- 您现在的位置：买卖IC网 > PDF目录43900 > L6728AHTR (STMICROELECTRONICS) SWITCHING CONTROLLER, PDSO10 PDF资料下载
参数资料
| 型号： | L6728AHTR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO10 |
| 封装： | 3 X 3 MM, ROHS COMPLIANT, VFDFPN-10 |
| 文件页数： | 3/33页 |
| 文件大小： | 1033K |
| 代理商： | L6728AHTR |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
L6728AH
Soft-start
Doc ID 15726 Rev 1
11/33
6
Soft-start
L6728AH implements a soft-start to smoothly charge the output filter avoiding high in-rush
currents to be required from the input power supply. The device gradually increases the
internal reference from 0 V to 0.8 V in 4.5 msec (typ.), in closed loop regulation, linearly
charging the output capacitors to the final regulation voltage. A pre-charged output voltage
will affect the soft-start duration, resulting in a reduction of this period of time (< 4 msec).
During the soft-start process all the protections but the UVP are active: the UVP becomes
active as soon as the soft-start ends up.
The device begins soft-start phase only when VCC power supply is above UVLO threshold
and over-current threshold setting phase has been completed.
6.1
Low-side-less start up (LSLess)
In order to avoid any kind of negative undershoot and dangerous return from the load during
start-up, L6728AH performs a special sequence in enabling LS driver to switch: during the
soft-start phase, the LS driver results disabled (LS = OFF) until the HS starts to switch. This
avoid the dangerous negative spike on the output voltage that can happen if starting over a
pre-biased output.
If the output voltage is pre-biased to a voltage higher than the final one, the HS would never
start to switch. In this case, at the end of soft-start time, LS is enabled and discharge the
output to the final regulation value.
This particular feature of the device masks the LS turn-on only from the control loop point of
view: protections by-pass this turning ON the LS MOSFET in case of need.
Figure 4.
LSLess startup (left) vs. non-LSLess startup (right)
相关PDF资料 |
PDF描述 |
|---|---|
| L6730DTR | 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6730D | 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6730CQTR | 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, QCC24 |
| L6730CTR | 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6730 | 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L6728ATR | 功能描述:电压模式 PWM 控制器 HIGH FREQ SINGLE PHASE PWM CNTRL RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| L6728D | 功能描述:电流型 PWM 控制器 SNGL PHASE PWM CONTROLLER RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| L6728DTR | 功能描述:电流型 PWM 控制器 Single-Phase PWM 5V to 12V Controller RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| L6728H | 功能描述:电压模式 PWM 控制器 Sgl Output 300 KHz DFN-10 RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| L6728HTR | 功能描述:电流型 PWM 控制器 SINGLE PHASE PWM CNTRL PWR GOOD RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。