- 您现在的位置：买卖IC网 > PDF目录80246 > L5970ADTR (STMICROELECTRONICS) 1.8 A SWITCHING REGULATOR, 500 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | L5970ADTR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 1.8 A SWITCHING REGULATOR, 500 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | SO-8 |
| 文件页数： | 9/11页 |
| 文件大小： | 139K |
| 代理商： | L5970ADTR |
7/11
L5970AD
The turn on of the power element, or better, the rise time of the current at turn on, is a very critical param-
eter to compromise.
At a first approach, it looks like the faster it is the rise time, the lower are the turn on losses.
But there is a limit introduced by the recovery time of the recirculation diode.
In fact when the current of the power element equals the inductor current, the diode turns off and the drain
of the power is free to go high. But during its recovery time, the diode can be considered as an high value
capacitor and this produces a very high peak current, responsible of many problems:
Spikes on the device supply voltage that cause oscillations (and thus noise) due to the board parasitics.
Turn on overcurrent causing a decrease of the efficiency and system reliability.
Big EMI problems.
Shorter freewheeling diode life.
The fall time of the current during the turn off is also critical. In fact it produces voltage spikes (due to the
parasitics elements of the board) that increase the voltage drop across the PDMOS.
In order to minimize all these problems, a new topology of driving circuit has been used and its block dia-
gram is shown in fig. 8.
The basic idea is to change the current levels used to turn on and off the power switch, according with the
PDMOS status and with the gate clamp status.
This circuitry allow to turn off and on quickly the power switch and to manage the above question related
to the freewheeling diode recovery time problem. The gate clamp is necessary to avoid that Vgs of the
internal switch goes higher than Vgsmax. The ON/OFF Control block avoids any cross conduction be-
tween the supply line and ground.
Figure 8. Driving Circuitry
3.7 INHIBIT FUNCTION
The inhibit feature allows to put in stand-by mode the device. With INH pin higher than 2.2V the device is dis-
abled and the power consumption is reduced to less than 100
A. With INH pin lower than 0.8V, the device is
enabled. If the INH pin is left floating, an internal pull up ensures that the voltage at the pin reaches the inhibit
threshold and the device is disabled. The pin is also Vcc compatible.
Vgsmax
GATE
STOP
DRIVE
DRAIN
OFF
ON
PDMOS
VOUT
DRAIN
VCC
ILOAD
C
ESR
D00IN1133
IOFF
ION
ON/OFF
CONTROL
CLAMP
L
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3858EUH-2#TRPBF | DUAL SWITCHING CONTROLLER, 900 kHz SWITCHING FREQ-MAX, PQCC32 |
| LM2670SDADJEP | 5.4 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO14 |
| LTC3900MPS8 | SWITCHING REGULATOR, PDSO8 |
| LM336H-2.5 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.49 V, MBCY3 |
| LPC48DP | 2-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L5970D | 功能描述:直流/直流开关调节器 1.2 to 35V Step-Down RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| L5970D_07 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Up to 1A step down switching regulator |
| L5970D_0710 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Up to 1A step down switching regulator |
| L5970D013 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:UP TO 1A STEP DOWN SWITCHING REGULATOR |
| L5970D013TR | 功能描述:直流/直流开关调节器 1.2 to 35V Step-Down RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。