- 您现在的位置：买卖IC网 > Datasheet目录336 > KIT34713EPEVBE (Freescale Semiconductor)KIT EVAL BOARD 5A 1MHZ Datasheet资料下载
参数资料
| 型号： | KIT34713EPEVBE |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 13/23页 |
| 文件大小： | 0K |
| 描述： | KIT EVAL BOARD 5A 1MHZ |
| 标准包装： | 1 |
| 系列： | * |
FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
SD = 0
V IN < 3.0 V
Power Off
Shutdown
V OUT = Discharge
V REF = Discharge
PG = 1
V OUT =OFF
V R EF =OFF
PG = 1
3.0 V<=V IN <=6.0 V
SD = 1
I OUT >=I SHORT
V OUT >V OV
Over-voltage
V OUT =ON
V REF =ON
PG = 1
V OUT <V OV
V OUT >V UV
Normal
V TT = ON
V REF =ON
PG = 0
T J <=145°C
T IMEOUT Expired
T IMEOUT
Expired
T IMEOUT
Expired
Short-circuit
V OUT =OFF
V REF =OFF
PG = 1
V OUT <V UV
Under-voltage
V OUT =ON
V REF =ON
PG = 1
Thermal Shutdown
V OUT =OFF
V REF =OFF
PG = 1
Over-current
V OUT =OFF
V REF =ON
PG = 1
I OUT1 >=I LIM1
For>=10 ms
T J >= 170°C
Figure 5. Operation Modes Diagram
MODES OF OPERATION
The 34713 has two primary modes of operation:
Normal Mode
In normal mode, all functions and outputs are fully
operational. To be in this mode, the V IN needs to be within its
operating range, Shutdown input is high, and no faults are
present. This mode consumes the most amount of power.
Shutdown Mode
In this mode, activated by pulling the SD pin low, the chip
is in a shutdown state and the output is disabled and
discharged. In this mode, the 34713 consumes the least
amount of power since almost all of the internal blocks are
disabled.
START-UP SEQUENCE
When power is first applied, the 34713 checks the status
of the SD pin. If the device is in a shutdown mode, no block
will power up and the output will not attempt to ramp. Once
the SD pin is released to enable the device, the V DDI internal
supply voltage and the bias currents are established and the
internal V DDI POR signal is also released. The rest of the
internal blocks will be enabled and the buck converter
switching frequency and soft start values are determined by
reading the FREQ and ILIM pins respectively. A soft start
cycle is then initiated to ramp up the output of the buck
converter. The buck converter error amplifier uses the
voltage on the VREFIN pin as its reference voltage until
V REFIN is equal to 0.7 V, then the error amplifier defaults to
the internal 0.7 V reference voltage. This method helps
achieve multiple tracking configurations as will be explained
later in this document.
Soft start is used to prevent the output voltage from
overshooting during startup. At initial startup, the output
capacitor is at zero volts; V OUT = 0 V. Therefore, the voltage
across the inductor will be PV IN during the capacitor charge
phase which will create a very sharp di/dt ramp. Allowing the
inductor current to rise too high can result in a large
difference between the charging current and the actual load
current that can result in an undesired voltage spike once the
capacitor is fully charged. The soft start is active each time
the IC goes out of standby or shutdown mode, power is
recycled, or after a fault retry.
After a successful start-up cycle where the device is
enabled, no faults have occurred, and the output voltage has
reached its regulation point, the 34713 pulls the power good
34713
Analog Integrated Circuit Device Data
Freescale Semiconductor
13
相关PDF资料 |
PDF描述 |
|---|---|
| KIT34716EPEVBE | KIT EVAL BOARD 1MHZ DUAL SW-MODE |
| KIT34717EPEVBE | KIT EVAL BOARD 5A 1.0MHZ |
| KS-1787-MG | SHELF SLIDING KEYBOARD ASSEMBLY |
| KS-1788 | SHELF SLIDING KEYBOARD ASSEMBLY |
| KSDKSTM32-PL | KIT IAR KICKSTART STM32 CORTEXM3 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KIT34716EPEVBE | 功能描述:电源管理IC开发工具 1.0 MHZ DUAL SWITCH-MODE RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| KIT34717EPEVBE | 功能描述:电源管理IC开发工具 5.0 A 1.0MHZ FULLY INTEG RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| KIT34727FCEVBE | 功能描述:电源管理IC开发工具 600MA HIGH EFFICIENCY LO RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| KIT34825EPEVME | 功能描述:界面开发工具 MICRO USB INTERFACE IC RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
| KIT34844AEPEVBE | 功能描述:LED 照明开发工具 IC, 10 CHANNEL LED BACKLIGHT RoHS:否 制造商:Fairchild Semiconductor 产品:Evaluation Kits 用于:FL7732 核心: 电源电压:120V 系列: 封装: |
发布紧急采购，3分钟左右您将得到回复。