参数资料
型号: L6382D5
厂商: STMICROELECTRONICS
元件分类: 电源管理
英文描述: 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20
封装: ROHS COMPLIANT , SOP-20
文件页数: 8/21页
文件大小: 267K
代理商: L6382D5
Block description
L6382D5
16/21
6.3
Drivers
LSD (Low Side Driver): it consists of a level shifter from 5V logic signal (LSI) to Vcc
MOS driving level; conceived for the half-bridge low-side power MOS, it is able to
source and sink 120mA (min).
HSD (Level Shifter and High Side Driver): it consists of a level shifter from 5V logic
signal (HSI) to the high side gate driver input up to 600V. Conceived for the half-bridge
high-side power MOS, the HSD is able to source and sink 120mA.
PFD (Power Factor Driver): it consists of a level shifter from 5V logic signal (PFI) to Vcc
MOS driving level: the driver is able to source 120mA from VCC to PFG (turn-on) and to
sink 250mA to GND (turn-off); it is suitable to drive the MOS of the PFC pre-regulator
stage.
HED (Heat Driver): it consists of a level shifter from 5V logic signal (HEI) to Vcc MOS
driving level; the driver is able to source 30mA from Vcc to HEG and to sink 75mA to
GND and it is suitable for the filament heating when they are supplied by independent
winding.
Bootstrap Circuit: it generates the supply voltage for the high side Driver (HSD). This
circuit sources current from VCC to PIN HSB when LSG in ON. A patented integrated
bootstrap section replaces an external bootstrap diode. This section together with a
bootstrap capacitor provides the bootstrap voltage to drive the high side power
MOSFET. This function is achieved using a high voltage DMOS driver which is driven
synchronously with the low side external power MOSFET. For a safe operation, current
flow between BOOT pin and Vcc is always inhibited, even though ZVS operation may
not be ensured.
6.4
Internal logic, over current protection (OCP) and interlocking
function
The DIM (Digital Input Monitor) block manages the input signals delivered to the drivers
ensuring that they are low during the described start-up procedure; the DIM block controls
the L6382D5 behaviour during both save and operating modes.
When the voltage on pin CSI overcomes the internal reference of 0.54V (typ.) the block
latches the fault condition: in this state the OCP block forces low both HSG and LSG signals
while CSO will be forced high. This condition remains latched until LSI and HSI are
simultaneously low and CSI is below 0.54V.
This function is suitable to implement an over current protection or hard-switching detection
by using an external sense resistor.
As the voltage on pin CSI can go negative, the current must be limited below 2mA by
external components.
Another feature of the DIM block is the internal interlocking that avoids cross-conduction in
the half-bridge FET's: if by chance both HSI and LSI input's are brought high at the same
time, then LSG and HSG are forced low as long as this critical condition persists.
相关PDF资料
PDF描述
L64005-F SPECIALTY CONSUMER CIRCUIT, PQFP160
L64007 SPECIALTY CONSUMER CIRCUIT, PQFP160
L64013A1 SPECIALTY CONSUMER CIRCUIT, PQFP100
L64014A SPECIALTY CONSUMER CIRCUIT, PQFP144
L64015 SPECIALTY CONSUMER CIRCUIT, PQFP144
相关代理商/技术参数
参数描述
L6382D5TR 功能描述:功率因数校正 IC Pwr management unit RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
L6382DTR 功能描述:电池管理 Pwr management unit RoHS:否 制造商:Texas Instruments 电池类型:Li-Ion 输出电压:5 V 输出电流:4.5 A 工作电源电压:3.9 V to 17 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:VQFN-24 封装:Reel
L6384 功能描述:功率驱动器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
L6384 制造商:STMicroelectronics 功能描述:600V HALF BRIDGE DRIVER 6384 DIP8
L6384D 功能描述:功率驱动器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube