参数资料
型号: L6563S
厂商: STMICROELECTRONICS
元件分类: 稳压器
英文描述: POWER FACTOR CONTROLLER, PDSO14
封装: ROHS COMPLIANT, SOP-14
文件页数: 21/42页
文件大小: 1230K
代理商: L6563S
Application information
L6563S
28/42
Doc ID 16116 Rev 3
Essentially, the circuit artificially increases the ON-time of the power switch with a positive
offset added to the output of the multiplier in the proximity of the line voltage zero-crossings.
This offset is reduced as the instantaneous line voltage increases, so that it becomes
negligible as the line voltage moves toward the top of the sinusoid. Furthermore the offset is
modulated by the voltage on the VFF pin (see “Voltage Feedforward” section) so as to have
little offset at low line, where energy transfer at zero crossings is typically quite good, and a
larger offset at high line where the energy transfer gets worse.
The effect of the circuit is shown in Figure 39, where the key waveforms of a standard TM
PFC controller are compared to those of this chip.
To take maximum benefit from the THD optimizer circuit, the high-frequency filter capacitor
after the bridge rectifier should be minimized, compatibly with EMI filtering needs. A large
capacitance, in fact, introduces a conduction dead-angle of the AC input current in itself -
even with an ideal energy transfer by the PFC pre-regulator - thus reducing the effectiveness
of the optimizer circuit.
6.5
Tracking boost function
In some applications it may be advantageous to regulate the output voltage of the PFC pre-
regulator so that it tracks the RMS input voltage rather than at a fixed value like in
conventional boost pre-regulators. This is commonly referred to as “tracking boost” or
“follower boost” approach.
With the L6563S this can be realized by connecting a resistor (RT) between the TBO pin
and ground. The TBO pin presents a DC level equal to the peak of the MULT pin voltage and
is then representative of the mains RMS voltage. The resistor defines a current, equal to
V(TBO)/RT, that is internally 1:1 mirrored and sunk from pin INV (#1) input of the L6563S's
error amplifier. In this way, when the mains voltage increases the voltage at TBO pin will
increase as well and so will do the current flowing through the resistor connected between
TBO and GND. Then a larger current will be sunk by INV pin and the output voltage of the
PFC pre-regulator will be forced to get higher. Obviously, the output voltage will move in the
opposite direction if the input voltage decreases.
To avoid undesired output voltage rise should the mains voltage exceed the maximum
specified value, the voltage at the TBO pin is clamped at 3V. By properly selecting the
multiplier bias it is possible to set the maximum input voltage above which input-to-output
tracking ends and the output voltage becomes constant. If this function is not used, leave
the pin open: the device will regulate a fixed output voltage.
Starting from the following data:
Vin1 = minimum specified input RMS voltage;
Vin2 = maximum specified input RMS voltage;
Vo1 = regulated output voltage @ Vin = Vin1;
Vo2 = regulated output voltage @ Vin = Vin2;
Vox = absolute maximum limit for the regulated output voltage;
to set the output voltage at the desired values use the following design procedure:
相关PDF资料
PDF描述
L6564DTR SWITCHING CONTROLLER, PDSO10
L6564D SWITCHING CONTROLLER, PDSO10
L6585DE POWER FACTOR CONTROLLER, PDSO20
L6585DETR POWER FACTOR CONTROLLER, PDSO20
L6598 SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDIP16
相关代理商/技术参数
参数描述
L6563STR 功能描述:功率因数校正 IC Transition Mode PFC 5mA 90uA 1.5% Ref RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
L6563TR 功能描述:功率因数校正 IC POWER SUPPLY RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel
L6564 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:10 pin transition-mode PFC controller
L6564D 功能描述:IC PFC CTRLR TRANSITION 10SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - PFC(功率因数修正) 系列:- 产品培训模块:GreenChip Synchronous Rectification Control Family of ICs 标准包装:1 系列:- 模式:间歇导电(DCM) 频率 - 开关:- 电流 - 启动:- 电源电压:8.6 V ~ 38 V 工作温度:-20°C ~ 150°C 安装类型:表面贴装 封装/外壳:14-SOIC(0.154",3.90mm 宽) 供应商设备封装:14-SO 包装:Digi-Reel® 其它名称:568-5348-6
L6564DTR 功能描述:功率因数校正 IC Transition Mode PFC 5mA 90uA 1.5% Ref RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel