
L
V
OUT
0
V
OUT_NOMINAL
20% PEAK CURRENT LIMIT
1.015*V
OUT_NOMINAL
FIGURE 2. SKIP MODE OPERATION WAVEFORMS
v
EAMP
 
d
i
L
v
OUT
v
CSA
 
FIGURE 3. PWM OPERATION WAVEFORMS
相关PDF资料
PDF描述
ABM43DRMI CONN EDGECARD 86POS .156 SQ WW
ISL9305IRTBCNLZ-T IC REG QD BUCK/LINEAR 16TQFN
A7NXB-1510G CABLE D-SUB - AMN15B/AE15G/X
RBC05DREH-S13 CONN EDGECARD 10POS .100 EXTEND
ABM40DTMD CONN EDGECARD 80POS R/A .156 SLD
相关代理商/技术参数
参数描述
ISL9305IRTHAANLZ-T 功能描述:电流型 PWM 控制器 DL DC/DC & DLLDO /1 8/1 2/3 TQFN L16 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL9305IRTHBCNLZ-T 功能描述:电流型 PWM 控制器 DL DC/DC & DLLDO /1 8/1 2/3 TQFN L16 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL9305IRTHBFNCZ-T 功能描述:电流型 PWM 控制器 DL DC/DC & DLLDO /1 8/1 2/3 TQFN L16 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL9305IRTHWBNLZ-T 功能描述:电流型 PWM 控制器 DL DC/DC & DLLDO /1 8/1 2/3 TQFN L16 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14
ISL9305IRTHWCLBZ-T 功能描述:电流型 PWM 控制器 DL DC/DC & DLLDO /1 8/1 2/3 TQFN L16 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14