- 您现在的位置：买卖IC网 > PDF目录43900 > L6585D (STMICROELECTRONICS) 0.6 A POWER FACTOR AND FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO20 PDF资料下载
参数资料
| 型号： | L6585D |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | 0.6 A POWER FACTOR AND FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封装： | LEAD FREE, SOP-20 |
| 文件页数： | 9/25页 |
| 文件大小： | 1478K |
| 代理商： | L6585D |
L6585D
Half-bridge current control
17/25
7
Half-bridge current control
The information about the lamp current can be obtained by reading the voltage across a
sense resistor placed in series to the source of the half-bridge low side MOS.
This circuitry is enabled at the end of the pre-heating phase and it enriches the L6585D with
two features:
●
Controlled lamp voltage/current during ignition (Figure 5): by properly setting the
sense resistor (such that the VHBCS level is crossed in correspondence of a lamp
voltage higher than the ignition voltage) it is possible to limit the maximum lamp voltage
during ignition. In case of this occurrence, then the L6585D would react with a small
frequency increase that allows limiting the lamp voltage (V+IGN). This also prevents the
risk of crossing the resonance frequency of the LBALLAST-CRES circuit. If the lamp
–
EOI internal switch opens and its voltage moves asymptotically to 2V
–
The switching frequency reaches the operating one;
–
When TCH reaches 1.52, it will be discharged
If instead that the lamp hasn’t ignited after a time equal to the pre-heat time (Figure 5
right) the oscillator stops, the chip enters low consumption mode and this condition is
latched until the mains supply voltage is removed or a re-lamp is detected.
●
Over-current protection during run mode: if the HBCSL threshold is crossed, the TCH
internal generator is turned on as well as the one at pin EOI causing a frequency
increase: this implements a current control structure.
During run mode another protection is active: a second comparator (HBCSH) on the pin
HBCS detects anomalous current flow through the sense resistor such as the spikes
generated by the capacitive mode; the crossing of this second threshold latches the IC.
相关PDF资料 |
PDF描述 |
|---|---|
| L6585DTR | 0.6 A POWER FACTOR AND FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6590AN | 0.7 A SWITCHING REGULATOR, 74 kHz SWITCHING FREQ-MAX, PDIP8 |
| L6590D013TR | 0.7 A SWITCHING REGULATOR, 74 kHz SWITCHING FREQ-MAX, PDSO16 |
| L6590D | 0.7 A SWITCHING REGULATOR, 74 kHz SWITCHING FREQ-MAX, PDSO16 |
| L6591TR | SWITCHING CONTROLLER, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L6585D_07 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Combo IC for PFC and ballast control |
| L6585DE | 功能描述:功率因数校正 IC Combo IC for PFC Ballast control RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| L6585DETR | 功能描述:功率因数校正 IC Combo IC for PFC and ballast control RoHS:否 制造商:Fairchild Semiconductor 开关频率:300 KHz 最大功率耗散: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Reel |
| L6585DTR | 功能描述:DC/DC 开关控制器 Combo IC RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| L6590 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:FULLY INTEGRATED POWER SUPPLY FIPS |
发布紧急采购，3分钟左右您将得到回复。