- 您现在的位置：买卖IC网 > PDF目录97994 > L4977A (STMICROELECTRONICS) 11 A SWITCHING REGULATOR, 500 kHz SWITCHING FREQ-MAX, PZFM15 PDF资料下载
参数资料
| 型号： | L4977A |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 11 A SWITCHING REGULATOR, 500 kHz SWITCHING FREQ-MAX, PZFM15 |
| 封装： | PLASTIC, POWER PACK-15 |
| 文件页数： | 17/21页 |
| 文件大小： | 6754K |
| 代理商： | L4977A |
stability of the loop can be adjusted by an exter-
nal RC network connected to the output of the er-
ror amplifier. A voltage feedforward control has
been added to the oscillator, this maintains supe-
rior line regulation over a wide input voltage
range. Closing the loop directly gives an output
voltage of 5.1V, higher voltages are obtained by
inserting a voltage divider.
At turn on output overcurrents are prevented by
the soft start function (fig. 2). The error amplifier is
initially clamped by an external capacitor Css and
allowed to rise linearly under the charge of an in-
ternal constant current source.
Output overload protection is provided by a cur-
rent limit circuit (fig. 3). The load current is sensed
by an internal metal resistor connected to a com-
parator. When the load current exceeds a preset
threshold the output of the comparator sets a flip
flop which turns off the power DMOS. The next
clock pulse, from an internal 40kHz oscillator will
reset the flip flop and the power DMOS will again
conduct. This current protection method, ensures
a constant current output when the system is
overloaded or short circuited and limits the
switching frequency, in this condition, to 40kHz.
The Reset and Power fail circuitry (fig 4) gener-
ates an output signal when the supply voltage ex-
ceeds a threshold programmed by an external
voltage divider. The reset signal, is generated
with a delay time programmed by an external ca-
pacitor on the delay pin. When the supply voltage
falls below the threshold or the output voltage
goes below 5V the reset output goes low immedi-
ately. The reset output is an open collector-drain.
Fig 4A shows the case when the supply voltage is
higher than the threshold, but the output voltage
is not yet 5V.
Fig 4B shows the case when the output is 5.1V
but the supply voltage is not yet higher than the
fixed threshold.
The thermal protection disables circuit operation
when the junction temperature reaches about
150
°C and has an hysterysis to prevent unstable
conditions.
Figure 4: Reset and Power Fail Functions.
A
B
L4977A
5/21
相关PDF资料 |
PDF描述 |
|---|---|
| L4978D013TR | 3.5 A SWITCHING REGULATOR, 300 kHz SWITCHING FREQ-MAX, PDSO16 |
| L4978 | 3.5 A SWITCHING REGULATOR, 300 kHz SWITCHING FREQ-MAX, PDIP8 |
| L497B | SPECIALTY ANALOG CIRCUIT, PDIP16 |
| L4981BD013TR | 2 A POWER FACTOR CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO20 |
| L4985D | 1.5 A SWITCHING REGULATOR, 83 kHz SWITCHING FREQ-MAX, PDSO20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L4977HT | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Voltage-Mode SMPS Controller |
| L4978 | 功能描述:直流/直流开关调节器 3.3 to 50V Step-Down RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| L4978_05 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:2A STEP DOWN SWITCHING REGULATOR |
| L4978D | 功能描述:直流/直流开关调节器 3.3 to 50V Step-Down RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| L4978D013TR | 功能描述:直流/直流开关调节器 3.3 to 50V Step-Down RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。