参数资料
| 型号： | KSZ8051RNL |
| 厂商： | Micrel Inc |
| 文件页数： | 17/59页 |
| 文件大小： | 0K |
| 描述： | TXRX PHY 10/T100 3.3V RMII 32QFN |
| 特色产品： | KSZ8051RNL Physical Layer Transceiver |
| 标准包装： | 640 |
| 类型： | PHY 收发器 |
| 驱动器/接收器数： | 1/1 |
| 规程： | RMII |
| 电源电压： | 1.8V，2.5V，3.3V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-QFN 裸露焊盘（5x5） |
| 包装： | 托盘 |
| 其它名称： | 576-3713 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页
Micrel, Inc.
KSZ8051MNL/RNL
July 2010
24
M9999-070910-1.0
RMII Data Interface (KSZ8051RNL only)
The Reduced Media Independent Interface (RMII) specifies a low pin count Media Independent Interface (MII). It provides
a common interface between physical layer and MAC layer devices, and has the following key characteristics:
Pin count is 8 pins (3 pins for data transmission, 4 pins for data reception, 1 pin for the 50MHz reference clock).
10Mbps and 100Mbps data rates are supported at both half and full duplex.
Data transmission and reception are independent and belong to separate signal groups.
Transmit data and receive data are each 2-bit wide, a dibit.
RMII – 25MHz Clock Mode
The KSZ8051RNL is configured to RMII – 25MHz Clock Mode after it is powered up or hardware reset with the following:
A 25MHz crystal connected to XI, XO (pins 9, 8), or an external 25MHz clock source (oscillator) connected to XI.
The CONFIG[2:0] strapping pins (pins 18, 29, 28) set to ‘001’.
Register 1Fh, bit 7 is set to ‘0’ (default value) to select 25MHz Clock Mode.
RMII – 50MHz Clock Mode
The KSZ8051RNL is configured to RMII – 50MHz Clock Mode after it is powered up or hardware reset with the following:
An external 50MHz clock source (oscillator) connected to XI (pin 9).
The CONFIG[2:0] strapping pins (pins 18, 29, 28) set to ‘001’.
Register 1Fh, bit 7 is set to ‘1’ to select 50MHz Clock Mode.
RMII Signal Definition
The following table describes the RMII signals. Refer to RMII Specification v1.2 for detailed information.
RMII
Signal Name
Direction
(with respect to PHY,
KSZ8051RNL signal)
Direction
(with respect to
MAC)
Description
REF_CLK
Output (25MHz clock mode) /
<no connect> (50MHz clock
mode)
Input /
Input or <no connect>
Synchronous 50 MHz reference clock for
receive, transmit and control interface
TXEN
Input
Output
Transmit Enable
TXD[1:0]
Input
Output
Transmit Data [1:0]
CRS_DV
Output
Input
Carrier Sense/Receive Data Valid
RXD[1:0]
Output
Input
Receive Data [1:0]
RXER
Output
Input, or (not
required)
Receive Error
Table 2. RMII Signal Description
Reference Clock (REF_CLK)
REF_CLK is a continuous 50MHz clock that provides the timing reference for TX_EN, TXD[1:0], CRS_DV, RXD[1:0], and
RX_ER.
For 25MHz Clock Mode, the KSZ8051RNL generates and outputs the 50MHz RMII REF_CLK to the MAC at REF_CLK
(pin 19).
For 50MHz Clock Mode, the KSZ8051RNL takes in the 50MHz RMII REF_CLK from the MAC or system board at XI (pin
9) and has the REF_CLK (pin 19) left as a no connect.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B4M-MW-F3 | CONVERTER MOD DC/DC 10V 100W |
| VE-J5T-MX-F3 | CONVERTER MOD DC/DC 6.5V 75W |
| VE-B1X-MW-F1 | CONVERTER MOD DC/DC 5.2V 100W |
| LT1785HN8#TRPBF | IC TXRX RS485/RS422 60V 8-DIP |
| VE-B1W-MW-F2 | CONVERTER MOD DC/DC 5.5V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ8051RNL AM | 功能描述:以太网 IC Single-Port 10/100BT PHY (Automotive) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8051RNL AM TR | 功能描述:以太网 IC Single-Port 10/100BT PHY (Automotive) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8051RNL TR | 功能描述:以太网 IC 3.3V, 10Base-T/100Base-TX Physical Layer Transceiver w/ RMII Support (32-QFN) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8051RNL-EVAL | 功能描述:以太网开发工具 3.3V, 10Base-T/100Base-TX Physical Layer Transceiver w/ RMII Support (32-QFN) - Evaluation Board RoHS:否 制造商:Micrel 产品:Evaluation Boards 类型:Ethernet Transceivers 工具用于评估:KSZ8873RLL 接口类型:RMII 工作电源电压: |
| KSZ8051RNLI | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:10Base-T/100Base-TX Physical Layer Transceiver |
发布紧急采购，3分钟左右您将得到回复。