参数资料
型号: L6246
厂商: STMICROELECTRONICS
元件分类: 运动控制电子
英文描述: VOICE COIL MOTOR CONTROLLER, 3 A, PQFP44
封装: 10 X 10 MM, PLASTIC, QFP-44
文件页数: 10/12页
文件大小: 162K
代理商: L6246
Obsolete
Product(s)
- Obsolete
Product(s)
POWER SUPPLY MONITOR
This circuit monitors the logic supply (5V) and the
power supply (12V) and activates the power on
reset output (POR) and the VCM PARK circuit.
After both logic and power supply reach their
nominal value a timing capacitor (T_CAP) has to
be charge before the POR output change from
low to high level.
POR delay
=
C
V
I
where:
C is the capacitor value connected at pin
T_CAP
V is delta voltage that capacitor have to be
charged (2.3V)
I is the costant current charging the capacitor
(4
A typ.)
At the two input pins, +12 FILTER CAP and + 5
FILTER CAP, can be connected two capacitors
for filtering the noise on the power supply, avoid-
ing in this case undesired commutations of the
POR signal because of some fast negative spikes
on the line.
BRAKE AND PARKING CIRCUITS
The voice coil driver is switched into the parking
condition through the VCM PARK input or when
the POR signal is low. In such condition immedi-
ately the output stage turns on the two lower
DMOS of the power bridge to activate the BRAKE
of the voice coil motor.
After a delay generated by the capacitor at the
BRAKE DELAY pin, only one of the two lower
DMOS stays on while the opposite half bridge is
tristated.
BRAKE delay
=
C
V
I
where:
C is the capacitor value connected at pin
BRAKE DELAY
V is delta voltage that capacitor have to be
charged (3V)
I is the costant current charging the capacitor
(5
A typ.)
The parking voltage is then supplied by the
PARKING circuit connected to the output that has
been tristated.
The value of such a voltage is set by connecting
an external resistor between the RPARK pin and
ground.
Vr
=
Vbandgap
104
Rpark
where:
Vr is the retract voltage for parking the heads
Vbandgap is the internal bandgap reference
voltage of 1.4V
Rpark is value of the resistor connected at
RPARK pin
The parking circuit takes the power supply from
the spindle driver through the VBEMF pin, so that
in case of power fail the retract of the heads is
possible using the rectified BEMF voltage coming
from the spindle motor.
CHARGE PUMP
The charge pump circuit is used as a means of al-
most doubling the power supply voltage (12V) in
order to drive the upper DMOS of the power
bridge.
The energy stored in the in the capacitor con-
nected at VCP pin is also used to drive the gate
of the external N-MOSFET.
GATE DRIVER
This circuit provide the voltage driving the gate of
the external isolation N-MOSFET, and it is con-
trolled by the POR signal.
THERMAL
The thermal protection circuit has two threshold,
the first if the pre shut down alarm that activates
the THERMAL SD signal and the second is the
shut down temperature that tristates the output
stage when the junction temperature increases
over this level.
APPLICATION INFORMATION
Example of calculation of the error amplifier com-
pansation for the stability of the current control
loop. As can be seen from the draw of the current
control loop circuit of the next page, the voltage
across the load is:
#1
VL = ACPW
ACERR (ACINP VIN - ACENSE Vsense)
Vsense = Rs
IL
VL = ( ZL + Rs)
IL
where AC... is the closed loop gain of Power, Er-
ror, Sense and Input Amplifier.
Changing in the #1 the transfer function between
the load current and the VIN is:
#2
IL
VIN
=
ACPW
ACERR
ACINP
ZL
+ RS + ACPW ACERR ACSENSE RS
L6246
7/12
相关PDF资料
PDF描述
L6258EA STEPPER MOTOR CONTROLLER, 2 A, PDSO36
L6268 VOICE COIL MOTOR CONTROLLER, 2.1 A, PQFP44
L6269 VOICE COIL MOTOR CONTROLLER, 2.1 A, PQFP44
L6280 STEPPER MOTOR CONTROLLER, 4.4 A, PQCC44
L6285S STEPPER MOTOR CONTROLLER, 2 A, PDIP42
相关代理商/技术参数
参数描述
L624F 制造商:未知厂家 制造商全称:未知厂家 功能描述:THYRISTOR MODULE|BRIDGE|HALF-CNTLD|CA|480V V(RRM)|42.5A I(T)
L625 制造商:Lufkin 功能描述:25' Ultralok Tape Measure 制造商:Lufkin 功能描述:LUFKIN 25 FEET ULTRALOK TAPE MEASURE, COLOR: HI-VIZ ORANGE, WIDTH: 1 , FEATURES: ONE PIECE SLIDE LOCK HOLDS BLADE FIRMLY AT ANY LENGTH, BUILT-IN SHOCK ABSORBER CUSHIONS BLADE RETURN & PROTECTS END HOOK, FEET, INCH MARKS & STUD MARKIN
L6-250BLU 功能描述:JUMPER 0.025" SQ SOCKET 6" BLUE RoHS:是 类别:测试设备 >> 测试引线 - 跳线,专用型 系列:E-Z-LINK 标准包装:1 系列:MG-B 配置:短头鳄鱼夹至短头鳄鱼夹 第一连接器:接线夹,微型,绝缘 第二连接器:接线夹,微型,绝缘 线缆长度:60.0"(1524.00mm) 所含物品:1 根引线,橙 材料 - 绝缘体:聚氯乙烯(PVC) 线规:18 AWG 电压 - 额定:33VAC,70VDC 额定电流:5A 温度范围:122°F(50°C) 其它名称:5995008270878
L6254 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:12V DISK DRIVE SPINDLE & VCM, POWER & CONTROL “COMBO”
L6256 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:12V COMBO