参数资料
型号: L6714
厂商: STMICROELECTRONICS
元件分类: 稳压器
英文描述: SWITCHING CONTROLLER, 170 kHz SWITCHING FREQ-MAX, PQFP64
封装: 10 X 10 MM, LEAD FREE, TQFP-64
文件页数: 69/70页
文件大小: 694K
代理商: L6714
Pin settings
L6714
8/70
15
VCC
Device supply voltage. The operative voltage is 12V ±15%. Filter with 1F (typ)
MLCC vs. SGND.
16
DAC/
CS_SEL
DAC and Current Sense SELection Pin.
This pin sources a constant 12.5A current. By connecting a resistor vs. SGND
it is possible to select between Intel and AMD integrated DACs and Current
Sense methods.
Filter with 100pF(max) vs. SGND.
DACs and Current Sense methods cannot be changed dynamically.
17
OUTEN
OUTput ENable Pin.
Forced low, the device stops operations with all MOSFET OFF: all the
protections are disabled except for Section 16.2: Preliminary over voltage on
Set free, the device starts-up implementing soft-start up to the selected VID
code.
Cycle this pin to recover latch from protections; filter with 1nF (typ) vs. SGND.
18
SSOSC/
REF
Intel Mode. Soft Start OSCillator Pin.
By connecting a resistor RSSOSC vs. SGND, it allows programming the frequency
FSS of an internal additional oscillator that drives the reference during Soft-Start.
Setting this frequency allows programming the Soft-Start time TSS proportionally
to the RSSOSC connected with a gain of 20.1612 [s / k]. The same slope
implemented to reach VBOOT has to be considered also when the reference
moves from VBOOT to the programmed VID code. See “Soft start” Section for
details.
AMD Mode. REFerence Output. Filter with 47
- 4.7nF vs. SGND.
19
SGND
All the internal references are referred to this pin. Connect to the PCB Signal
Ground.
20
VSEN
Remote Buffer Output, it manages OVP and UVP protections and PGOOD
See Table 10 for details.
21
DROOP
A current proportional to the total current read is sourced from this pin according
to the Current Reading Gain.
Short to FB to implement Droop Function or Short to SGND to disable the
function.Connecting to SGND through a resistor and filtering with a capacitor,
the current info can be used for other purposes.
22
FB
Error Amplifier Inverting Input. Connect with a resistor RFB vs. VSEN and with an
RF - CF vs. COMP.
23
COMP
Error Amplifier Output. Connect with an RF - CF vs. FB.
The device cannot be disabled by pulling down this pin.
24
CS4+
Channel 4 Current Sense Positive Input.
LS Mosfet Sense: connect through a resistor Rg to the LS mosfet Source.
Inductor DCR Sense: connect through an R-C filter to the phase-side of the
channel 4 inductor.
See “Layout guidelines” Section for proper layout of this connection.
Table 1.
Pin functions
Pin
Function
相关PDF资料
PDF描述
L6725TR 20 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16
L6728ATR SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10
L6728A SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10
L6728D 30 A SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO10
L6911C 1.3 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20
相关代理商/技术参数
参数描述
L6714TR 功能描述:功率驱动器IC 4 Phase Controller RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
L6716 制造商:STMicroelectronics 功能描述:DC DC Cntrlr Quad-OUT Sync Step Down 48-Pin VFQFPN EP Tray 制造商:STMicroelectronics 功能描述:HANDHELD & COMPUTER PM - Trays 制造商:STMicroelectronics 功能描述:2/3/4 Phase Controlr Embedded Driver
L6716TR 功能描述:开关变换器、稳压器与控制器 2/3/4 phase CNTRL Embedded Drivers RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
L6717 制造商:STMicroelectronics 功能描述:High-Efficiency Hybrid AM2r2 Controller 48-Pin VFQFPN Tray 制造商:STMicroelectronics 功能描述:HANDHELD & COMPUTER PM - Trays 制造商:STMicroelectronics 功能描述:High EFF Hybrid CTRL I2C Embedded Driver
L6717A 制造商:STMicroelectronics 功能描述:CPU Power Supply Controller Tray 制造商:STMicroelectronics 功能描述:HANDHELD & COMPUTER PM - Trays 制造商:STMicroelectronics 功能描述:High EFF Hybrid CTRL I2C Embedded Driver